Nonlinear Fluorescence Response Research Articles

BGO quenching effect on spectral measurements of cosmic-ray nuclei in DAMPE experiment

The Dark Matter Particle Explorer (DAMPE) is a satellite-borne detector designed to measure high energy cosmic-rays and γ-rays. As a key sub-detector of DAMPE, the Bismuth Germanium Oxide (BGO) imaging calorimeter is utilized to measure the particle energy with a high resolution. The nonlinear fluorescence response of BGO for large ionization energy deposition, known as the quenching effect, results in an under-estimate of the energy measurement for cosmic-ray nuclei. In this paper, various models are employed to characterize the BGO quenching factors obtained from the experimental data of DAMPE. Applying the proper quenching model in the detector simulation process, we investigate the tuned energy responses for various nuclei and compare the results based on two different simulation softwares, i.e. GEANT4 and FLUKA. The BGO quenching effect results in a decrease of the measured energy by approximately 2.5% (5.7%) for carbon (iron) at ∼10 GeV/n and <1% above 1 TeV/n, respectively. Accordingly, the correction of the BGO quenching effect leads to an increase of the low-energy flux measurement of cosmic-ray nuclei.

Exploiting Dynamic Nonlinearity in Upconversion Nanoparticles for Super-Resolution Imaging.

Single-beam super-resolution microscopy, also known as superlinear microscopy, exploits the nonlinear response of fluorescent probes in confocal microscopy. The technique requires no complex purpose-built system, light field modulation, or beam shaping. Here, we present a strategy to enhance this technique's spatial resolution by modulating excitation intensity during image acquisition. This modulation induces dynamic optical nonlinearity in upconversion nanoparticles (UCNPs), resulting in variations of nonlinear fluorescence response in the obtained images. The higher orders of fluorescence response can be extracted with a proposed weighted finite difference imaging algorithm from raw fluorescence images to generate an image with higher resolution than superlinear microscopy images. We apply this approach to resolve single nanoparticles in a large area, improving the resolution to 132 nm. This work suggests a new scope for the development of dynamic nonlinear fluorescent probes in super-resolution nanoscopy.

Modelling Förster resonance energy transfer (FRET) using anisotropy resolved multi-dimensional emission spectroscopy (ARMES)

BackgroundFörster Resonance Energy Transfer (FRET) is widely used to study the structure and dynamics of biomolecular systems and also causes the non-linear fluorescence response observed in multi-fluorophore proteins. Accurate FRET analysis, in terms of measuring changes in donor and acceptor spectra and energy transfer efficiency is therefore critical. MethodsWe demonstrate a novel quantitative FRET analysis using anisotropy resolved multidimensional emission spectroscopy (ARMES) in a Human Serum Albumin (HSA) and 1,8-anilinonaphathalene sulfonate (ANS) model. ARMES combines 4D measurement of polarized excitation emission matrices (pEEM) with multivariate data analysis to spectrally resolve contributing fluorophores. Multivariate analysis (Parallel Factor, PARAFAC and restricted Tucker3) was used to resolve fluorophore contributions and for modelling the quenching of HSA emission and the HSA-ANS interactions. ResultspEEM spectra were modelled using Tucker3 which accommodates non-linearities introduced by FRET and a priori chemical knowledge was used to optimise the solution, thus resolving three components: HSA emission, ANS emission from indirect FRET excitation, and ANS emission from direct excitation. Perpendicular emission measurements were more sensitive to indirectly excited acceptor emission. PARAFAC modelling of HSA, donor emission, separated ANS FRET interacting (Tryptophan) and non-interacting (Tyrosine) components. This enabled a new way of calculating quenching constants using the multi-dimensional emission of individual donor fluorophores. ConclusionsFRET efficiency could be calculated using the multi-dimensional, resolved emission of the interacting donor fluorophores only which yielded higher ET efficiencies compared to conventional methods. General significanceShows the potential of multidimensional fluorescence measurements and data analysis for more accurate FRET modelling in proteins.

Toward Two-Photon Absorbing Dyes with Unusually Potentiated Nonlinear Fluorescence Response.

The combination of two two-photon-induced processes in a Förster resonance energy transfer (FRET)-operated photochromic fluorene-dithienylethene dyad lays the foundation for the observation of a quartic dependence of the fluorescence signal on the excitation light intensity. While this photophysical behavior is predicted for a four-photon absorbing dye, the herein proposed approach opens the way to use two-photon absorbing dyes, reaching the same performance. Hence, the spatial resolution limit, being a critical parameter for applications in fluorescence imaging or data storage with common two-photon absorbing dyes, is dramatically improved.

The Quenching Effect of BGO Crystals on Relativistic Heavy Ions in the DAMPE Experiment

The DArk Matter Particle Explorer (DAMPE) is a satellite-borne, calorimetric-type, high-energy-resolution detector for the precise measurement of high-energy electrons, gamma rays, and nuclei from deep space. The DAMPE electromagnetic calorimeter consists of bismuth germanate (BGO) crystals that can measure incident hadron energies from 50 GeV to 100 TeV. For an inorganic scintillator, such as BGO, the nonlinear fluorescence response when measuring ions contributes to the difference between the experimental data and Monte Carlo simulations. This article reports the BGO quenching nonlinearity occurring in the DAMPE experiment. The ionization energy response of BGO to several kinds of ions lighter than iron is investigated by conducting beam tests and analyzing flight data. We compare the scintillator output with the energy loss according to GEANT4 simulations and determine the quenching parameters. The combined result of beam test and flight experiment shows that the quenching effect strongly depends on the density of the ionization energy loss.

