Effects Of Nanoparticle Properties Research Articles

A Review of the Antibacterial, Fungicidal and Antiviral Properties of Selenium Nanoparticles.

The resistance of microorganisms to antimicrobial drugs is an important problem worldwide. To solve this problem, active searches for antimicrobial components, approaches and therapies are being carried out. Selenium nanoparticles have high potential for antimicrobial activity. The relevance of their application is indisputable, which can be noted due to the significant increase in publications on the topic over the past decade. This review of research publications aims to provide the reader with up-to-date information on the antimicrobial properties of selenium nanoparticles, including susceptible microorganisms, the mechanisms of action of nanoparticles on bacteria and the effect of nanoparticle properties on their antimicrobial activity. This review describes the most complete information on the antiviral, antibacterial and antifungal effects of selenium nanoparticles.

Red blood cell-hitchhiking mediated pulmonary delivery of ivermectin: Effects of nanoparticle properties

Recent studies have demonstrated that ivermectin (IVM) exhibits antiviral activity against severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2), the causative virus of coronavirus disease 2019 (COVID-19). However, the repurposing of IVM for the treatment of COVID-19 has presented challenges primarily due to the low IVM plasma concentration after oral administration, which was well below IC50. Here, a red blood cell (RBC)-hitchhiking strategy was used for the targeted delivery of IVM-loaded nanoparticles (NPs) to the lung. IVM-loaded poly (lactic-co-glycolic acid) (PLGA) NPs (IVM-PNPs) and chitosan-coating IVM-PNPs (IVM-CSPNPs) were prepared and adsorbed onto RBCs. Both RBC-hitchhiked IVM-PNPs and IVM-CSPNPs could significantly enhance IVM delivery to lungs, improve IVM accumulation in lung tissue, inhibit the inflammatory responses and finally significantly alleviate the progression of acute lung injury. Specifically, the redistribution and circulation effects were related to the properties of NPs. RBC-hitchhiked cationic IVM-CSPNPs showed a longer circulation time, slower accumulation and elimination rates, and higher anti-inflammatory activities than RBC-hitchhiked anionic IVM-PNPs. Therefore, RBC-hitchhiking provides an alternative strategy to improve IVM pharmacokinetics and bioavailability for repurposing of IVM to treat COVID-19. Furthermore, according to different redistribution effects of different NPs, RBC-hitchhiked NPs may achieve various accumulation rates and circulation times for different requirements of drug delivery.

Revisiting stress-strain behavior and mechanical reinforcement of polymer nanocomposites from molecular dynamics simulations.

Through coarse-grained molecular dynamics simulations, the effects of nanoparticle properties, polymer-nanoparticle interactions, chain crosslinks and temperature on the stress-strain behavior and mechanical reinforcement of polymer nanocomposites (PNCs) are comprehensively investigated. By regulating the filler-polymer interaction (miscibility) in a wide range, an optimal dispersion state of nanoparticles is found at moderate interaction strength, while the mechanical properties of PNCs are improved monotonically with the increase of the particle-polymer interaction due to the tele-bridge structures of nanoparticles via polymer chains. Although smaller-sized fillers more easily build interconnected structures, the elastic moduli of PNCs at the percolation threshold concentration where a three-dimensional filler network forms are almost independent of nanoparticle size. Compared with spherical nanoparticles, anisotropic rod-like ones, especially with larger aspect ratio and rod stiffness, contribute exceptional reinforcement towards polymer materials. In addition, the elastic modulus with the strain, derived from the stress-strain curve, shows an analogous nonlinear behavior to the amplitude-dependence of the storage modulus (Payne effect). Such a behavior originates essentially from the failure/breakup of the microstructures contributing to the mechanical reinforcement, such as bound polymer layers around nanoparticles or nanoparticle networking structures. The Young's modulus as a function of the nanoparticle volume fraction greatly exceeds that predicted by the Einstein-Smallwood model and Guth-Gold model, which arises primarily from the contribution of the local/global filler network. The temperature dependence of the Young's modulus is further examined by mode coupling theory (MCT) and the Vogel-Fulcher-Tammann (VFT) equation, and the results indicate that the time-temperature superposition principle holds modestly above the critical temperature on the short-time (small-length) scale of elastic response. This work is expected to provide some guidance on controlling and improving the mechanical properties and nonlinear behavior of PNCs.

Heat transfer analysis of nanofluid based microchannel heat sink

Heat generation in miniature electronic devices is a limiting factor that often adversely affects device performance. One prominent remedy for this problem is to adopt nanofluid based microchannel heat sinks embedded with pin fins. The performance of these heat sinks depends on their geometry and coolant properties. Aside from these geometrical aspects, there is a dearth of studies on the effects of nanoparticle properties on heat transfer enhancement. In this study, the effects of nanoparticle properties on heat removal performance are modeled using a nanofluid two-component model. It is shown that the nanoparticle distribution plays important roles in heat transfer, and, unlike homogeneous nanofluid models, the flow patterns in the system follow the nanoparticle distribution. Moreover, it is found that the influence of nanoparticles on heat transfer depends both on the pin size and the flow regime. While there is a monotonic dependency between the nanoparticle effect and the pin size at small Reynolds numbers, this effect is non-monotonic at high Reynolds numbers. Nanofluid viscosity is also shown to have adverse effects on heat transfer improvement, and the effect is more detrimental as the inertial forces increase. The particle size and surface energy are also found to change the whole picture of heat removal process due to particle agglomeration and deposition. Therefore, based on the nanoparticle properties, a characteristic curve is introduced, using which, nanoparticles can safely improve heat transfer.

