Hydraulic Residence Time Distribution Research Articles

Simulation and optimization of hydraulic performance of small baffled subsurface flow constructed wetland.

The water body inside the constructed wetland is affected by various factors, and the flow state is relatively complicated. There will always be a certain degree of low velocity area and rapid outflow phenomenon, which makes part of the space in the wetland unable to be effectively used. Based on Computational Fluid Dynamics (CFD) technology, this paper uses Fluent's porous media model and discrete phase model to establish a hydrodynamic model of up and down baffled subsurface flow constructed wetland system. The internal flow field of the wetland is simulated, and the hydraulic performance of different baffle settings and substrate laying methods in the wetland is systematically evaluated. The results show that when the number of baffles is the same, the hydraulic efficiency is higher when the first baffle is located on the lower part of the substrate. Compared with the position of the baffle, the increase in the number of baffles does not significantly improve the hydraulic efficiency of the constructed wetland. The substrate layer thickness ratio has a significant effect on the two parameters of the variance of the hydraulic residence time distribution (σ2) and the flow divergence (σ02). By increasing the thickness of the middle substrate, the low flow rate phenomenon caused by the small porosity substrate area of the upper layer and the rapid outflow phenomenon of the lower substrate can be improved to a certain extent, the utilization efficiency of the middle substrate layer is improved, and the hydraulic performance is increased. The research results are of great significance for improving the utilization of wetland space and ensuring its efficient decontamination and purification function.

High performance spiral wound microbial fuel cell with hydraulic characterization

The understanding and development of functioning systems are crucial steps for microbial fuel cell (MFC) technology advancement. In this study, a compact spiral wound MFC (swMFC) was developed and hydraulic residence time distribution (RTD) tests were conducted to investigate the flow characteristics in the systems. Results show that two-chamber swMFCs have high surface area to volume ratios of 350–700m2/m3, and by using oxygen cathode without metal-catalysts, the maximum power densities were 42W/m3 based on total volume and 170W/m3 based on effective volume. The hydraulic step-input tracer study identified 20–67% of anodic flow dead space, which presents new opportunities for system improvement. Electrochemical tools revealed very low ohmic resistance but high charge transfer and diffusion resistance due to catalyst-free oxygen reduction. The spiral wound configuration combined with RTD tool offers a holistic approach for MFC development and optimization.

Impact of approach used to determine removal levels of drugs of abuse during wastewater treatment

In this study the levels of 19 drugs of abuse were estimated throughout a wastewater treatment plant using polar organic chemical integrative samplers (POCIS), 24h composite samples and grab samples. Overall removal efficiencies and removals in between each treatment unit were calculated using load data for each sampling technique as well as removals that take into account the hydraulic residence time distribution of the treatment plant (time-shifted mass balancing approach). Amphetamine-type stimulants, cocaine and its major metabolite, benzoylecgonine and opioid levels determined with 24h composite samples were generally comparable to those obtained with POCIS and grab samples. Negative mass balances resulting from the estimation of overall removal efficiencies by POCIS, day-to-day mass balancing of 24h composite and grab sample data did not occur when the hydraulic retention time (HRT) distributions of the plant were taken into account for calculation. Among the compounds investigated, cocaine exhibited the highest overall removal (90%) while codeine had the lowest with 13%, respectively. Sampling between the treatment units revealed that highest removal occurs during biological treatment as compared to primary or secondary clarification. Methylenedioxyamphetamine (MDA), fentanyl, dihydrocodeine and heroin were not detected in wastewater at any of the sampling locations at the treatment plant regardless of the sampling technique. The study demonstrates the benefits of applying the time-shifted mass balancing approach to the calculation of removals of drugs of abuse during wastewater treatment.

Taenia eggs in a stabilization pond system with poor hydraulics: concern for human cysticercosis?

The objective of this study is to compare the removal of Taenia eggs to the removal of Ascaris eggs in a wastewater stabilization pond system consisting of three ponds in series, where the hydraulic residence time distribution has been characterized via a tracer study supported by computational fluid dynamics modeling. Despite a theoretical hydraulic retention time of 30 days, the peak dye concentration was measured in the effluent of the first pond after only 26 hours. The smaller-sized Taenia eggs were detected in higher concentrations than Ascaris eggs in the raw wastewater. Ascaris eggs were not detected in the pond system effluent, but 45 Taenia eggs/L were detected in the system effluent. If some of these eggs were of the species Taenia solium, and if the treated wastewater were used for the irrigation of crops for human consumption, farmers and consumers could potentially be at risk for neurocysticercosis. Thus, limits for Taenia eggs in irrigation water should be established, and precautions should be taken in regions where pig taeniasis is endemic. The results of this study indicate that the theoretical hydraulic retention time (volume/flow) of a pond is not always a good surrogate for helminth egg removal.

