The study of the structural and mechanical properties of tubing steels used in wells at oil and gas condensate fields is of particular interest due to the resource intensity of these systems and the high cost of their repair and restoration. Tubing is operated under conditions of increased loads under the influence of its own weight, internal pressure and constant contact with highly aggressive media. As a result of simultaneous exposure to corrosive media and operational loads, tubing is the most consumable downhole material. The destruction and, as a result, the breakage of the tubing suspension occurs as a result of mechanical abrasion and cracking of the pipe body, the development of fatigue cracks in the thread, etc. Contact with aggressive agents of the extracted fluid and reservoir waters leads to various types of corrosion damage: ulcerative, pitting, corrosion fatigue, corrosion cracking, meza corrosion, biocorrosion, etc. Corrosion foci are localized on the inner and outer surfaces of pipes. The problem is complicated by the increased content of carbon dioxide (CO2), hydrogen sulfide (H2S), as well as the presence of various bacteria in oil and gas fields.This article is devoted to the study of the mechanical characteristics and microstructure of tubing steels that were in operation under conditions of complicating factors and highly aggressive corrosive environment. Tubing pipes Ø73x5.5 of strength group E. were tested. The following research methods were carried out: visual inspection; determination of the chemical composition of steel; determination of hardness; uniaxial tensile test; optical microscopy.As a result of the tests, quantitative characteristics of the mechanical properties of the steels were obtained. A significant decrease in the hardness, tensile strength and yield strength of steel has been established under prolonged exposure to complicated operating conditions. Metallographic studies have established the contamination of steels with silicates of various shapes, amounting to 3 and 2 points according to GOST 1778. Microstructural studies have been carried out. The fine-grained ferrite-carbide structure of steels has been revealed. This structure corresponds to the heat treatment mode: quenching followed by tempering.