Implosions Of Planar Wire Arrays Research Articles

Determination of plasma pinch time and effective current radius of double planar wire array implosions from current measurements on a 1-MA linear transformer driver

Implosions of planar wire arrays were performed on the Michigan Accelerator for Inductive Z-pinch Experiments, a linear transformer driver (LTD) at the University of Michigan. These experiments were characterized by lower than expected peak currents and significantly longer risetimes compared to studies performed on higher impedance machines. A circuit analysis showed that the load inductance has a significant impact on the current output due to the comparatively low impedance of the driver; the long risetimes were also attributed to high variability in LTD switch closing times. A circuit model accounting for these effects was employed to measure changes in load inductance as a function of time to determine plasma pinch timing and calculate a minimum effective current-carrying radius. These calculations showed good agreement with available shadowgraphy and x-ray diode measurements.

Time-gated measurements of electron beam generated Kα emission lines from brass planar wire array implosions

The relative amount of Kα radiation emitted by partially ionized copper and zinc from planar wire arrays on the 1 MA Zebra generator at the University of Nevada, Reno, does not correspond to the composition (70% copper, 30% zinc) of the array's brass wires. For example, the copper Kα line at 8 keV was observed to be much stronger than would be expected from zinc's Kα radiation at 8.6 keV, but this ratio also reversed, more emission from zinc than from copper, during the X-ray pulse. An excess of Kα photons from copper is consistent with a beam of electrons with energies above copper's K-edge but below that of zinc, but the opposite case is perplexing. Preferential ablation of Zn over Cu early in the current pulse could be a contributing factor, but opacity effects are not. Synthetic spectra for brass computed by a non-LTE collisional-radiative model that includes an electron beam component compare well with observed K-shell spectra, and suggest the parent ions of the Kα emission. These ionization stages are consistent with L-shell spectra. This comparison also indicates that the total energy in the electron beam increases towards the end of the radiation pulse while the electron temperature decreases. The crucial diagnostic in this measurement is a time-resolved X-ray spectrometer based on a LiF crystal.