Number Of Electron-positron Pairs Research Articles

Pixelated Readout Circuit for Pair-Monitor at International Linear Collider

The pair monitor measures the beam profile at the interaction point of the international linear collider. It extracts the information from the directional distribution of a large number of electron-positron pairs created by collision of bunches. The pairs are detected by pixel detectors placed close to the beam on both sides of the interaction point, and a readout ASIC that meets the stringent requirements has been developed. In order to measure the beam profile as a function of location within a train, and also to deal with the high hit rate, the pixel detector is read out in 16 time slices per bunch train. In this paper, we describe the design of the readout circuit and present the result of performance tests.

Strange stars and their cooling with positron electrical neutralization of quark matter

Questions of the equilibrium, stability, and observational manifestations of strange stars are considered, in which electrical neutralization of the quark matter is provided by positrons, as occurs for some sets of bag parameters resulting in a stiffer equation of state. Such models consist entirely of self-contained, strange quark matter and their maximum mass reaches 2.4–2.5 M⊙ with a radius of 13–14 km. The cooling of such strange quark stars both in the absence and in the presence of mass accretion is investigated. It is shown that in the absence of mass accretion onto the strange star, the dependence of temperature (T, K) on age (t, yr) depends very little on the mass of the configuration and has the form T ≈ 2.3·108r−1/5. If the star’s initial temperature is sufficiently high (T0≥2·1010K), then the total number of electron-positron pairs emitted does not depend on it and is determined only by the total mass of the configuration. In the case of accretion, the annihilation of electrons of the infalling fatter with positrons of the strange quark matter results in the emission of γ-rays with an energy of∼0.5 MeV, by observing which one can distinguish candidates for strange stars. The maximum temperature of strange stars with mass accretion is calculated.

The role of electron–positron pairs in parsec-scale radio jets

We investigate the hypothesis that the parsec-scale jets observed in extragalactic objects consist of an electron-positron pair plasma outflowing from the compact, X-ray emitting region of the source. Due to annihilation in the innermost regions, there is an upper limit on the number of electron-positron pairs that can reach the parsec-scale jet. On the other hand, there is a lower limit on the density of particles in the jet: their density must be at least equal to that needed to emit the synchrotron radiation we observe. We derive the latter limit by assuming a power-law electron distribution, with a low-energy cut-off. By comparing these two limits, we find that the constituents of parsec-scale jets may be electron-positron pairs produced in the innermost regions only if their minimum energy is greater than approximately 50 MeV. Remarkably, the same limit on the minimum particle energy is found in the case of jets consisting of electrons and protons in order that Faraday depolarization is avoided.

The gamma-ray spectra of radio pulsars

A general expression for the gamma-ray spectra of pulsars is derived for models where the radiation is produced by particles accelerated along the open field lines of a neutron star. The accelerating potentials are assumed to be limited by pair production discharges and to decrease linearly with increasing number of electron-positron pairs created during these discharge processes. The corresponding energy distribution of particles is derived both for the case of strong radiation reaction and for that of no radiation reaction. The resultant formula for the gamma-ray spectrum fits well to the Crab and the Vela pulsar spectra assuming that radiation reaction is negligible in these two fast pulsars.