Range Of Excitation Levels Research Articles

Experimental Investigation on Nonlinear Response of a Low-Swirl Flame to Acoustic Excitation With Large Amplitude

Abstract Thermoacoustic instability is a major issue in developing high-efficiency low emission gas turbine combustors. In order to predict the amplitude of limit cycle oscillation, an understanding of the amplitude-dependent response of the flame, i.e., the nonlinear response, to large acoustic excitation is needed. In the present study, the nonlinear response of a low-swirl CH4/air premixed flame to acoustic excitation is experimentally studied. Amplitude dependences of flame dynamic at 75 Hz and 195 Hz are discussed in detail over a wide range of excitation levels. Experimental results show the gain of flame describing function of the low-swirl flame has a peak value at 65 Hz and a local minimum at 105 Hz which is caused by the destructive (out of phase) and constructive (in-phase) of the axial and azimuthal velocity fluctuation. At low perturbation level, flame heat release fluctuation is in linear relationship with the normalized velocity driving level. Heat release fluctuation begins to saturate at a certain level which depends on the driving frequency. The low-swirl flame oscillates mainly in the axial direction at 75 Hz while it is in the radial direction at 195 Hz. The nonlinear flame heat release response is a result of combination effect of flame rollup process and harmonic responses.

Study on target energy transfer of 3D acoustic cavity - plate coupling system with the membrane nonlinear energy sink

The target energy transfer (TET) between a membrane nonlinear energy sink (NES) and the acoustic medium inside a rectangular cavity is studied. The acoustic medium is interacted with a plate and multi-order modes coupling of the 2 structure is considered. Based on the modal expansion approach, with Green's function, Helmholtz equation and the boundary conditions of the acoustic medium and the plate, the coupling coefficient matrix of the mode of 2 structures is derived. The equations of the membrane NES, multi-order modes of the acoustic medium and multi-order modes of the plate are established, and numerical analysis is used to investigate the TET phenomenon. The results show that in condition of a single-point excitation to the plate, under a certain range of excitation levels, the membrane can be seen as a kind of NES, and the energy in the acoustic medium can be unidirectionally transmitted to the membrane NES and attenuated, reducing the sound pressure level in the cavity. At the same time, it is found that the NES can suppress multi-order sound pressure of the acoustic medium at the same time, and realize the control of cascaded resonance noise.

Luminescence and Stimulated Emission of Polycrystalline Cu(In,Ga)Se2 Films Deposited by Magnetron-Assisted Sputtering

The stimulated emission of Cu(In,Ga)Se2 alloy thin films formed by magnetron-assisted sputtering onto a sodium-fluoride layer deposited onto a molybdenum layer on a glass substrate is observed. The structural and optical parameters of the films are determined by scanning electron microscopy, local X-ray spectral microanalysis, X-ray structural analysis, and low-temperature luminescence (T = 10 K) measurements in the range of excitation levels of 1.6–75 kW cm–2 provided by nanosecond nitrogen-laser pulses. The stimulated emission threshold corresponds to ~25 kW cm–2. Comparative analysis of the emission of Cu(In,Ga)Se2 thin films suggests that the introduction of sodium results in significant improvement of the structural quality, specifically, in a decrease in the density of energy states in the band tails and in a decrease in the concentration of nonradiative-recombination centers.

Identification of Near-infrared [Se iii] and [Kr vi] Emission Lines in Planetary Nebulae∗

Abstract We identify [Se iii] 1.0994 μm in the planetary nebula (PN) NGC 5315 and [Kr vi] 1.2330 μm in three PNe from spectra obtained with the Folded-Port InfraRed Echellette (FIRE) spectrometer on the 6.5 m Baade Telescope. Se and Kr are the two most widely detected neutron-capture elements in astrophysical nebulae, and can be enriched by s-process nucleosynthesis in PN progenitor stars. The detection of [Se iii] 1.0994 μm is particularly valuable when paired with observations of [Se iv] 2.2864 μm, as it can be used to improve the accuracy of nebular Se abundance determinations, and allows Se ionization correction factor (ICF) schemes to be empirically tested for the first time. We present new effective collision strength calculations for Se2+ and Kr5+, which we use to compute ionic abundances. In NGC 5315, we find that the Se abundance computed from Se3+/H+ is lower than that determined with ICFs that incorporate Se2+/H+. We compute new Kr ICFs that take Kr5+/H+ into account, by fitting correlations found in grids of Cloudy models between Kr ionic fractions and those of more abundant elements, and use these to derive Kr abundances in four PNe. Observations of [Se iii] and [Kr vi] in a larger sample of PNe, with a range of excitation levels, are needed to rigorously test the ICF prescriptions for Se and our new Kr ICFs.

