Laser Ablation Of Nickel Research Articles

355 nm nanosecond pulsed Nd:YAG laser profile measurement, metal thin film ablation and thermal simulation

Laser ablation of nickel, gold and copper thin film on glass substrates has been investigated using a nanosecond pulsed Nd:YAG laser operating at 355 nm in air with a Gaussian intensity profile. The exact beam profile was measured through mechanical scanning with a photodiode. A small beam defect was observed, which can affect the machining performance at higher pulse energies. The ablation thresholds of the films were calculated from the crater diameter values. The effect of the pulse repetition rate and the film thickness was also studied. At high pulse repetition rates heat accumulation was observed and the ablation threshold decreased with the film thickness. Both cases resulted in higher diameters.

Nickel plasma produced by 532-nm and 1064-nm pulsed laser ablation

A comparison between laser ablation of nickel in vacuum by using 532-and 1064-nm Nd:YAG (Yttrium Aluminium Garnet) laser wavelengths, with an intensity of 5 × 109 W/cm2, is reported. Nanosecond pulsed ablation produces high nonisotropic emission of neutrals and ionic species. For 532-nm laser irradiation, mass quadrupole spectrometry, coupled to electrostatic ion deflection and time-of-flight measurements, allows estimation of the energy distributions of the emitted species from plasma. For 1064-nm laser ablation, a cylindrical electrostatic ion analyzer permits one to measure the yield and the charge state of the emitted ions and reconstruct the ion energy and charge state distributions. Neutrals show typical Boltzmann-like distributions, while ions show Coulomb-Boltzmann-shifted distributions depending on their charge state. Surface profiles of the ablated craters permitted study of the ablation threshold and yields of nickel in vacuum versus the laser fluence. The plasma temperature was evaluated using experimental data. Special regard is given to the ion acceleration process occurring inside the plasma due to the high electrical field generated at nonequilibrium plasma conditions and the angular distribution of the emitted species.

Laser ablation of Ni by ultrashort pulses: molecular dynamics simulation

Laser ablation of nickel has been investigated by the molecular dynamics simulation technique. The 500 fs laser pulses at λ=248 nm were used in the simulations. The influence of the laser energy density on the process of ablation was studied. The time evolution of the plasma plume was shown. The threshold was determined and the ablation rate as a function of the laser energy density was obtained. The values are in good agreement with the experimental data of other authors. The dynamics of the shock wave in a solid was studied. The velocity of the ablated atoms and ions is several kilometers per second and increases with the laser fluence rise.

Sub-picosecond UV laser ablation of metals

Laser ablation of Nickel, Copper, Molybdenum, Indium, Tungsten and Gold by short ultraviolet laser pulses (0.5 ps, 248 nm) in vacuum is reported for the first time. For Nickel and Indium, ablation is also studied in air to demonstrate the influence of the ambient atmosphere. Metal ablation in air is significantly less efficient than in vacuum due to redeposition of ablated material. The ablation rates in vacuum are discussed using a thermal model, which also allows to estimate ablation rates for other metals from basic optical and thermal properties. A comparison of the morphology of ablation sites after nanosecond and sub-picosecond ablation shows unequivocally the advantages of short-pulse laser ablation for high-precision patterning of thermally good conducting materials in micron-scale dimensions.