Nanoelectrospray Ionization Emitters Research Articles

Effects of Nano-Electrospray Ionization Emitter Position on Unintentional In-Source Activation of Peptide and Protein Ions.

Native ion mobility-mass spectrometry (IM-MS) typically introduces protein ions into the gas phase through nano-electrospray ionization (nESI). Many nESI setups have mobile stages for tuning the ion signal and extent of co-solute and salt adduction. However, tuning the position of the emitter capillary in nESI can have unintended downstream consequences for collision-induced unfolding or collision-induced dissociation (CIU/D) experiments. Here, we show that relatively small variations in the nESI emitter position can shift the midpoint (commonly called the "CID50" or "CIU50") potential of CID breakdown curves and CIU transitions by as much as 8 V on commercial instruments. A spatial "map" of the shift in CID50 for the loss of heme from holomyoglobin onto the emitter position on a Waters Synapt G2-Si mass spectrometer shows that emitter positions closer to the instrument inlet can result in significantly greater in-source activation, whereas different effects are found on an Agilent 6545XT instrument for the ions studied. A similar effect is observed for CID of the singly protonated leucine enkephalin peptide and Shiga toxin 1 subunit B homopentamer on the Waters Synapt G2-Si instrument. In-source activation effects on a Waters Synapt G2-Si are also investigated by examining the RMSD between CIU fingerprints acquired at different emitter positions and the shifts in CIU50 for structural transitions of bovine serum albumin and NIST monoclonal antibody.

Tips on Making Tiny Tips: Secrets to Submicron Nanoelectrospray Emitters.

Nanoelectrospray ionization emitters with submicron tip diameters have significant advantages for use in native mass spectrometry, including the ability to produce resolved charge-state distributions for proteins and macromolecular complexes from standard biochemical buffers that contain high concentrations of nonvolatile salts and to prevent nonspecific aggregation that can occur during droplet evaporation. We report on various factors affecting the tip morphology and provide suggestions for producing and using emitters with submicron tips. Effects of pulling parameters for a Sutter Instrument P-87 tip puller on the resulting tip diameter and morphology are shown. The "Pull" parameter has the largest effect on tip diameter, followed by "Velocity", "Pressure", and "Heat", whereas the "Time" parameter has minimal effect beyond a lower threshold. High "Pull" values generate emitters with multiple tapers, whereas high "Velocity" values generate a tip with only a single tapered region. A protocol for producing reproducible emitters in the submicron size range, as well as guidelines and tips for using these emitters with standard biochemical buffers that contain high concentrations of nonvolatile salts, is presented with the aim of expanding their use within the native mass spectrometry community.

Droplet-assisted electrospray phase separation using an integrated silicon microfluidic platform.

We report a silicon microfluidic platform that enables monolithic integration of transparent micron-scale microfluidic channels, an on-chip segmentation of analyte flows into picoliter-volume droplets, and a nano-electrospray ionization emitter that enables spatial and temporal separation of oil and aqueous phases during electro-spray for subsequent mass spectrometry analysis.

Single-Cell Native Mass Spectrometry of Human Erythrocytes.

Native mass spectrometry (MS) enables the determination of the molecular mass of protein complexes. Generally, samples for native MS are isolated, purified, and prepared in volatile solutions. However, to understand the function of proteins in living cells, it is essential to characterize the protein complex as is, without isolation/purification of the protein, using the smallest possible amount of the sample. In the present study, we modified the "live single-cell MS" method, which has mainly been used in metabolomics, and applied it to observe hemoglobin directly sampled from human erythrocytes. By optimizing the experimental methods and conditions, we obtained native mass spectra of hemoglobin using only a single erythrocyte, which was directly sampled into a nanoelectrospray ionization emitter using a micromanipulator and microinjector system. That is, our method enables the analysis of ∼0.45 fmol of hemoglobin directly sampled from an erythrocyte. To our knowledge, this is the first report of native MS for endogenous proteins using a single intact human cell.

A hybrid fluorous monolithic capillary column with integrated nanoelectrospray ionization emitter for determination of perfluoroalkyl acids by nano-liquid chromatography–nanoelectrospray ionization-mass spectrometry/mass spectrometry

A hybrid fluorous monolithic column was simply prepared via photo-initiated free radical polymerization of an acrylopropyl polyhedral oligomeric silsesquioxane (acryl-POSS) and a perfluorous monomer (2,2,3,3,4,4,5,5,6,6,7,7-dodecafluoroheptyl acrylate) in UV-transparent fused-silica capillaries within 5min. The physical characterization of hybrid fluorous monolith, including scanning electron microscopy (SEM), Fourier transform infrared (FT-IR) spectroscopy, mercury intrusion porosimetry (MIP) and nitrogen adsorption/desorption measurement was performed. Chromatographic performance was also evaluated by capillary liquid chromatography (cLC). Due to the fluorous–fluorous interaction between fluorous monolith and analytes, fluorobenzenes could well be separated, and the column efficiencies reached 86,600–92,500plates/m at the velocity of 0.87mm/s for alkylbenzenes and 51,900–76,000plates/m at the velocity of 1.10mm/s for fluorobenzenes. Meanwhile, an approach to integrate nanoelectrospray ionization (ESI) emitter with hybrid fluorous monolithic column was developed for quantitative determination of perfluoroalkyl acids by nanoHPLC–ESI-MS/MS. The integration design could minimize extracolumn volume, thus excluding undesirable peak broadening and improving separation performance.

