Magnet Synchronous Wind Power Generation Research Articles

Enhanced MPPT in Permanent Magnet Direct-Drive Wind Power Systems via Improved Sliding Mode Control

Addressing the challenges of significant speed overshoot, stability issues, and system oscillations associated with the sliding mode control (SMC) strategy in maximum power point tracking (MPPT) for permanent magnet synchronous wind power systems, this paper introduces a fuzzy sliding mode control (FSMC) method employing an innovative exponential convergence law. By incorporating a velocity adjustment function into the traditional exponential convergence law, a novel convergence law was designed to mitigate oscillations during the sliding phase and expedite the convergence rate. Additionally, a fuzzy controller was developed to implement a fuzzy adaptive SMC strategy, optimizing the MPPT for permanent magnet synchronous wind power generation systems. Simulation results indicated that this approach offered a faster response and superior interference rejection capabilities, compared to conventional and modified SMC strategies. The improved FSMC strategy demonstrated a swift, dynamic response and excellent steady-state performance, improving the efficiency of MPPT, thus confirming the effectiveness of the proposed method.

Frequency regulation strategy of direct drive permanent magnet synchronous wind power generation system based on RPC principle

Frequency regulation strategy of direct drive permanent magnet synchronous wind power generation system based on RPC principle

A fuzzy control and neural network based rotor speed controller for maximum power point tracking in permanent magnet synchronous wind power generation system

When the wind speed changes significantly in a permanent magnet synchronous wind power generation system, the maximum power point cannot be easily determined in a timely manner. This study proposes a maximum power reference signal search method based on fuzzy control, which is an improvement to the climbing search method. A neural network-based parameter regulator is proposed to address external wind speed fluctuations, where the parameters of a proportional-integral controller is adjusted to accurately monitor the maximum power point under different wind speed conditions. Finally, the effectiveness of this method is verified via Simulink simulation

Modeling of Direct-Drive Permanent Magnet Synchronous Wind Power Generation System Considering the Power System Analysis in Multi-Timescales

The dynamics of wind power generation cannot be neglected in the modern power system and could have a great impact on the system dynamics, even raising the risk of a blackout. Because of this, power system simulation has to include the model of wind power generation. However, due to the high order of the full model of the wind power generator, it is impossible to model them in detail in the use of the power system dynamic simulation considering the thousands of wind generators in the grid. In this context, a simplified model is normally used with the trade-off in lower accuracy. As a direct-drive permanent magnet synchronous wind power generation system (D-PMSG) would take up a certain occupation in the modern power system, a proper D-PMSG simplified model is needed in the power system simulation. For a different research purpose in a different timescale, a different complexity of the model can be used to maximize the accuracy, in the meantime speeding up the simulation. This paper proposes a set of simplified models of the direct-drive permanent magnet synchronous wind power generation system (D-PMSG) and classifies them according to the timescale of the dynamics and the use cases, i.e., faults (transient stability analysis), system contingencies (voltage and frequency stability analysis) and wind speed variations (energy transformation). The accuracy of the proposed simplified models is verified by comparing them with the detailed D-PMSG electromagnetic transient mode in Matlab/Simulink, and their use case of the power system simulation is validated based on the case study of the IEEE 39-bus system considering the above scenarios.

Augmented robust T-S fuzzy control based PMSG wind turbine improved with H∞ performance

<p>In this paper, an improved augmented Takagi-Sugeno fuzzy control design applied to the system of converting wind turbine energy was proposed. The wind generator used is based on a permanent magnet synchronous wind power generator (PMSG) under varying operation of the wind speed. The proposed T-S fuzzy control strategy aims to maximize wind energy in low wind speed. A part of our contribution lies in the limitation of the power output of the wind generator in high wind speed. Through the concept of the virtual desired variables, the design of the output tracking controller is achieved. In light of this concept, the developed T-S fuzzy control was designed via parallel-distributed compensation (PDC) approach with H<sub>∞</sub> performance.</p><p>Sufficient conditions for the stability of the closed-loop system affected by external disturbances are proved from Lyapunov’s direct method and the feedback gains of the controller strategy are determined by linear matrix inequalities (LMIs) tools. Another contribution is in showing the robustness of the Takagi-Sugeno based control strategy, with a focus on a set of system parameters with model uncertainties. The simulation results show the high performance of the proposed controller strategy for a 5MW (PMSG) obtained through simulation.</p>

Research on Generator Side PWM Control of Synchronous Permanent Magnet Wind Power Generation System

This paper mainly studies the generator side converter of permanent magnet synchronous wind power generation system using dual PWM converter as the main circuit. This paper mainly studies and analyzes the control principle and control mode of generator side PWM in wind power generation system, and models and simulates the motor side converter based on rotor field oriented control. According to the control characteristics of the machine side converter, the specific idea of adopting the PWM vector control strategy is analyzed. The vector control strategy based on feedforward decoupling is proposed. The results of MATLAB / Simulink simulation show that: the PMSM Wind power generation system with vector control strategy can achieve stable power generation operation with variable speed and constant frequency, and can effectively adjust the output power of the power generation system, and the output current has good sinusoidal performance and small harmonic.

Stand Alone Performance of Permanent Magnet Synchronous Wind Power Generator with Current Source Matrix Converter

—A matrix converter is a voltage/current source AC/AC frequency converter. In grid-connected operation of a variable-speed permanent magnet synchronous wind power generator, the matrix converter is normally controlled as a voltage source converter. In this control method, the generator-side voltage is synthesized from the grid-side voltage source. However, in the stand-alone mode of operation, the grid-side stiff voltage source is not available, and the input filter of the matrix converter is unstable. In this article, a new control method is presented that controls a permanent magnet synchronous wind generator in a stand-alone mode with a matrix converter as a current source converter. The proposed method is so fast that it can control the matrix converter small capacitor voltage despite the generator large inductance and without any input filter instability. A multi-pole permanent magnet synchronous wind generator is simulated to prove the performance of the proposed control strategy.

Maximum Wind Power Tracking Control Based on PID and Feedback Linearization

Based on the mathematical model of permanent magnet synchronous generator, the paper discussed the effect of the simplifying torque coefficient equation on direct-drive permanent magnet synchronous wind power generator. On the basis of feedback linearization principle, designed a PID and feedback linearization compound controller in this paper, and validated under varying wind speed, power coefficient remains at a constant value, which reached the maximum wind power capture purposes. Using MATLAB/simulink tool to build direct-drive permanent magnet synchronous wind power system simulation model, the paper verify the stability of the system when the external applied load mutate. The result shows that the control strategy of the composite is effective and timely when tacking the maximum power.

Fault diagnosis for permanent magnet synchronous generator under chaos conditions：LMI approach

The permanent magnet synchronous wind power generator is investigated, and its mathematical model is established in two-phase synchronous rotating coordinates. By a time scaling transformation and a linear affine transformation, the chaos model is obtained, and the chaos phenomena occur when the model parameters are in a certain range and under running conditions. Then, an uncertain nonlinear model of permanent magnet synchronous wind power generator is established, and a fault observer is designed. When faults occur, the fault observer can estimate the fault quickly and accurately. Simulation results show that the fault observer based on linear matrix inequality approach can diagnosis the fault rapidly and accurately.