Estimation Of Adhesive Strength Research Articles

Nanoscratch Testing of 3Al2O3·2SiO2 EBCs: Assessment of Induced Damage and Estimation of Adhesion Strength

In this study, the structural integrity of mullite (3Al2O3·2SiO2) films, deposited on silicon carbide (SiC) substrates using chemical vapor deposition (CVD), was investigated via increasing load nanoscratch tests. The films were configured by mullite columns of stoichiometric composition growing from a silica-rich layer in contact with the SiC substrate. Controlled damage was induced in the 3Al2O3·2SiO2 films at relatively low scratch loads. Radial and lateral cracking were applied until final delamination and repeated chipping were achieved as the load increased. The intrinsic integrity of the 3Al2O3∙2SiO2 film and the performance of the coated 3Al2O3·2SiO2/SiC system, regarded as a structural unit, were analyzed. With the aid of advanced characterization techniques at the surface and subsurface levels, the configuration and morphology of the damage induced in the coated system by the nanoscratch tests were characterized, and the scratch damage micromechanisms were identified. Finally, the adhesion of the film, in terms of energy of adhesion and interfacial fracture toughness, was determined using different models proposed in the literature. The results from this investigation contribute to the understanding of the mechanical performance and structural integrity of EBC/SiC-based systems, which over the past few years have increasingly been implemented in novel applications for gas turbines and aircraft engines.

Vesicle adhesion reveals novel universal relationships for biophysical characterization.

Adhesion plays an integral role in diverse biological functions ranging from cellular transport to tissue development. Estimation of adhesion strength, therefore, becomes important to gain biophysical insight into these phenomena. In this study, we use curvature elasticity to present non-intuitive, yet remarkably simple, universal relationships that capture vesicle-substrate interactions. These relationships not only provide efficient strategies to tease out adhesion energy of biological molecules but can also be used to characterize the physical properties of elastic biomimetic nanoparticles. We validate the modeling predictions with experimental data from two previous studies.

625 超音波の瞬時振動数によるヒートシールの接着力評価

625 超音波の瞬時振動数によるヒートシールの接着力評価

Determination of the interface strength between two polymer materials by a new curved interface tensile test: Preliminary experimental results

Recently, the authors have proposed a new experimental method for the determination of adhesion strength between two different materials. A curved interface and special arrangement of materials is used for the tensile test of bimaterial specimens to avoid singular stress fields around corners and edges. The main advantage of the test consists in the fact that the strength is determined under conditions of a uniform tensile stress field normal to the interface in the region where debonding starts. The present paper presents experimental results for two bimaterial systems - PMMA/TPE and PC/TPE (two stiff standard polymers with a thermoplastic elastomer). The expected failure behaviour was observed during the experiments, thus enabling the estimation of adhesion strength by using calculated stress concentration factors. The influence of the radius of curvature is discussed in detail.

塗膜の付着性 ＩＩ 接着強さの推定と接着条件の影響

塗膜の付着性 ＩＩ 接着強さの推定と接着条件の影響