Full-order Extended Kalman Filter Research Articles

A Method to Improve the Response of a Speed Loop by Using a Reduced-Order Extended Kalman Filter

In servo systems, encoders are usually used to measure the position and speed signals of electric machines. But in a low speed range, the traditional M/T method has a larger time delay, which will cause an increase of the speed loop order and degradation of the speed loop performance. A method employed to reduce the delay of speed feedback by using a reduced-order Extended Kalman Filter (EKF) is introduced in this paper. The speed of the permanent magnet synchronous motor is estimated by the reduced-order EKF in a low speed range, which reduces the delay of speed feedback and extends the cutoff frequency of the speed loop to improve the dynamic performance of the servo system. In order to solve the issues that the traditional full-order EKF is sensitive to the inertia of the system and computationally complex, a composite load torque observer (CLTO) is proposed in this paper. The load torque and the friction torque are simultaneously observed by the CLTO. Additionally, the CLTO is used to reduce the order of the EKF, which reduces the sensitivity of EKF on inertia to enhance the robustness of the algorithm and simplifies the computational complexity. The feasibility and effectivity of the above method are verified by simulations and experiments.

Concurrent hyperthermia estimation schemes based on extended Kalman filtering and reduced-order modelling.

The success of treating cancerous tissue with heat depends on the temperature elevation, the amount of tissue elevated to that temperature, and the length of time that the tissue temperature is elevated. In clinical situations the temperature of most of the treated tissue volume is unknown, because only a small number of temperature sensors can be inserted into the tissue. A state space model based on a finite difference approximation of the bioheat transfer equation (BHTE) is developed for identification purposes. A full-order extended Kalman filter (EKF) is designed to estimate both the unknown blood perfusion parameters and the temperature at unmeasured locations. Two reduced-order estimators are designed as computationally less intensive alternatives to the full-order EKF. Simulation results show that the success of the estimation scheme depends strongly on the number and location of the temperature sensors. Superior results occur when a temperature sensor exists in each unknown blood perfusion zone, and the number of sensors is at least as large as the number of unknown perfusion zones. Unacceptable results occur when there are more unknown perfusion parameters than temperature sensors, or when the sensors are placed in locations that do not sample the unknown perfusion information.