Nonlinear fluorescence imaging by photoinduced charge separation

Manipulation of the optical property of fluorescent probes has been a powerful strategy to establish super-resolution microscopy. We describe a new strategy to realize a probe with a nonlinear fluorescence response by using photoinduced charge separation. In this scheme, the first photon is used for the generation of the charge-separated state and the second photon is for fluorescence excitation. This stepwise two-photon absorption was confirmed by detection of a second-order nonlinear fluorescence response. Transient absorption spectra studies and simulation indicate that fluorescence is emitted through the photophysical pathways we proposed. Fluorescence imaging of biological cells showed marked improvements in image contrast and resolution, demonstrating the usefulness of the fluorescent probe in laser scanning confocal microscopy.

Saturated excitation of fluorescent proteins for subdiffraction-limited imaging of living cells in three dimensions

We report, for the first time, the saturated excitation (SAX) of fluorescent proteins for subdiffraction-limited imaging of living cells in three-dimensions. To achieve saturation, a bright yellow and green fluorescent protein (Venus and EGFP) that exhibits a strong nonlinear fluorescence response to the high excitation intensity at the laser focus is used. Harmonic demodulation of the fluorescence signal produced by a modulated excitation light extracts the nonlinear fluorescence signals. After constructing the image from the nonlinear components, we obtain fluorescence images of living cells with spatial resolution beyond the diffraction limit. We also applied linear deconvolution to SAX microscopy and found it effective in further enhancing the contrast of small intracellular structures in the SAX image, confirming the expansion of the optical transfer function in SAX microscopy.

Rare Example of TICT Based Optical Responses for the Specific Recognition of Cr3+ by a 2,2′:6′,2″-Terpyridine Derivative and Demonstration of Multiple Logic Operations

Chemosensor L showed a nonlinear fluorescence response on specific binding to Cr3+ ion in the presence of various alkali, alkaline-earth, transition, and lanthanide metal ions. A luminescence band with maxima at 512 nm for L was observed (λext = 330 nm) for a twisted intramolecular charge transfer (TICT) transition following antienergy gap law behavior. However, normal energy gap law behavior prevailed on formation of a new nonluminescent charge transfer complex, Mn+·L. For paramagnetic metal ions, paramagnetism induced luminescence quenching could have also contributed to this. A new switched on fluorescence response at λems of 356 nm (λext of 330 nm) was observed due to Franck–Condon charge transfer (FC-CT) transition only on the formation of a complex, (Cr3+)2·L. Spectral studies revealed a unique dynamic coordination behavior and migration of Cr3+ from the terpyridyl fragment to the NNMe2 center of L as a function of the varying concentration of another ion (Zn2+) and the subtle difference in the binding affinities of the terpyridyl moiety toward Cr3+ and Zn2+. Further, spectral responses of L toward Zn2+, different concentration of Cr3+, H+ and on subsequent addition of F– as different ionic inputs could be correlated well for demonstrating various basic and combinatorial circuits.

Nonlinear fluorescence response driven by ATP-induced self-assembly of guanidinium-tethered tetraphenylethene

Nonlinear fluorescence response, which is particularly important to attain the high signal-to-background ratio, was realized by the aggregation-induced fluorescence increase of guanidinium-tethered tetraphenylethene with ATP.

SAX microscopy with fluorescent nanodiamond probes for high-resolution fluorescence imaging

We report the use of fluorescent nanodiamonds (FNDs) as a photostable fluorescent probe for high resolution saturated excitation (SAX) microscopy. We confirmed that FNDs show a nonlinear fluorescence response under saturated excitation conditions generated by intense excitation light. Using FNDs, we quantified the spatial resolution improvement inherent in SAX microscopy, and experimentally demonstrated the scalability of the spatial resolution of SAX microscopy. The photostability of the FNDs allowed us to perform nanoparticle imaging of a multicolor-stained macrophage cell with a spatial resolution beyond the diffraction limit.

Intrinsically Resolution Enhancing Probes for Confocal Microscopy

In recent years different implementations of superresolution microscopy based on targeted switching (STED, GSD, and SSIM) have been demonstrated. The key elements to break the diffraction barrier are two distinct molecular states that generate a saturable nonlinear fluorescence response with respect to the excitation intensity. In this paper, we demonstrate that a nonlinearity can even be encoded in fluorescent probes, which then increase the resolution of a standard confocal microscope. This nonlinearity is achieved by an intensity dependent blocking of the resonance energy transfer between a donor and one or more acceptor fluorophores, utilizing radical anion states of the acceptor. In proof-of-principle experiments, we demonstrate a significant resolution increase using probes with different numbers of acceptor fluorophores. Quantitative description by a theoretical model paves the way for the development of fluorescent probes that can more than double the resolution of essentially any confocal microscope in all three dimensions.