Understanding Acoustic Cavitation Initiation by Porous Nanoparticles: Toward Nanoscale Agents for Ultrasound Imaging and Therapy.

Ultrasound is widely applied in medical diagnosis and therapy due to its safety, high penetration depth, and low cost. In order to improve the contrast of sonographs and efficiency of the ultrasound therapy, echogenic gas bodies or droplets (with diameters from 200 nm to 10 µm) are often used, which are not very stable in the bloodstream and unable to penetrate into target tissues. Recently, it was demonstrated that nanobubbles stabilized by nanoparticles can nucleate ultrasound responsive microbubbles under reduced acoustic pressures, which is very promising for the development of nanoscale (<100 nm) ultrasound agents. However, there is still very little understanding about the effects of nanoparticle properties on the stabilization of nanobubbles and nucleation of acoustic cavitation by these nanobubbles. Here, a series of mesoporous silica nanoparticles with sizes around 100 nm but with different morphologies were synthesized to understand the effects of nanoparticle porosity, surface roughness, hydrophobicity, and hydrophilic surface modification on acoustic cavitation inception by porous nanoparticles. The chemical analyses of the nanoparticles showed that, while the nanoparticles were prepared using the same silica precursor (TEOS) and surfactant (CTAB), they revealed varying amounts of carbon impurities, hydroxyl content, and degrees of silica crosslinking. Carbon impurities or hydrophobic modification with methyl groups is found to be essential for nanobubble stabilization by mesoporous silica nanoparticles. The acoustic cavitation experiments in the presence of ethanol and/or bovine serum albumin (BSA) demonstrated that acoustic cavitation is predominantly nucleated by the nanobubbles stabilized at the nanoparticle surface not inside the mesopores. Finally, acoustic cavitation experiments with rough and smooth nanoparticles were suggested that a rough nanoparticle surface is needed to largely preserve surface nanobubbles after coating the surface with hydrophilic macromolecules, which is required for in vivo applications of nanoparticles.

A Method for Quantification of Penetration of Nanoparticles through Skin Layers Using Near-Infrared Optical Imaging

Our study presents a new method for tracking nanoparticle penetration through different layers of the skin using near-infrared dye-loaded nanoparticles (hydrodynamic diameter = 156 nm) and optical imaging. The dye-loaded nanoparticles were mixed in a topical skin cream, applied to human cadaver skin and incubated either for three or 24 h post-application, skin tissue was clipped between glass slides prior to imaging for signal intensity across the skin thickness using an optical imaging system. The data show that nanoparticles penetrate through all the layers of the skin but there is almost an exponential decay in the signal intensity from epidermis to dermis. Depending upon the incubation time, about 55%–59% of the total signal was seen in the epidermis and the remaining through dermis and hypodermis. The advantage of the method is that it allows quantitative analysis of the extent of penetration of nanoparticles through different layers of the skin without interference of any background signal from skin tissue, and without requiring extensive tissue processing. Our method could potentially be used to study the effect of nanoparticle properties and/or the use of different formulation additives on penetration of nanoparticles through different skin layers.

The effect of nanoparticle properties, detection method, delivery route and animal model on poly(lactic-co-glycolic) acid nanoparticles biodistribution in mice and rats

A review of poly(lactic-co-glycolic) acid (PLGA) nanoparticle (NP) biodistribution was conducted with the intent of identifying particle behavior for drug delivery applications. Databases such as Science Direct and Web of Science were used to locate papers on biodistribution of intravenous (i.v.) and orally delivered PLGA NPs in mice and rats. The papers included in the review were limited to those that report biodistribution data in terms of % dose particles/g tissue in the liver, kidney, spleen, lung, heart and brain. Noted trends involved particle behavior based on individual organ, particle size, animal model, type of indicator (entrapped versus covalently linked) and method of delivery (oral or i.v.). The liver showed the highest uptake of particles in mice, and the lung showed the highest uptake in rats. Minimal amounts of particles were detected in both the heart and brain of rats and mice. In rats, the concentration of particles approached 0% dose/g or decreased significantly over 24 h after administration of a single dose of particles. Higher concentrations of smaller particles were evident in the liver, kidney and spleen. Orally delivered drugs showed little to no uptake within the 24 h analysis when compared with i.v. delivered NPs. Differences in particle concentrations between rats and mice were also observed as expected when expressed as % dose/g organ. Particles with covalently linked indicators showed lower concentrations in tissues than particles with physically entrapped indicators. Further research on oral delivery of PLGA NPs as well as distribution beyond 24 h is needed to fully understand particle behavior in vivo for successful application of NPs in drug delivery.

Antibacterial activity of ZnO nanoparticles under ambient illumination — The effect of nanoparticle properties

ZnO nanomaterials exhibit prominent antibacterial activity even without UV illumination. Their antibacterial activity was attributed to different mechanisms, such as production of reactive oxygen species (ROS) and/or release of zinc ions in solution. Here we examined the relationship between the properties of eight different ZnO nanoparticles, their production of ROS, zinc ion release and antibacterial activity. We found that while the particles exhibited differences in antibacterial activity, there was no correlation with ROS production and zinc ion release. However, ROS production was inversely correlated with the concentration of nonradiative defects indicating that the recombination losses of photogenerated carriers can negatively affect ROS production.