Epoxy Resin-based Canal Sealer Research Articles

Hydroxyapatite-based cements induce different apatite formation in radicular dentin

ObjectiveTo investigate crystallinity and ultrastructure of the formed hydroxyapatite at radicular cervical and apical dentin after being treated with three different canal sealers. MethodsCervical and apical root dentin surfaces were treated with two experimental hydroxyapatite-based sealers, containing sodium hydroxide (calcypatite) or zinc oxide (oxipatite) and an epoxy resin-based canal sealer (AH Plus); gutta-percha without sealer was included as control. Dentin surfaces were studied by X-ray diffraction and transmission electron microscopy through selected area diffraction and bright-field imaging after 24h and 12m of storage. ResultsRoot cervical dentin treated with calcypatite and oxipatite produced poor crystallinity of new minerals, wide amorphous phase and non-stoichiometry. Reflections at the 002 plane and the corresponding diffraction rings attained lower values in the Scherrer equation and the Scherrer-Wilson equation in samples treated with both HAp-based sealers than in specimens without sealer or with AH Plus. At root cervical dentin treated with calcypatite, shorter and wider crystallite size formations and lower crystals grain size were found, if compared to those encountered at oxipatite treated dentin. Oxipatite attained improved crystallographic atomic order and less structural variation in both distances and angles. Apical dentin treated with oxipatite attained preferred grain orientation with polycrystalline lattices. SignificanceThe immature crystallites formed in dentin treated with calcypatite and oxipatite will account for high hydroxyapatite solubility and remineralizing activity. New polycrystalline formations encountered in apical dentin treated with oxipatite may also produce high mechanical performance.

The mineralizing effect of zinc oxide-modified hydroxyapatite-based sealer on radicular dentin.

The aim of this study was to evaluate the remineralization ability of three endodontic sealer materials at different root dentin regions. Cervical, medial, and apical root dentin surfaces were treated with two experimental hydroxyapatite-based cements, containing sodium hydroxide (calcypatite) or zinc oxide (oxipatite); an epoxy resin-based canal sealer, AH Plus; and gutta-percha. Remineralization, at the inner and outer zones of dentin disk surfaces, was studied by nanohardness (Hi) and Raman analysis. Nanoroughness and collagen fibrils width measurements were performed. Numerical data, at 24h or 12m, were analyzed by ANOVA and Student-Newman-Keuls (p < 0.05). At the outer and inner zones of the cervical dentin treated with oxipatite, the highest Hi after 12m of immersion was achieved. The same group showed the highest intensity of phosphate peak, markers for calcification and crystallinity. Nanoroughness was lower and fibril diameter was higher at the inner zone of the dentin treated with oxipatite. Dentin mineralization occurred in every region of the root dentin treated with oxipatite and calcypatite, especially at the inner zone of the dentin after 12m. Oxipatite reinforced the inner root zone at any third of the radicular dentin, by increasing both nanohardness and remineralization. When using calcypatite, the highest nanohardness was found at the apical third of the inner root dentin, but the lowest mechanical performance was obtained at the cervical and the medial thirds of the roots. Therefore, application of oxipatite as sealing cement of root canals is recommended. Oxipatite, when used as an endodontic sealing material, strengthens radicular dentin.