Extracted Calf Surfactant Research Articles

Changes in membrane elasticity caused by the hydrophobic surfactant proteins correlate poorly with adsorption of lipid vesicles.

To establish how the hydrophobic surfactant proteins, SP-B and SP-C, promote adsorption of lipids to an air/water interface, we used X-ray diffuse scattering (XDS) to determine an order parameter of the lipid chains (Sxray) and the bending modulus of the lipid bilayers (KC). Samples contained different amounts of the proteins with two sets of lipids. Dioleoylphosphatidylcholine (DOPC) provided a simple, well characterized model system. The nonpolar and phospholipids (N&PL) from extracted calf surfactant provided the biological mix of lipids. For both systems, the proteins produced changes in Sxray that correlated well with KC. The dose-response to the proteins, however, differed. Small amounts of protein generated large decreases in Sxray and KC for DOPC that progressed monotonically. The changes for the surfactant lipids were erratic. Our studies then tested whether the proteins produced correlated effects on adsorption. Experiments measured the initial fall in surface tension during adsorption to a constant surface area, and then expansion of the interface during adsorption at a constant surface tension of 40 mN m-1. The proteins produced a sigmoidal increase in the rate of adsorption at 40 mN m-1 for both lipids. The results correlated poorly with the changes in Sxray and KC in both cases. Disordering of the lipid chains produced by the proteins, and the softening of the bilayers, fail to explain how the proteins promote adsorption of lipid vesicles.

Structural Changes in Films of Pulmonary Surfactant Induced by Surfactant Vesicles.

When compressed by the shrinking alveolar surface area during exhalation, films of pulmonary surfactant in situ reduce surface tension to levels at which surfactant monolayers collapse from the surface in vitro. Vesicles of pulmonary surfactant added below these monolayers slow collapse. X-ray scattering here determined the structural changes induced by the added vesicles. Grazing incidence X-ray diffraction on monolayers of extracted calf surfactant detected an ordered phase. Mixtures of dipalmitoyl phosphatidylcholine and cholesterol, but not the phospholipid alone, mimic that structure. At concentrations that stabilize the monolayers, vesicles in the subphase had no effect on the unit cell, and X-ray reflection showed that the film remained monomolecular. The added vesicles, however, produced a concentration-dependent increase in the diffracted intensity. These results suggest that the enhanced resistance to collapse results from enlargement by the additional material of the ordered phase.

Location of the Hydrophobic Surfactant Proteins, SP-B and SP-C, in Fluid-Phase Bilayers.

The hydrophobic surfactant proteins, SP-B and SP-C, promote rapid adsorption by the surfactant lipids to the surface of the liquid that lines the alveolar air sacks of the lungs. To gain insights into the mechanisms of their function, we used X-ray diffuse scattering (XDS) and molecular dynamics (MD) simulations to determine the location of SP-B and SP-C within phospholipid bilayers. Initial samples contained the surfactant lipids from extracted calf surfactant with increasing doses of the proteins. XDS located protein density near the phospholipid headgroup and in the hydrocarbon core, presumed to be SP-B and SP-C, respectively. Measurements on dioleoylphosphatidylcholine (DOPC) with the proteins produced similar results. MD simulations of the proteins with DOPC provided molecular detail and allowed direct comparison of the experimental and simulated results. Simulations used conformations of SP-B based on other members of the saposin-like family, which form either open or closed V-shaped structures. For SP-C, the amino acid sequence suggests a partial α-helix. Simulations fit best with measurements of XDS for closed SP-B, which occurred at the membrane surface, and SP-C oriented along the hydrophobic interior. Our results provide the most definitive evidence yet concerning the location and orientation of the hydrophobic surfactant proteins.