Electroosmotically driven solution mixing in borosilicate theta glass nESI emitters.

The use of borosilicate theta glass capillaries as nanoelectrospray ionization emitters has recently been demonstrated as a method for mixing two solutions as they are sprayed into the mass spectrometer for analysis. All previous experiments resulted in a solution mixing timescale limited to the time the analytes spend in the Taylor cone and subsequent droplets (i.e. sub-millisecond timescale). In an effort to extend the solution mixing timescale to the milliseconds regime, we demonstrate that solution can be moved from one channel of the theta tip to the opposite channel via electroosmosis by applying a potential difference between the two wire electrodes inserted into each channel of the theta tip. First, we establish that electroosmosis is responsible for solution movement using fluorescence microscopy to track fluorescent tracer dyes. We then demonstrate the utility of this technique in varying the extent of denaturation of holomyoglobin to apomyoglobin on the millisecond timescale just prior to analysis by mass spectrometry. Finally, we induce additional turbulence for better mixing by applying a square wave potential to one of the wire electrodes while holding the opposite wire at a constant voltage between the low and high potentials of the square wave. This experiment was found to provide nearly complete mixing after a single cycle of the square wave. The use of electroosmosis significantly expands the flexibility of theta tips for altering solutions prior to nESI without the need for off-line sample manipulation. Copyright © 2015 John Wiley & Sons, Ltd.

Affecting Protein Charge State Distributions in Nano-Electrospray Ionization via In-Spray Solution Mixing Using Theta Capillaries

Borosilicate theta glass capillaries pulled to serve as nanoelectrospray ionization emitters are used for short time-scale mixing of protein and acid solutions during the electrospray process to alter protein charge state distributions (CSDs) without modifying the sample solution. The extent of protein CSD shifting/denaturing can be tailored by acid identity and concentration. The observed CSD(s) are protein dependent, and the short mixing time-scale enables the study of short-lived unfolding intermediates and higher charge states of noncovalent protein complexes, including those of holomyoglobin. Additionally, the theta tips provide a simple and inexpensive method for mixing nonvolatile reagents such as supercharging agents, which cannot be used with previously developed vapor leak-in techniques, with protein solutions during the electrospray process.

Chemical Vapor Deposition of Aminopropyl Silanes in Microfluidic Channels for Highly Efficient Microchip Capillary Electrophoresis-Electrospray Ionization-Mass Spectrometry

We describe a chemical vapor deposition (CVD) method for the surface modification of glass microfluidic devices designed to perform electrophoretic separations of cationic species. The microfluidic channel surfaces were modified using aminopropyl silane reagents. Coating homogeneity was inferred by precise measurement of the separation efficiency and electroosmotic mobility for multiple microfluidic devices. Devices coated with (3-aminopropyl)di-isopropylethoxysilane (APDIPES) yielded near diffusion-limited separations and exhibited little change in electroosmotic mobility between pH 2.8 and pH 7.5. We further evaluated the temporal stability of both APDIPES and (3-aminopropyl)triethoxysilane (APTES) coatings when stored for a total of 1 week under vacuum at 4 °C or filled with pH 2.8 background electrolyte at room temperature. Measurements of electroosmotic flow (EOF) and separation efficiency during this time confirmed that both coatings were stable under both conditions. Microfluidic devices with a 23 cm long, serpentine electrophoretic separation channel and integrated nanoelectrospray ionization emitter were CVD coated with APDIPES and used for capillary electrophoresis (CE)-electrospray ionization (ESI)-mass spectrometry (MS) of peptides and proteins. Peptide separations were fast and highly efficient, yielding theoretical plate counts over 600,000 and a peak capacity of 64 in less than 90 s. Intact protein separations using these devices yielded Gaussian peak profiles with separation efficiencies between 100,000 and 400,000 theoretical plates.

