LCx Mycobacterium Tuberculosis Assay Research Articles

LCx Mycobacterium tuberculosis assay is valuable with respiratory specimens, but provides little help in the diagnosis of extrapulmonary tuberculosis

BACKGROUND. Commercial nucleic acid amplification tests, designed for the detection of Mycobacterium tuberculosis DNA/RNA in respiratory samples, are often applied also in nonrespiratory specimens in order to verify the diagnosis of extrapulmonary tuberculosis.AIM. To evaluate the value of the Abbott LCx Mycobacterium tuberculosis assay for the diagnosis of pulmonary and extrapulmonary tuberculosis based on routine clinical laboratory results.METHODS. The assay was used to analyse 350 respiratory and 826 nonrespiratory specimens from 961 patients, of whom 3.6% had culture-proven tuberculosis. The results obtained by the LCx assay were compared with the records on mycobacterial isolates of the national reference laboratory and, in the case of positive findings, with clinical data.RESULTS. In comparison with culture, the sensitivity, specificity and positive/negative predictive value of the assay on respiratory specimens were 87.5%, 99.7%, 93.3% and 99.4%, respectively. With nonrespiratory specimens, the overall sensitivity, specificity and positive/negative predictive value of the LCx assay were 73.3%, 98.0%, 40.7% and 99.5%, respectively. When clinical and histological data were also included, the positive predictive value of LCx with nonrespiratory specimens was 45.8%.CONCLUSION. Critical interpretation of the nucleic acid amplification results obtained from nonrespiratory specimens is necessary in both laboratory and clinical settings.

Detection of Mycobacterium tuberculosis in Paraffin-Embedded Pleural Biopsy Specimens by Commercial Ribosomal RNA and DNA Amplification Kits

To evaluate the utility of two gene amplification systems in historical paraffin-embedded pleural biopsy (PEB) tissues from patients with pleural tuberculosis, and to compare the results to those obtained with conventional histologic and microbiological methods. A retrospective study. Seventy-four formalin-fixed PEB tissues collected and stored over 12 years (1984 through 1995) were retrieved. Gene amplifications were performed in 57 tissues from patients with diagnoses of pleural tuberculosis and in 17 from patients with carcinoma as controls, using the first version of the Amplified Mycobacterium tuberculosis Direct Test (AMTDT; Gen-Probe; San Diego, CA) and the LCx Mycobacterium tuberculosis Assay (LCxMTB; Abbott Laboratories; Abbott Park, IL). The sensitivities of the AMTDT and LCxMTB were 52.6% and 63.2%, respectively (p = not statistically significant). The specificity of both tests was 100%. Twenty tissue samples (35.1%) were positive by both systems, and 10 tissues (17.5%) were positive only by the AMTDT, while 16 tissues (28.1%) were positive only by the LCxMTB. Both tests gave negative results for 11 specimens (19.3%). When both tests were used, a positive diagnosis was achieved in 80.7% of the samples. Diagnosis of 73.7% of patient conditions had previously been made by smear examination of pleural biopsy and sputum, pleural liquid, or biopsy culture. The overall diagnostic yield with both culture and amplification techniques was 96.5% (55 of 57 patients) for pleural tuberculosis, with amplification techniques adding 22.8% of the diagnoses. Amplification techniques are useful in archival PEB tissues, providing additional diagnoses beyond culturing, although the sensitivity should be improved, possibly by standardizing protocols.

Ligase chain reaction assay is clinically useful in the discrimination of smear-positive pulmonary tuberculosis from atypical mycobacterioses

We evaluated the usefulness of the ligase chain reaction (LCR) (Abbott LCx Mycobacterium tuberculosis assay) during the initial diagnosis of tuberculosis. LCx was carried out in parallel with conventional methods for the analysis of clinical samples. Out of 86 patients who were examined clinically, 53 were suspected of having pulmonary tuberculosis, eight had residual X-ray scars from previous tuberculosis and 25 served as asymptomatic controls. Ten bronchoscopy samples and 237 sputum samples were analysed by direct microscopy, culture and LCx. All 11 smear-positive and two of three smear-negative tuberculosis patients had at least one LCx-positive specimen. All samples that were both LCx and smear-positive were culture-positive for M. tuberculosis. The smear-positive samples from the five patients with atypical mycobacteriosis were LCx-negative. There were three false-positive results: one in a smear-negative sample from a patient with M. malmoense infection and two from two pneumonia patients. All samples from controls and patients with previous tuberculosis were LCx-negative. The sensitivity, specificity and the positive and negative predictive values of LCx in patient analysis were 92.9%, 95.8%, 81.3% and 98.6%, respectively. LCx assay of M. tuberculosis is useful in rapid confirmation of tuberculosis or atypical mycobacteriosis from a smear-positive sample and may aid in diagnosing smear-negative tuberculosis.