The Location of the Hydrophobic Proteins SP-B and SP-C in Fluid-Phase Bilayers

Pulmonary surfactant is a mixture of lipids and proteins that lowers surface tension in the lungs. The material acts as a surfactant, forming a film on the liquid layer that lines the alveoli. Two hydrophobic proteins, the homodimeric SP-B and monomeric SP-C, are essential for surfactant function. SP-B, which accelerates adsorption of the surfactant lipids to form the interfacial film, belongs to the Saposin-like family of proteins, which adopt a saposin fold in the open or closed configuration. A model membrane containing a single lipid, dioleoyl phosphatidylcholine, allowed molecular dynamics simulation of the bilayer with each protein. Simulations considered SP-B in both the open and closed configuration, and SP-C as transmembrane or deeply buried in the hydrophobic region. X-ray diffuse scattering (XDS) provided experimental structural information. The experimental and simulated form factors agreed best with SP-B in the closed configuration, and SP-C in the hydrocarbon interior. XDS also provided structural information for bilayers of extracted calf surfactant, which contains the physiological mixture of lipids and proteins. The location of the proteins, determined by analyzing the data with the Scattering Density Profile program, again showed SP-B in the headgroup region of the bilayer and SP-C in the hydrocarbon interior. Electron density profiles with component groups, as well as dynamic snapshots from simulations, yielded a visual representation of where the proteins are located.

Surface Reflectivity from Absorbed Films of Pulmonary Surfactant at the Air-Liquid Interface

Pulmonary surfactant (PS) is the complex mixture of lipids and proteins that forms a thin film on the liquid layer that lines the alveolar air-sacks of the lungs. When compressed by the decreasing alveolar surface area during exhalation, the surfactant films reduce surface tension to exceptionally low levels. This behavior in situ contrasts with the performance of spread monolayers in vitro that contain the complete set of surfactant constituents, which collapse promptly when compressed below the equilibrium spreading pressure. The structural characteristics that provide the basis for this functional difference remain controversial. The studies here used X-ray reflectivity to compare the structure of adsorbed films and spread monolayers of extracted calf surfactant on the air-water interface. Our results show the presence in the adsorbed film of additional double layers of distinct electron densities underneath the interfacial monolayer. These results support previous evidence that adsorbed films of pulmonary surfactant have multilamellar thickness, and that the additional layers may have functional significance.

The Accelerated Late Adsorption of Pulmonary Surfactant

Adsorption of pulmonary surfactant to an air−water interface lowers surface tension (γ) at rates that initially decrease progressively, but which then accelerate close to the equilibrium γ. The studies here tested a series of hypotheses concerning mechanisms that might cause the late accelerated drop in γ. Experiments used captive bubbles and a Wilhelmy plate to measure γ during adsorption of vesicles containing constituents from extracted calf surfactant. The faster fall in γ reflects faster adsorption rather than any feature of the equation of state that relates γ to surface concentration (Γ). Adsorption accelerates when γ reaches a critical value rather than after an interval required to reach that γ. The hydrophobic surfactant proteins (SPs) represent key constituents, both for reaching the γ at which the acceleration occurs and for producing the acceleration itself. The γ at which rates of adsorption increase, however, is unaffected by the Γ of protein in the films. In the absence of the proteins, a phosphatidylethanolamine, which, like the SPs, induces fusion of the vesicles with the interfacial film, also causes adsorption to accelerate. Our results suggest that the late acceleration is characteristic of adsorption by fusion of vesicles with the nascent film, which proceeds more favorably when the Γ of the lipids exceeds a critical value.

Differential Effects of Lysophosphatidylcholine on the Adsorption of Phospholipids to an Air/Water Interface

