Higher Biomass Activity Research Articles

Spatial heterogeneity of biofouling under different cross-flow velocities in reverse osmosis membrane systems

The spatially heterogeneous distribution of biofouling in spiral wound membrane systems restricts (i) the water distribution over the membrane surface and therefore (ii) the membrane-based water treatment. The objective of the study was to assess the spatial heterogeneity of biofilm development over the membrane fouling simulator (MFS) length (inlet and outlet part) at three different cross-flow velocities (0.08, 0.12 and 0.16m/s). The MFS contained sheets of membrane and feed spacer and simulated the first 0.20m of spiral-wound membrane modules where biofouling accumulates the most in practice. In-situ non-destructive oxygen imaging using planar optodes was applied to determine the biofilm spatially resolved activity and heterogeneity.Comparison of the inlet and outlet position of the MFS showed a more (i) heterogeneous biofilm distribution and a (ii) higher biological activity at the inlet side (first 2.5cm) for all cross-flow velocities. The lowest cross-flow velocity had the highest biomass activity particularly at the inlet side. A better characterization of biofilm development, including the factors that influence the biofilm spatial heterogeneity in membrane systems with time, may help to develop effective strategies for biofouling control in membrane systems.

Bioreactor Function under Perturbation Scenarios Is Affected by Interactions between Bacteria and Protozoa

This study investigated the impact of transient cadmium perturbations on the structure and function of the microbial community in an activated sludge system. The impact of cadmium perturbation on the bioreactor performance, bacterial activity, bacterial community structure, and bacteria-protozoa interactions was examined. The bacterial community exhibited a short-term inhibition following a pulse perturbation of cadmium. Process recovery was associated with an increase in bacterial abundance above the unperturbed control reactor, followed by high biomass activity after the washout of cadmium. This trend was seen for multiple experiments at both laboratory- and pilot-scale. The increase in biomass activity could not be explained by changes in bacterial community structure. Independent experiments showed that the increase in bacterial abundance, and by association biomass activity, was caused by the decrease in the protozoal grazing due to the higher inhibition of ciliated protozoa as compared to bacteria when exposed to cadmium. This paper highlights the importance of expanding the investigative boundaries of the microbial ecology of bioengineered systems to include protozoal grazing, especially under perturbation scenarios.

Molecular and physiological approaches to understand the ecology of methanol degradation during the biofiltration of air streams

A 13.4L biofilter treating an off-gas stream supplemented with methanol under two different situations was studied in terms of MeOH removal efficiency, microbial ecology and odor removal. During Period 1 (P1) the reactor was packed with wood bark chips with no pH control, treating an off-gas resulting from the aerobic chamber of a membrane biological reactor treating sewage and located outdoor, whereas during Period 2 (P2) a compressed air stream fed with MeOH was treated using PVC rings and maintaining pH at neutral values. Both systems operated at 96g MeOHm−3h−1 achieving removal efficiencies of around 90% during P1 and 99.9% during P2. The relative activity of biomass developed in both systems was assessed using respirometric analysis with samples obtained from both biofilms. Higher biomass activity was obtained during P2 (0.25–0.35kg MeOHkg−1VSSd−1) whereas 1.1kg MeOHkg−1VSSd−1 was obtained in the case of P1. The application of molecular and microscopic techniques showed that the eukaryotes were predominant during P1, being the yeast Candida boidinii the most abundant microorganism. A specific Fluorescence in situ hybridization probe was designed for C. boidinii and tested successfully. As a result of the neutral pH, a clear predominance of prokaryotes was detected during P2. Interestingly, some anaerobic bacteria were detected such as Desulfovibrio, Desulfobacteraceae species and also some archaea such as Methanosarcina.

Metabolic activity test in investigation of biodegradation in biological filters

The esterase activity (EA) metabolic activity test was shown to be applicable to measurement of the activity of biomass of biofilters. The method was reproducible and detected significant differences in biomass activity in different filters and at various depths within each filter. The highest biomass activity occurred at the bed surface in 60% of filter media. The EA test also revealed the changes of biomass activity during the time of filter operation as a result of backwashing. For all investigated filters maximum biomass activity in the middle of washing cycle was observed. Following backwashing, the activity dropped to a minimum. The relation between TOC (total organic carbon) and COD (chemical oxygen demand) removal and biomass activity were noted. The results presented in the paper suggest that the metabolic activity test can be used in investigation of the performance of biofilters.

Process development for anaerobic waste water treatment using porous carriers for microbial colonization

A chemostat is well known to be a tool for selecting microorganisms with minimum doubling times during continuous fermentation, which is of special importance for slowly growing microorganisms like those used in anaerobic digestion. By set point control (SPC) of the operation parameters — especially of residence time τ — by means of a process computer, the selection stress can be optimized. A continuous operation very close to wash-out conditions is possible in spite of the microorganisms population changing properties. For anaerobic digestion of acid, a biomass was obtained that could reduce the chemical oxygen demand (COD) by more than 20 kg per kg dry biomass per d. For a high space-time yield, not only a high biomass activity but also a high biomass concentration is needed; therefore, methods for biomass retention or recycling have been developed. A porous glass sponge with free permeable macropores that can be colonized by anaerobic microorganisms proved to be especially useful. Raschig ring-shaped particles of this material were used in fixed-bed loop reactors for the anaerobic digestion of organically high polluted effluents.