Multiplexed Extraction and Quantitative Analysis of Pharmaceuticals from DBS Samples Using Digital Microfluidics

Dried blood spot (DBS) sampling is emerging as a valuable technique in a variety of fields, including clinical and preclinical testing of pharmaceuticals. Despite this popularity, current DBS sampling and analysis processes remain laborious and time consuming. Digital microfluidics, a microscale liquid-handling technique, characterized by the manipulation of discrete droplets on open electrode arrays, offers a potential solution to these problems. We report a new digital microfluidic method for multiplexed extraction and analysis of pharmaceuticals in DBS samples. In the new method, four DBS samples are extracted in microliter-sized droplets containing internal standard, and the extract is delivered to dedicated nanoelectrospray ionization emitters for direct analysis by tandem mass spectometry and selected reaction monitoring. The new method allows for an order of magnitude reduction in processing time and approximately three-times reduction in extraction solvent relative to conventional techniques, while maintaining acceptable analytical performance for most drugs tested.

Adjacent Pulsed Nanoelectrospray Ionization Emitters for the Alternating Generation of Ions of Opposite Polarity

An approach that allows for adjacent closely spaced nanoelectrospray ionization (nESI) emitters to be pulsed alternately to generate ions of opposite polarity for transmission through a common interface is described. The potential difference between two or more nESI emitters in close proximity is minimized by applying the same polarity to both emitters at any given point in time but with the magnitude of only the active emitter's potential being sufficiently high to sustain a stable spray. The reduced difference in potential between emitters allows the distance between emitters to be decreased to within a few millimeters so that compromises imposed by the use of multiple emitters for the generation of ions from distinct solutions using a common atmosphere interface are minimized.

Silanization of inner surfaces of nanoelectrospray ionization emitters for reduced analyte adsorption

During the course of nanoelectrospray ionization (nanoESI) of substance P, an unusual type of signal reduction was observed with flow rates <10 nL/min. This reduction in signal appears to be induced by the adsorption of positively charged analytes onto negatively charged free silanol groups on the inner surface of emitters; analytes with higher pI values (such as substance P) exhibit greater tendency for adsorption. Support for this hypothesis is demonstrated by the decrease in signal reduction in the presence of concentrated salts or for emitters whose internal silanols have been covalently silanized. Emitters treated with hexamethyldisilazane or 3-aminopropyltriethoxysilane showed higher analyte signals for substance P than untreated emitters, suggesting a reduction of analyte adsorption onto the inner walls of silanized emitters. The efficacy of reduced peptide adsorption was demonstrated for emitters silanized with 3-aminopropyltriethoxysilane using a simple peptide mixture as well as a more complex peptide mixture (a tryptic digest of horse hemoglobin).

Octadecylated Silica Monolith Capillary Column with Integrated Nanoelectrospray Ionization Emitter for Highly Efficient Proteome Analysis

An improved strategy for the preparation of octadecylated silica monolith capillary column with high homogeneity was proposed. Column performance was evaluated by nanoscale HPLC. The design for constructing an integrated nanoelectrospray emitter on the octadecylated silica monolith capillary column was first introduced. In comparison with the separated configuration where the emitter is connected to monolithic capillary column by the aid of a zero dead volume union, the integrated capillary column has the inherent advantage of the minimized extracolumn volume thus providing improved separation quality. The performance of the integrated monolithic capillary column was evaluated by separation of BSA tryptic digest, and peak capacity of 313 with a 30-cm column was obtained. The high separation performance allowed highly confident identification of 662 distinct proteins through assignment of 1933 unique peptides by analysis of tryptic digest of 0.5 mug of Saccharomyces cerevisiae proteins. The higher separation efficiency by a 60-cm monolithic capillary column increased the proteome coverage with identification of 1323 proteins through assignment of 5501 unique peptides over 400-min gradient elution.

Two-dimensional microfabricated sources for nanoelectrospray.

The idea of a novel two-dimensional (2D) nanoelectrospray ionization emitter tip with the shape of a nib is explored here. This novel planar design is studied as an alternative to the needle-like standard emitter tips that suffer from a lack of reproducibility and robustness and from an inherent incompatibility with high-throughput analysis. The composition of the micro-nib sources is analogous to the working of a simple fountain pen, with a liquid reservoir linked to a micro-nib tip from which the sample is electrosprayed via a capillary slot. The micro-nib prototypes described here were fabricated using microtechnology techniques and using the epoxy-based negative photoresist SU-8. The resulting free-standing micro-nib structure was supported by a silicon wafer. We present here two series of such micro-nib sources, the latter series exhibiting improved characteristics such as a 8 micro m source width of the nib tip. They were tested in mass spectrometry experiments on an ion trap mass spectrometer (LCQ Deca XP+, Thermo Finnigan) using standard peptide samples having concentrations down to 1 micro M and with a high voltage (HV) supply around 1 kV for the second series of micro-nib sources. In addition to the stability of the spray, the obtained mass spectra showed the reliability of these sources for peptide analysis; the signal of the spectra was as intense and the signal-to-noise ratio (S/N) as high as that obtained with the use of standard emitter tips.