To determine how the hydrophobic surfactant proteins promote insertion of the surfactant lipids into an air/water interface, we measured the effect of lysophosphatidylcholine (LPC) on adsorption. Existing models contend that the proteins function either by disordering the lipids or by stabilizing a negatively curved structure located between the adsorbing vesicle and the interface. Because LPC produces greater disorder but positive curvature, the models predict opposite effects. With vesicles containing either dioleoyl phosphatidylcholine (DOPC) or the neutral and phospholipids isolated from calf surfactant, LPC increased the initial rate at which surface tension fell. The final surface tension, however, remained well above the value of ∼25 mN/m expected for a saturated surface. With two preparations, dioleoyl phosphatidylethanolamine and gramicidin A-DOPC, which form the negatively curved hexagonal-II (H II) phase and adsorb rapidly, LPC instead had little effect on initial adsorption but delayed the fall of surface tension below ∼30 mN/m. LPC produced a similar inhibition of the late adsorption for extracted calf surfactant. Unlike dioleoyl phosphatidylethanolamine and gramicidin A-DOPC, small-angle x-ray scattering and 31P-nuclear magnetic resonance for extracted calf surfactant detected no evidence for the H II phase. Our results indicate that although LPC can promote the initial adsorption of vesicles containing only lamellar lipids, it inhibits the facilitation by the hydrophobic proteins of late adsorption. Our findings support a model in which the surfactant proteins accelerate adsorption by producing a focal tendency to stabilize a negatively curved kinetic intermediate without a general shift to the H II phase.

Rapid Compression Transforms Interfacial Monolayers of Pulmonary Surfactant

Films of pulmonary surfactant in the lung are metastable at surface pressures well above the equilibrium spreading pressure of 45 mN/m but commonly collapse at that pressure when compressed in vitro. The studies reported here determined the effect of compression rate on the ability of monolayers containing extracted calf surfactant at 37°C to maintain very high surface pressures on the continuous interface of a captive bubble. Increasing the rate from 2 Å 2/phospholipid/min (i.e., 3% of (initial area at 40 mN/m)/min) to 23%/s produced only transient increases to 48 mN/m. Above a threshold rate of 32%/s, however, surface pressures reached >68 mN/m. After the rapid compression, static films maintained surface pressures within ±1 mN/m both at these maximum values and at lower pressures following expansion at <5%/min to ≥45 mN/m. Experiments with dimyristoyl phosphatidylcholine at 37°C produced similar results. These findings indicate that compression at rates comparable to values in the lungs can transform at least some phospholipid monolayers from a form that collapses readily at the equilibrium spreading pressure to one that is metastable for prolonged periods at higher pressures. Our results also suggest that transformation of surfactant films can occur without refinement of their composition.

Neutral lipids induce critical behavior in interfacial monolayers of pulmonary surfactant.

We have shown previously that lateral compression of pulmonary surfactant monolayers initially induces separation of two phases but that these remix when the films become more dense (1). In the studies reported here, we used fluorescence microscopy to examine the role of the different surfactant constituents in the remixing of the separated phases. Subfractions containing only the purified phospholipids (PPL), the surfactant proteins and phospholipids (SP&PL), and the neutral and phospholipids (N&PL) were obtained by chromatographic separation of the components in extracted calf surfactant (calf lung surfactant extract, CLSE). Compression of the different monolayers produced nonfluorescent domains that emerged for temperatures between 20 and 41 degreesC at similar surface pressures 6-8 mN/m higher than values observed for dipalmitoyl phosphatidylcholine (DPPC), the most prevalent component of pulmonary surfactant. Comparison of the different preparations showed that the neutral lipid increased the total nonfluorescent area at surface pressures up to 25 mN/m but dispersed that total area among a larger number of smaller domains. The surfactant proteins also produced smaller domains, but they had the opposite effect of decreasing the total nonfluorescent area. Only the neutral lipids caused remixing. In images from static monolayers, the domains for N&PL dropped from a maximum of 26 +/- 3% of the interface at 25 mN/m to 4 +/- 2% at 30 mN/m, similar to the previously reported behavior for CLSE. During continuous compression through a narrow range of pressure and molecular area, in N&PL, CLSE, and mixtures of PPL with 10% cholesterol, domains became highly distorted immediately prior to remixing. The characteristic transition in shape and abrupt termination of phase coexistence indicate that the remixing caused by the neutral lipids occurs at or close to a critical point.