Measurement and quality control of turbine blades is critical to the successful operation of power plants. It has a key role in manufacturing and reverse engineering. Novel technologies continue to be developed to measure parts with complex geometries, such as turbine blades. Digitizing techniques, using both contact and noncontact methods, are used. Selecting the most appropriate digitizing method for a turbine blade requires consideration of the measuring performance of the alternative methods, including criteria such as accuracy, speed and cost. This study seeks to evaluate the practical accuracy and efficiency of various contact and noncontact digitizing methods through measurement and associated quality control of a complex part, that is, a turbine blade airfoil. Four popular technologies, using distinct underlying measurement methods, were chosen to measure a Frame 5 gas turbine blade, namely, a touch trigger probe mounted on a Zeiss coordinate measuring machine, a touch scanning probe and a spot laser probe separately mounted on Renishaw coordinate measuring machine and a linear laser system from ZScanner. The measured point cloud resulting from each method was then used to reconstruct three-dimensional computer-aided design models of the blade. The accuracy of each measuring system was evaluated against the original blade. The evaluation incorporated a comparative study of design parameters derived from the point cloud and reconstructed surfaces associated with each measurement method. The maximum error of point clouds were −123, 2530 and 2173 µm for the ZScanner linear laser, Renishaw spot laser and Renishaw touch scan, respectively. These measured errors indicated higher accuracy from linear laser method than spot laser scanning and touch scanning methods. Furthermore, the achieved standard deviations of 42, 170 and 269 µm for point clouds of ZScanner linear laser, Renishaw spot laser and Renishaw touch scan, respectively, showed that the manufacturer reported that information cannot be always reliable.