Photoacoustic Microscopy Technique Research Articles

Photoacoustic computed microscopy.

Photoacoustic microscopy (PAM) is emerging as a powerful technique for imaging microvasculature at depths beyond the ~1 mm depth limit associated with confocal microscopy, two-photon microscopy and optical coherence tomography. PAM, however, is currently qualitative in nature and cannot quantitatively measure important functional parameters including oxyhemoglobin (HbO2), deoxyhemoglobin (HbR), oxygen saturation (sO2), blood flow (BF) and rate of oxygen metabolism (MRO2). Here we describe a new photoacoustic microscopic method, termed photoacoustic computed microscopy (PACM) that combines current PAM technique with a model-based inverse reconstruction algorithm. We evaluate the PACM approach using tissue-mimicking phantoms and demonstrate its in vivo imaging ability of quantifying HbO2, HbR, sO2, cerebral BF and cerebral MRO2 at the small vessel level in a rodent model. This new technique provides a unique tool for neuroscience research and for visualizing microvasculature dynamics involved in tumor angiogenesis and in inflammatory joint diseases.

Photoacoustic microscopy: a potential new tool for evaluation of angiogenesis inhibitor

The feasibility of photoacoustic microscopy (PAM) for evaluation of angiogenesis inhibitor was investigated on a chick embryo model in vivo. Different concentrations of the angiogenesis inhibitor, Sunitinib, were applied to the chorioallantoic membrane (CAM) of the chick embryos. Imaging of microvasculature in embryo CAMs was acquired using a laser-scanning PAM system; while the optical microscopy (OM) capturing the microvascular images of the same set of CAMs for comparison served as a gold standard for validating the results from PAM. The microvascular density as a function of applied Sunitinib concentration has been quantified in both PAM and OM images. The results from these two modalities have a good agreement, suggesting that PAM could provide an unbiased quantification of microvascular density for objective evaluation of anti-angiogenesis medication. In comparison with conventional OM which enables only two-dimensional enface imaging, PAM is capable of three-dimensional analysis of microvessels, including not only morphology but also functions, as demonstrated in part by the imaging result on a canine bladder model. The emerging PAM technique shows promise to be used in clinical and preclinical settings for comprehensive and objective evaluation of anti-angiogenesis medications.

Volumetric imaging of erythrocytes using label‐free multiphoton photoacoustic microscopy

Photoacoustic microscopy (PAM) is an imaging modality well suited to mapping vasculature and other strong absorbers in tissue. However, one of the primary drawbacks to PAM when used for high-resolution imaging is the relatively poor axial resolution due to the inverse dependence on the transducer bandwidth. While submicron lateral resolution PAM can be achieved by tightly focusing the excitation light, the axial resolution is fundamentally limited to 10s of microns for typical transducer frequencies. Here we present a multiphoton PAM technique called transient absorption ultrasonic microscopy (TAUM), which results in a completely optically resolved voxel with an experimentally measured axial resolution of 1.5 microns. This technique is demonstrated by imaging individual red blood cells in three dimensions in blood smear and ex vivo tissues. To the best of our knowledge, this is the first demonstration of fully resolved, volumetric photoacoustic imaging of erythrocytes.

Thermal Image of Coffee-Seed Germ Obtained by Photoacoustic Microscopy

Photoacoustic microscopy (PAM) has been shown to be a suitable technique to obtain thermal images of a wide variety of samples from semiconductors to biological material. In PAM, the incidence of a modulated laser beam on a sample within a photoacoustic (PA) cell, hermetically sealed, produces a PA signal which depends on the thermal and optical properties of the studied sample. By making a sweep of the modulated laser beam on the sample surface, it is possible to obtain the PA signal as a function of their x−y coordinates, and from this signal, it is possible to reconstruct thermal images of the sample. In this study, thermal images of a coffee-seed germ were obtained, with a difference of 12 h between them, by using the PAM technique. Thermal differences observed between images give information which reflects degradation due to the fact that germ cells undergo changes as a function of time. The thermal images obtained by the PAM technique could be applied to biological materials that have a complex constitution (not homogeneous) in their structures, and thermal differences can be observed. PAM is a non-destructive technique, which is an important feature for this type of study. Other applications of this technique can be performed in the agricultural and biotechnological areas.

Functional photoacoustic imaging to observe regional brain activation induced by cocaine hydrochloride

Photoacoustic microscopy (PAM) was used to detect small animal brain activation in response to drug abuse. Cocaine hydrochloride in saline solution was injected into the blood stream of Sprague Dawley rats through tail veins. The rat brain functional change in response to the injection of drug was then monitored by the PAM technique. Images in the coronal view of the rat brain at the locations of 1.2 and 3.4 mm posterior to bregma were obtained. The resulted photoacoustic (PA) images showed the regional changes in the blood volume. Additionally, the regional changes in blood oxygenation were also presented. The results demonstrated that PA imaging is capable of monitoring regional hemodynamic changes induced by drug abuse.