Crack characterisation by detection and classification of nonlinear behaviour using the Hilbert transform

The presence of a crack in a structure causes a local variation in the stiffness that alters the dynamics of the entire system. This article introduces an approach for crack characterisation by detection and classification of the nonlinearities arising from a crack operating in flexural and torsion modes of vibration. Nonlinearity detection is accomplished by obtaining amplitude dependent frequency response functions, whereas classification is achieved by processing those frequency response functions through the Hilbert transform. For the purpose of illustrating this process, a dog-bone-type specimen is tested. Fatigue cracks of various depths are generated and propagated in the specimen by vibration at resonance. For varying crack depths, a range of excitation levels are used to obtain amplitude dependent frequency response functions from which resonance frequencies and damping levels are extracted. While utilising the Hilbert transform for nonlinearity classification, Haoui correction terms are incorporated for accommodating the issues associated with truncated data, either baseband or zoomed. Corrections terms for residual modes outside the frequency range of interest are neglected.

Modeling subharmonic response from contrast microbubbles as a function of ambient static pressure.

Variation of subharmonic response from contrast microbubbles with ambient pressure is numerically investigated for non-invasive monitoring of organ-level blood pressure. Previously, several contrast microbubbles both in vitro and in vivo registered approximately linear (5-15 dB) subharmonic response reduction with 188 mm Hg change in ambient pressure. In contrast, simulated subharmonic response from a single microbubble is seen here to either increase or decrease with ambient pressure. This is shown using the code BUBBLESIM for encapsulated microbubbles, and then the underlying dynamics is investigated using a free bubble model. The ratio of the excitation frequency to the natural frequency of the bubble is the determining parameter--increasing ambient pressure increases natural frequency thereby changing this ratio. For frequency ratio below a lower critical value, increasing ambient pressure monotonically decreases subharmonic response. Above an upper critical value of the same ratio, increasing ambient pressure increases subharmonic response; in between, the subharmonic variation is non-monotonic. The precise values of frequency ratio for these three different trends depend on bubble radius and excitation amplitude. The modeled increase or decrease of subharmonic with ambient pressure, when one happens, is approximately linear only for certain range of excitation levels. Possible reasons for discrepancies between model and previous experiments are discussed.

Impacts of Transformer Core Hysteresis Formation on Stability Domain of Ferroresonance Modes

This paper investigates impacts of various formations of hysteresis on the stability domain of ferroresonance modes of a voltage transformer (VT). Based on four different hysteretic and two single-valued polynomial models, ferroresonance behaviors of the VT are studied. The hysteretic models are developed based on the Preisach theory. The first hysteretic model accurately duplicates the measured hysteresis loops of the VT in a wide variation range of the core excitation level. The other three hysteretic models represent different hysteresis loop formations. The polynomial models are based on identical single-valued polynomial magnetization characteristics but represent different core loss resistances (i.e., constant and dynamically varying core loss resistances, respectively). All of the models represent the same core losses as the measured value to investigate impacts of hysteresis loop formations on ferroresonance modes, independent of the corresponding hysteresis losses. The studies are conducted in time domain in the PSCAD/EMTDC software environment. The studies indicate that the VT model, which duplicates the measured hysteresis loops and the measured core loss over a wide range of excitation levels, results in more ferroresonance modes, expanded stability domains, and higher overvoltages. This paper concludes that formation of hysteresis is an independent factor which significantly impacts the ferroresonance phenomenon. Not only is it a single-valued magnetization characteristic but also a generic hysteretic characteristic; if it is not accurately constructed based on the measured core hysteresis data, it can result in significant error in determining the ferroresonance overvoltages and stability domains of the ferroresonance modes.