Xenobiotic removal efficiencies in wastewater treatment plants: Residence time distributions as a guiding principle for sampling strategies

The effect of mixing regimes and residence time distribution (RTD) on solute transport in wastewater treatment plants (WWTPs) is well understood in environmental engineering. Nevertheless, it is frequently neglected in sampling design and data analysis for the investigation of polar xenobiotic removal efficiencies in WWTPs. Most studies on the latter use 24-h composite samples in influent and effluent. The effluent sampling period is often shifted by the mean hydraulic retention time assuming that this allows a total coverage of the influent load. However, this assumption disregards mixing regime characteristics as well as flow and concentration variability in evaluating xenobiotic removal performances and may consequently lead to biased estimates or even negative elimination efficiencies. The present study aims at developing a modeling approach to estimate xenobiotic removal efficiencies from monitoring data taking the hydraulic RTD in WWTPs into consideration. For this purpose, completely mixed tanks-in-series were applied to address hydraulic mixing regimes in a Luxembourg WWTP. Hydraulic calibration for this WWTP was performed using wastewater conductivity as a tracer. The RTD mixing approach was coupled with first-order biodegradation kinetics for xenobiotics covering three classes of biodegradability during aerobic treatment. Model simulations showed that a daily influent load is distributed over more than one day in the effluent. A 24-h sampling period with an optimal time offset between influent and effluent covers less than the half of the influent load in a dry weather scenario. According to RTD calculations, an optimized sampling strategy covering four consecutive measuring days in the influent would be necessary to estimate the full-scale elimination efficiencies with sufficient accuracy. Daily variations of influent flow and concentrations can substantially affect the reliability of these sampling results. Commonly reported negative removal efficiencies for xenobiotics might therefore be a consequence of biased sampling schemes. In this regard, the present study aims at contributing to bridge the gap between environmental chemistry and engineering practices.

Hydraulic residence time computation for constructed wetland design

Hydraulic residence time (HRT) is one of the key design parameters controlling the removal efficiency of contaminants and nutrients in stormwater and wastewater wetlands. The paper presents a new approach to the estimation of HRT using the variable residence time (VART) model. The VART model is employed to simulate the major processes (including advection, dispersion, and transient storage of contaminants/nutrients in vegetated zones) affecting HRT and thereby to produce a hydraulic residence time distribution (HRTD) for a design wetland. The HRTD in combination with a moment-based method is then utilized to find a mean design HRT for the design wetland. Methods for estimation of parameters governing the HRTD are proposed. The new approach to HRT computation is demonstrated through a case study for the Tres Rios Demonstration (TRD) Wetlands in Arizona, USA. Modeling results show that the design HRTs for the Hayfield wetland (H1) and the Cobble wetlands (C1 and C2) are 4.04, 4.66, and 2.65 days, respectively. The computed HRTs agree well with those reported by previous studies, confirming the efficacy of the new approach to hydraulic design of constructed wetlands.

Design methodology accounting for the effects of porous medium heterogeneity on hydraulic residence time and biodegradation in horizontal subsurface flow constructed wetlands

Horizontal flow constructed wetlands are engineered systems capable of eliminating a wide range of pollutants from the aquatic environment. Nevertheless, poor hydrodynamic behavior is commonly found resulting in preferential pathways and variations in both (i) the hydraulic residence time distribution (HRTD) and, consequently, (ii) the wetland's treatment efficiency. The aim of this work was to outline a methodology for wetland design that accounts for the effect of heterogeneous hydraulic properties of the porous substrate on the HRTD and treatment efficiency. Biodegradation of benzene was used to illustrate the influence of hydraulic conductivity heterogeneity on wetland efficiency. Random, spatially correlated hydraulic conductivity fields following a log-normal distribution were generated and then introduced in a subsurface flow numerical model. The results showed that the variance of the distribution and the correlation length in the longitudinal direction are key indicators of the extent of heterogeneity. A reduction of the mean hydraulic residence time was observed as the extent of heterogeneity increased, while the HRTD became broader with increased skewness. At the same time, substrate heterogeneity induced preferential flow paths within the wetland bed resulting in variations of the benzene treatment efficiency. Further to this it was observed that the distribution of biomass within the porous bed became heterogeneous, rising questions on the representativeness of sampling. It was concluded that traditional methods for wetland design based on assumptions such as a homogeneous porous medium and plug flow are not reliable. The alternative design methodology presented here is based on the incorporation of heterogeneity directly during the design phase. The same methodology can also be used to optimize existing systems, where the HRTD has been characterized with tracer experiments.