Increase Of Surface-enhanced Raman Scattering Signal Research Articles

Enzyme-amplified SERS immunoassay with Ag-Au bimetallic SERS hot spots

Surface-enhanced Raman scattering (SERS) enables rapid detection of single molecules with high specificity. However, quantitative and sensitive SERS analysis has been a challenge due to the lack of reliable SERS-active materials. In this study, we developed a quantitative SERS-based immunoassay using enzyme-guided Ag growth on Raman labeling compound (RLC)-immobilized gold nanoparticle (Au NP)-assembled silica NPs (SiO2@Au-RLC@Ag). The enzyme amplified Ag+ reduction as well as Ag growth on the RLC-immobilized Au NP-assembled silica NPs (SiO2@Au-RLC), which resulted in a significant increase in SERS signal. In the presence of target antigens such as immunoglobulinG (IgG) or prostate-specific antigen (PSA), Ab1-Antigen-Ab2 immune complex with alkaline phosphatase triggered an enzyme- catalyzed reaction to convert 2-phospho-L-ascorbic acid (2-phospho-L-AA) to ascorbic acid (AA). As produced AA reduced Ag+ to Ag, forming an Ag hot spot on the surface of SiO2@Au-RLC, which enhanced the SERS signal of SiO2@Au-RLC@Ag in a solution with a target antigen concentration. The plasmonic immunoassay for IgG detection showed a high linearity of SERS intensity in the range of 0.6 to 9.0 ng/mL with a detection limit (LOD) of 0.09 ng/mL, while an LOD of 0.006 ng/mL was obtained for PSA. The results indicate that the sensitivity of our novel SERS-based immunoassay is higher than that of conventional enzyme-based colorimetric immunoassays.

Optimization of SERS Sensing With Micro-Lensed Optical Fibers and Au Nano-Film

We present the fabrication and characterization of optical fiber reflection probes based on surface-enhanced Raman scattering (SERS) and micro-lensed multimode fibers. For the SERS substrate, a nano-sphere lithography method is used. Comparison of SERS measurements with three different fiber probe configurations is presented. The proposed optimized structure shows a five times increase in SERS signal for dried Rhodamine 6G (R6G) and two times for aqueous R6G in comparison to a standard reflection configuration. Measurements of different concentrations of R6G in a water solution with an limit of detection (LOD) equal to 10−7 M are demonstrated.

Increase of SERS Signal upon Heating or Exposure to a High-Intensity Laser Field: Benzenethiol on an AgFON Substrate

The surface-enhanced Raman scattering (SERS) signal from an AgFON plasmonic substrate, recoated with benzenethiol, was observed to increase by about 100% upon heating for 3.5 min at 100C and 1.5 min at 125C. The signal intensity was found to increase further by about 80% upon a 10 sec exposure to a high-intensity (3.2 kW/cm^2) 785-nm cw laser, corresponding to 40 mW in a 40+/-5-um diameter spot. The observed increase in the SERS signal may be understood by considering the presence of benzenethiol molecules in an intermediate or 'precursor' state in addition to conventionally ordered molecules forming a self-assembled monolayer. The increase in the SERS signal arises from the conversion of the molecules in the precursor state to the chemisorbed state due to thermal and photo-thermal effects.

Nanoporous Ag–GaN thin films prepared by metal‐assisted electroless etching and deposition as three‐dimensional substrates for surface‐enhanced Raman scattering

Three‐dimensional (3D) nanoporous gallium nitride (PGaN) scaffolds are fabricated by Pt‐assisted electroless hydrofluoric acid (HF) etching of crystalline GaN followed by in situ electroless deposition of Ag nanostructures onto the interior surfaces of the nanopores, yielding a large surface area substrate for surface‐enhanced Raman scattering (SERS). The resulting 3D SERS‐active substrates have been optimized by varying reaction parameters and starting material concentration, exhibiting enhanced Raman signals 10–100× more intense than either (1) sputtered Ag‐coated porous GaN or (2) Ag‐coated planar GaN. The increase in SERS signal is attributed to a combination of the large surface area and the inherent transparency of PGaN in the visible spectral region. Overall, Ag‐decorated PGaN is a promising platform for high sensitivity SERS detection and chemical analysis, particularly for reaction and metabolic products that can be trapped inside the highly anisotropic nanoscale pores of PGaN. The potential of this sampling mode is illustrated by the ability to acquire Raman spectra of adenine down to 5 fmol. Additionally, correlated SERS and laser desorption/ionization mass spectrometry spectra can be acquired from same sample spot without further preparation, opening new possibilities for the investigation of surface‐bound molecules with substantially enhanced information content. Copyright © 2012 John Wiley & Sons, Ltd.

Detection of adenosine using surface-enhanced Raman scattering based on structure-switching signaling aptamer

In the present study, we report a novel sensitive method for the detection of adenosine using surface-enhanced Raman scattering (SERS) sensing platform based on a structure-switching aptamer. First, Ag-clad Au colloids film on a polished gold disc is prepared as enhanced substrate and modified with thiolated capture DNA. The formation of an aptamer/DNA duplex of expanded anti-adenosine aptamer and tetramethylrhodamine-labeled DNA (denoted TMR-DNA) is then developed, in which TMR-DNA could also hybridize completely with capture DNA. The introduction of adenosine thus triggers structure switching of the aptamer from aptamer/DNA duplex to aptamer/target complex. As a result, the released TMR-DNA is captured onto the SERS substrate, resulting in an increase of SERS signal. Under optimized assay conditions, a wide linear dynamic range (2.0 × 10 −8 M to 2 × 10 −6 M) was reached with low detection limit (1.0 × 10 −8 M). Moreover, high selectivity, stability and facile regeneration are achieved. The successful test demonstrates the feasibility of the strategy for adenosine assay.