Quantification of reflex activity in stroke survivors during an imposed multi-joint leg extension movement

The goal of this study was to compare short- and long-latency reflex responses in eight major lower-extremity muscle groups following an imposed multi-joint leg movement between a group of 14 chronic (>1 year) stroke survivors and 10 healthy age-matched controls, and to investigate the influence of joint velocities and muscle excitation levels on these reflex responses in each respective group. Subjects were seated with their foot anchored to a sliding footplate that could extend their leg. Prior to the leg being moved, subjects were instructed to pre-activate hip and knee flexors and extensors. Feedback of joint torque was used to help subjects activate muscles over a range of excitation levels. Following pre-activation, the subject's leg was passively extended so the knee or hip joint rotated at one of three different speeds (30, 60, and 120 degrees /s). In general, it was found that the magnitude of stroke survivors' reflex response was greater compared to controls' in certain biarticular muscles, notably the gastrocnemius and medial hamstring, and the uniarticular adductor longus, and that the long-latency reflex component (between 40 and 150 ms post-movement) accounted for most of the observed differences. Furthermore, while reflex response amplitudes increased in both groups with increasing movement speed, the rate of increase was significantly larger in stroke subjects than in controls. Clinically, these findings may help explain why stroke survivors walk slowly since it is under these conditions that reflex responses better emulate those of their able-bodied counterparts.

Multiple Internal Resonance in Suspended Cables under Random In-Plane Loading

The random excitation of a suspended cable with simultaneous internal resonances is considered. The internal resonances can take place among the first in-plane and the first two out-of-plane modes. The external loading is represented by a wide-band random process. The response statistics are estimated using the Fokker-Planck-Kolmogorov (FPK) equation, together with Gaussian and non-Gaussian closures. Monte Carlo simulation is also used for numerical verification. The unimodal in-plane motion exists in regions away from the internal resonance condition. The mixed mode interaction is manifested within a limited range of internal detuning parameters, depending on the excitation power spectrum density and damping ratios. The Gaussian closure scheme failed to predict bounded solutions of mixed mode interaction. The non-Gaussian closure results are in good agreement with the Monte Carlo simulation. The on-off intermittency of the autoparametrically excited modes is observed in the Monte Carlo simulation over a small range of excitation levels. The influence of the cable parameters, such as damping ratios, sag-to-span ratio, internal detuning parameters, and excitation level on the autoparametric interaction, is studied. It is found that the internal detuning and excitation level are the two main parameters which affect the autoparametric interaction among the three modes. Due to the system's nonlinearity, the response of the three modes is strongly non-Gaussian and the coupled modes experience irregular modulation.

Investigation of a high intensity sound beam from a plane transducer. Experimental and theoretical results

Results of a systematic investigation of a high intensity sound beam from a plane circular transducer are presented for a large range of excitation levels. The ratio of the shock formation distance to the Rayleigh distance ranges from 1.7 to 0.06. A detailed description of the experimental setup is given. Problems encountered when calibrating highly intense and highly directive sound sources are discussed, and a novel method of calibration is proposed. Experimental results for the case of cw excitation are presented and compared with a simulation using the Bergen Code, thus allowing to assert the usefulness of the model (Khokhlov–Zabolotskaya–Kuznetsov equation) and of the numerical algorithm (spectral decomposition and finite difference method of the transformed beam equation) for high intensity sound beams. A new effect, nonlinear defocusing of the beam, is uncovered.

Turbulence suppression in an elliptic jet

Some instability characteristics in elliptic jets are presented. Turbulence suppression has been observed in an elliptic jet (aspect ratio, 2:1) under controlled excitation for Strouhal number St θ between approximately 0.005 and 0.024. Results over a range of excitation level from 0.25–9 percent for St θ = 0.012 and 0.017 show that low excitation level is as effective as high excitation level in suppressing turbulence.

Saturation and Gain Characteristics of Pulse Transformers Using Various Core Materials

This paper describes a study made on pulse transformers using ferrite and grain oriented steel cores. Characteristics studied are the saturation characteristics at -60 deg. C, +25 deg. C, and +130 deg. C, under a wide range of excitation levels. A set of curves suitable for predicting circuit performance under specified circuit and temperature conditions as well as examples of the use of these curves concludes the paper.