Links In Wireless Mesh Networks Research Articles

Promoting wired links in wireless mesh networks: an efficient engineering solution.

Wireless Mesh Networks (WMNs) cannot completely guarantee good performance of traffic sources such as video streaming. To improve the network performance, this study proposes an efficient engineering solution named Wireless-to-Ethernet-Mesh-Portal-Passageway (WEMPP) that allows effective use of wired communication in WMNs. WEMPP permits transmitting data through wired and stable paths even when the destination is in the same network as the source (Intra-traffic). Tested with four popular routing protocols (Optimized Link State Routing or OLSR as a proactive protocol, Dynamic MANET On-demand or DYMO as a reactive protocol, DYMO with spanning tree ability and HWMP), WEMPP considerably decreases the end-to-end delay, jitter, contentions and interferences on nodes, even when the network size or density varies. WEMPP is also cost-effective and increases the network throughput. Moreover, in contrast to solutions proposed by previous studies, WEMPP is easily implemented by modifying the firmware of the actual Ethernet hardware without altering the routing protocols and/or the functionality of the IP/MAC/Upper layers. In fact, there is no need for modifying the functionalities of other mesh components in order to work with WEMPPs. The results of this study show that WEMPP significantly increases the performance of all routing protocols, thus leading to better video quality on nodes.

Optimizing link rate assignment and transmission scheduling in WMN through compatible set generation

Radio links in wireless mesh networks (WMN) can select one of several modulation and coding schemes (MCS). A MCS assignment influences links data rates and their mutual interference, and therefore should be optimized. We consider joint optimization of link rate assignment and transmission scheduling in order to maximize the minimal flow in a WMN. One of the main difficulties stems from the requirement that each link has to use only one selected MCS for all its transmissions. This requirement leads to a complicated exact branch-and-price method, which is quite time-consuming for networks of practical size. Thus, we propose an original heuristic based on simulated annealing that utilizes specific characteristics of the problem. The method provides a balance between sub-optimality of the obtained solutions and the running time. The presented method is the main purpose and novelty of the paper. An extensive numerical study illustrates the effectiveness of the proposed approach.

A dynamic channel assignment strategy based on cross‐layer design for wireless mesh networks

SUMMARYIn wireless mesh networks (WMNs), if nonoverlapped channels or partially overlapped channels are used properly, the throughput can be improved drastically. However, the number of nonoverlapped channels is limited in wireless communication standards. An effective channel assignment algorithm for a WMN is necessary to increase the utilization rate of space and nonoverlapped channels. Static channel assignment algorithms can improve network throughput, but their accuracies are not satisfactory in common scenarios. Dynamic channel assignment algorithms can allocate channels according to the status of adjacent links in WMNs. A dynamic channel assignment algorithm needs cross‐layer design to get the information of routing. A routing‐information‐aware channel assignment algorithm based on a cross‐layer design is proposed, which is named R‐CA. The proposed method can dynamically allocate channels for wireless nodes when they need communication and release channels after data transmission. In R‐CA, limited channel resources can be used efficiently by more wireless nodes, and hence the communication throughput can be improved. Simulation results show that our channel allocation strategy can effectively ensure and enhance the network throughput and packet delivery rate in WMNs. Copyright © 2012 John Wiley & Sons, Ltd.