Comparison of Acid-Fast staining, PCR, LCR, PCR=Hybridization for dection of mycobacterum tuberculosis in clinical specimens

Background Mycobacterial culture is a confirmatory test to detect M.tuberculosis, but it takes at least 6 weeks to diagnose. PCR is a rapid and sensitive method, but it is known that PCR has a high false positive rate due to contamination, and a high false negative rate due to inhibitors. It is also known that LCR and PCR-Hybridization, recently developed methods, are more specific methods than PCR in terms of detection M.tuberculosis. In this study, we estimated the clinical utility of in house PCR, LCR and PCR-Hybridization for the detection of M.tuberculosis. Methods We evaluated 75 specimens, upon which M.tuberculosis culture based testing was requested, by PCR LCR, and PCR-Hybridization and compared results. Mycobacterial culture was performed on 3% Ogawa media for 8 weeks, and an in house PCR, LCx Mycobacterium tuberculosis assay kit(Abbott Laboratories, North Chicago, III) and the AMPLICOR M.tuberculosis test kit(Roche Molecular Systems, Inc. Branchburg, NJ, USA). Results In the view of the culture results, the sensitivities of the three tests were 40%, 80%, and 100% and their specificities were 98.6%, 94.3%, and 94.3%. Conclusion LCR and PCR-Hybridization and rapid and sensitive methods for detecting M.tuberculosis in clinical laboratories.

Multicenter evaluation of the Abbott LCx Mycobacterium tuberculosis ligase chain reaction assay.

Four Australian hospital laboratories evaluated the performance of the Abbott LCx Mycobacterium tuberculosis assay with 2,347 specimens (2,083 respiratory and 264 nonrespiratory specimens) obtained from 1, 411 patients. A total of 152 specimens (6.5%) were culture positive for Mycobacterium tuberculosis complex (MTBC); of these, 79 (52%) were smear positive. After resolution of discrepant data, the overall sensitivity, specificity, and positive and negative predictive values for the LCx assay were 69.7, 99.9, 99.1, and 97.7% respectively. For smear-positive respiratory specimens that were culture positive for MTBC, the values were 98.5, 100, 100, and 98.4%, respectively, while the values for smear-negative respiratory specimens were 41.5, 99.9, 96.4, and 98%, respectively. Relative operating characteristic curves were constructed to demonstrate the relationship between sensitivity and specificity for a range of possible cutoff values in the LCx assay. These graphs suggested that the assay sensitivity for respiratory samples could be increased from 70.2 to 78.6%, while the specificity would be reduced from 99.9 to 99.4% by inclusion of a grey zone (i.e., LCx assay values of between 0.2 and 0.99). An algorithm is presented for the handling of specimens with LCx assay values within this grey zone.

Evaluation of three commercial detection systems for Mycobacterium tuberculosis where clinical diagnosis is difficult.

AIMS: To assess the performance of three commercially available Mycobacterium tuberculosis detection systems employing nucleic acid amplification, when applied directly to respiratory and non-respiratory specimens from patients where the diagnosis...

Evaluation of the Abbott LCx Mycobacterium tuberculosis assay for direct detection of Mycobacterium tuberculosis complex in human samples.

