High temperature solid oxide fuel cell (SOFC) is regarded as a unique electrochemical device to convert the chemical energy of a large diversity of fuels into electricity and heat with high efficiency and low emission. The electrolyte-supported cell (ESC) design is proven to be one of the most feasible SOFC technologies for commercial applications. Thickness reduction of yttria stabilized zirconia (YSZ) electrolyte supports without sacrifice of mechanical strength is favorable for cell performance enhancement.In this work, dense gadolinium-doped ceria (GDC) thin-films with thickness in the range of 0.15-0.5 µm were fabricated as Sr-barrier layers on the cathode side, and as strength-balance and adhesion layer on the anode side by electron beam physical vapor deposition (EB-PVD) method. Replacing the state-of-the-art screen-printed GDC layers, the approach with YSZ substrate sandwiched in between two GDC thin-films was proposed not only to prevent the formation of interfacial secondary phase on the cathode side, but also to increase the overall robustness of ESCs. Investigated by scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDX), it was confirmed that 0.5 µm thick GDC thin-films were effective to suppress the formation of Sr-zirconate phase at the YSZ/GDC interface. In comparison to reference cells with screen-printed GDC layers, higher breaking loads were recorded on the cells with PVD-GDC thin-films by Ring-On-Ring bending tests, showing considerably improved mechanical properties. Current-voltage characteristics and electrochemical impedance spectroscopy demonstrated that the performance of the as-prepared ESCs with GDC thin-films was comparable to the reference cells. Operated at 860 °C, the ESC with 0.5 µm GDC thin-film outperformed other tested cells with 0.15 µm or 0.3 µm GDC layers, and delivered a power density of 0.55 W•cm-2 at a cell voltage of 0.7 V. The results achieved in this work can be considered as step stones for the further development of ESCs with reduced electrolyte thickness, sufficient robustness and improved performance.This work is financially supported by the German Ministry for Economic Affairs and Energy (BMWi) within the framework of the project “Kostenoptimierter Stack und verbessertes Offgrid-System (KOSOS)” with grant number of 03ETB005C.