AlSi10Mg alloy products with a hydrogen content of approximately 3.9 or 5.6 cm3/100 g-Al of hydrogen were fabricated by selective laser melting (SLM) using normal (as-received) and moist powders, and their non-reversible dimensional changes during heat treatment at 473 or 803 K were investigated. The linear dimensional change arising from the heat treatment at 473 K was approximately 0.22% by 3.6 ks and remained constant thereafter. This behavior was independent of the amount of hydrogen in the SLM products, suggesting that the dimensional changes at 473 K were induced by precipitation of Si phase from the α-Al phase. However, the linear dimensional changes during the heat treatment at 803 K were comparatively large and continued to increase during the heat treatment. At the same time, the linear dimensional changes at 803 K also showed a dependence on the amount of hydrogen in the SLM products. These phenomena indicated that the porosity expansion and precipitation of Si phase occurred simultaneously at 803 K. For the SLM product with a hydrogen content of approximately 3.9 cm3/100 g-Al, the linear dimensional change during the heat treatment at 803 K was 0.867% at 18 ks, of which 0.116% and 0.751% were estimated to have been induced by the precipitation of Si phase and the porosity expansion, respectively. From gas analyses using different methods, it was elucidated that the hydrogen desorbed from the powder and was entrapped in the SLM products at the time of laser scanning, and then enriched to the porosities during the heat treatment at 803 K, causing the porosity expansion.
Read full abstract