This study was performed to compare the resistance spot weldability of Al 5052-H32 alloy and Al 6014-T4 alloy, and the cause of the differences in the weldability was investigated. In general, the surface of the aluminum alloy has an oxide film several nm thick, and local heat input is generated at the electrode-sheet interface and the sheet-sheet interface during resistance spot welding. XPS analysis proved that the Al 5052- H32 alloy has a relatively thick magnesium oxide film on the surface and contains a large amount of magnesium solute element. As a result, Al 5052-H32 has a higher resistance, in both the contact resistance of the electrodesheet interface and sheet-sheet interface, compared with the Al 6014-T4 alloy. Therefore, the Al 5052-H32 alloy has a larger nugget diameter at the same welding current as compared to the Al 6014-T4 alloy, but the surface contamination of the electrode is aggravated due to local heat input. The results indicated that a difference in oxide film type and thickness can significantly influence resistance heat generation and electrode cooling effects, as well as produce welds with different weld morphology and microstructure. In addition, the Al 5052-H32 alloy had more pores and shrinkage in the weld than Al 6014-T4 alloy, and longitudinal cracks were observed in the center of the nugget, but had relatively excellent mechanical properties.