Individuals with cam morphology are prone to chondrolabral injuries that may progress to osteoarthritis. The mechanical factors responsible for the initiation and progression of chondrolabral injuries in these individuals are not well understood. Additionally, although labral repair is commonly performed during surgical correction of cam morphology, the isolated mechanical effect of labral repair on the labrum and surrounding cartilage is unknown. Using a volunteer-specific finite-element analysis, we asked: (1) How does cam morphology create a deleterious mechanical environment for articular cartilage (as evaluated by shear stress, tensile strain, contact pressure, and fluid pressure) that could increase the risk of cartilage damage compared with a radiographically normal hip? (2) How does chondrolabral damage, specifically delamination, delamination with rupture of the chondrolabral junction, and the presence of a chondral defect, alter the mechanical environment around the damage? (3) How does labral repair affect the mechanical environment in the context of the aforementioned chondrolabral damage scenarios? The mechanical conditions of a representative hip with normal bony morphology (characterized by an alpha angle of 37°) and one with cam morphology (characterized by an alpha angle of 78°) were evaluated using finite-element models that included volunteer-specific anatomy and kinematics. The bone, cartilage, and labrum geometry for the hip models were collected from two volunteers matched by age (25 years with cam morphology and 23 years with normal morphology), BMI (both 24 kg/m2), and sex (both male). Volunteer-specific kinematics for gait were used to drive the finite-element models in combination with joint reaction forces. Constitutive material models were assigned to the cartilage and labrum, which simulate a physiologically realistic material response, including the time-dependent response from fluid flow through the cartilage, and spatially varied response from collagen fibril reinforcement. For the cam hip, three models were created to represent chondrolabral damage conditions: (1) "delamination," with the acetabular cartilage separated from the bone in one region; (2) "delamination with chondrolabral junction (CLJ) rupture," which includes separation of the cartilage from the labrum tissue; and (3) a full-thickness chondral defect, referred to throughout as "defect," where the acetabular cartilage has degraded so there is a void. Each of the three conditions was modeled with a labral tear and with the labrum repaired. The size and location of the damage conditions simulated in the cartilage and labrum were attained from reported clinical prevalence of the location of these injuries. For each damage condition, the contact area, contact pressure, tensile strain, shear stress, and fluid pressure were predicted during gait and compared. The cartilage in the hip with cam morphology experienced higher stresses and strains than the normal hip. The peak level of tensile strain (25%) and shear stress (11 MPa) experienced by the cam hip may exceed stable conditions and initiate damage or degradation. The cam hip with simulated damage experienced more evenly distributed contact pressure than the intact cam hip, as well as decreased tensile strain, shear stress, and fluid pressure. The peak levels of tensile strain (15% to 16%) and shear stress (2.5 to 2.7 MPa) for cam hips with simulated damage may be at stable magnitudes. Labral repair only marginally affected the overall stress and strain within the cartilage, but it increased local tensile strain in the cartilage near the chondrolabral junction in the hip with delamination and increased the peak tensile strain and shear stress on the labrum. This finite-element modeling pilot study suggests that cam morphology may predispose hip articular cartilage to injury because of high shear stress; however, the presence of simulated damage distributed the loading more evenly and the magnitude of stress and strain decreased throughout the cartilage. The locations of the peak values also shifted posteriorly. Additionally, in hips with cam morphology, isolated labral repair in the hip with a delamination injury increased localized strain in the cartilage near the chondrolabral junction. In a hip with cam morphology, labral repair alone may not protect the cartilage from damage because of mechanical overload during the low-flexion, weightbearing positions experienced during gait. The predicted findings of redistribution of stress and strain from damage in the cam hip may, in some cases, relieve disposition to damage progression. Additional studies should include volunteers with varied acetabular morphology, such as borderline dysplasia with cam morphology or pincer deformity, to analyze the effect on the conclusions presented in the current study. Further, future studies should evaluate the combined effects of osteochondroplasty and chondrolabral treatment.
Read full abstract
Oct 1, 2024
Chirayu M Patel + 12
Open Access