Seven hundred thirty-seven clinical samples from 460 patients were processed for direct detection of Mycobacterium tuberculosis complex by a semiautomated ligase chain reaction commercial assay, the LCx Mycobacterium tuberculosis Assay (LCx assay) from Abbott Laboratories. Results were compared to those of direct microscopy and standard microbiological culture. Of 26 patients (5.7%) with a culture positive for M. tuberculosis, 22 (84.6%) were found positive by the LCx assay. The sensitivity of the LCx assay was 98% for smear-positive samples and 27% for smear-negative samples. With an overall culture positivity rate for M. tuberculosis of 8.3% (61 of 737 samples) and after resolution of discrepant results according to clinical data, the sensitivity, specificity, and positive and negative predictive values of the LCx assay were 78, 100, 95, and 98%, respectively, compared to 85, 100, 100, and 98%, respectively, for culture and 67, 99, 87, and 97%, respectively, for acid-fast staining. In conclusion, the LCx assay proved satisfactory and appears to be an easy-to-use 1-day test which must be used with standard culture methods but can considerably reduce diagnosis time versus culture. However, its clinical interest appears to be limited in our population with low mycobacterial prevalence because of its cost considering the small gain in sensitivity versus direct microscopy.

Rapid diagnosis of extrapulmonary tuberculosis by ligase chain reaction amplification.

A rapid amplification-based test for the diagnosis of extrapulmonary tuberculosis, the LCx Mycobacterium tuberculosis Assay from Abbott Laboratories, was evaluated. Results from the LCx M. tuberculosis Assay were compared with those from culture and the final clinical diagnosis for each patient. A total of 526 nonrespiratory specimens from 492 patients were tested. The specimens included urine; feces; lymph node exudates; pleural, cerebrospinal, articular, and ascitic fluids; tissue biopsies; gastric aspirates; purulent exudates; blood; and bone marrow aspirates. After combination of the culture results and the patient's clinical data, a total of 135 specimens were collected from 122 patients with a diagnosis of extrapulmonary tuberculosis. The sensitivity, specificity, and positive and negative predictive values for the LCx M. tuberculosis Assay were 77.7, 98.7, 95.2, and 93.1%, respectively; these values rose in resolved cases of TB to 78.5, 100, 100, and 93.1%, respectively. For 37 (27.4%) specimens from patients smear positive for the disease and 98 (72.6%) specimens from patients smear negative for the disease, the sensitivities of the LCx M. tuberculosis Assay were 100 and 71.1%, respectively. Statistically significant differences (P < 0.01) in sensitivities were found between culture and the LCx M. tuberculosis Assay. These differences were even greater among smear-negative specimens. The results demonstrate that the LCx M. tuberculosis Assay will provide rapid and valuable information for the diagnosis of extrapulmonary tuberculosis.

Evaluation of the semiautomated Abbott LCx Mycobacterium tuberculosis assay for direct detection of Mycobacterium tuberculosis in respiratory specimens.

Five hundred twenty processed respiratory specimens from 326 patients received for the diagnosis of tuberculosis or other mycobacterial infections were tested by means of the LCx Mycobacterium tuberculosis Assay from Abbott Laboratories, which uses ligase chain reaction technology for the direct detection of M. tuberculosis complex in respiratory specimens. The results of the LCx M. tuberculosis Assay were compared with the results of culture and staining techniques. After a combination of culture results and the patient's clinical data, a total of 195 specimens were collected from 110 patients who were positively diagnosed as having pulmonary tuberculosis. Twenty-three of these 195 specimens which corresponded to 10 patients with a history of pulmonary tuberculosis (TB) and anti-TB treatment ranging from 1 to 6 months were culture negative. The other 172 specimens were culture positive for M. tuberculosis. With an overall positivity rate of 37.5% (195 of 520 specimens), the sensitivity, specificity, and positive and negative predictive values were 90.8, 100, 100, and 94.7%, respectively, for the LCx M. tuberculosis Assay; 88.2, 100, 100, and 93.4%, respectively, for culture; and 82.6, 92, 72.9, and 97.6%, respectively, for acid-fast staining. For 161 specimens (82.6%) from patients smear positive for the disease and 34 specimens (17.4%) from patients smear negative for the disease, the sensitivity values for the LCx M. tuberculosis Assay were 98.8 and 53%, respectively. There were no statistically significant differences in the sensitivities and specificities between the LCx M. tuberculosis Assay and culture (P > 0.05). Conclusively, the LCx M. tuberculosis Assay has proved to have an acceptable sensitivity and a high specificity in detecting M. tuberculosis and has the potential of reducing the diagnosis time to an 8-h working day.