The quality of potato chips is highly dependent on the mechanical properties of the dough sheet produced prior to frying. It has been well established that poor mechanical properties result in fragile dough sheets and associated high product wastage. However, the effect of the rolling process on the mechanical properties of the dough is unknown so the optimum rolling process can only be obtained via a trial and error approach. This work reports for the first time the effects of dry flake size and rolling parameters on the mechanical performance of potato dough sheets. The laboratory scale rolling setup used a 10 cm roller diameter with a 0.2 mm gap height. Furthermore, an experimental method was developed enabling rigorous tensile testing of fragile potato dough sheets. The mechanical performance of the potato dough sheets was anisotropic, as the Young's modulus and strength were 35% and 57% higher across the rolling direction than those along the rolling direction, respectively. The formability, i.e. the ability to form a coherent sheet of the potato dough is improved by using smaller dry flakes (<500 μm). However, further decrease in the flakes size had no effect on the mechanical behaviour of potato dough sheets, i.e. flakes with diameter smaller than 212 μm showed similar tensile response to flakes smaller than 500 μm. Rolling the dough increases the coherence and the strength of the potato dough sheets, but also introduces defects orientated across the rolling direction which decrease the strength if the dough is rolled too many times. For example, sheets rolled for seven passes showed over 100% improvement in failure stress comparing to sheets rolled for five passes, but when the sheets were rolled for the eighth pass, the failure stress dropped by 17%. Due to the viscoelasticity of the dough, both the tensile modulus and strength of the sheets are higher when tested at higher strain rate. In addition, at higher strain rate, the defects in the sheets did not have enough time to grow, as evidenced by a lower scatter in failure stress. A method to obtain an optimum production condition has been identified, which will lead to fewer production interruptions due to dough breakage, and reduced waste. • Investigation on the effect of rolling process on the mechanical behaviour of thin potato dough sheets. • First research on the dry potato flake size-potato dough sheet property relationship. • Design of a novel test gear to perform tensile tests on potato dough sheets and other fragile materials. • Study on the mechanical behaviour of potato dough sheets after rolling process with high compression rate. • Microstructure observation to identify how the change in potato dough microstructure affects the mechanical performance.