Dialdehyde Glyoxal Research Articles

Revisiting the reaction of dicarbonyls in aerosol proxy solutions containing ammonia: the case of butenedial

Abstract. Reactions in aqueous solutions containing dicarbonyls (especially the α-dicarbonyls methylglyoxal, glyoxal, and biacetyl) and reduced nitrogen (NHx) have been studied extensively. It has been proposed that accretion reactions from dicarbonyls and NHx could be a source of particulate matter and brown carbon in the atmosphere and therefore have direct implications for human health and climate. Other dicarbonyls, such as the 1,4-unsaturated dialdehyde butenedial, are also produced from the atmospheric oxidation of volatile organic compounds, especially aromatics and furans, but their aqueous-phase reactions with NHx have not been characterized. In this work, we determine a pH-dependent mechanism of butenedial reactions in aqueous solutions with NHx that is compared to α-dicarbonyls, in particular the dialdehyde glyoxal. Similar to glyoxal, butenedial is strongly hydrated in aqueous solutions. Butenedial reaction with NHx also produces nitrogen-containing rings and leads to accretion reactions that form brown carbon. Despite glyoxal and butenedial both being dialdehydes, butenedial is observed to have three significant differences in its chemical behavior: (1) as previously shown, butenedial does not substantially form acetal oligomers, (2) the butenedial/OH− reaction leads to light-absorbing compounds, and (3) the butenedial/NHx reaction is fast and first order in the dialdehyde. Building off of a complementary study on butenedial gas-particle partitioning, we suggest that the behavior of other reactive dialdehydes and dicarbonyls may not always be adequately predicted by α-dicarbonyls, even though their dominant functionalities are closely related. The carbon skeleton (e.g., its hydrophobicity, length, and bond structure) also governs the fate and climate-relevant properties of dicarbonyls in the atmosphere. If other dicarbonyls behave like butenedial, their reaction with NHx could constitute a regional source of brown carbon to the atmosphere.

Glycolaldehyde is an endogenous source of lysine N-pyrrolation

Lysine N-pyrrolation converts lysine residues to Nϵ-pyrrole-l-lysine (pyrK) in a covalent modification reaction that significantly affects the chemical properties of proteins, causing them to mimic DNA. pyrK in proteins has been detected in vivo, indicating that pyrrolation occurs as an endogenous reaction. However, the source of pyrK remains unknown. In this study, on the basis of our observation in vitro that pyrK is present in oxidized low-density lipoprotein and in modified proteins with oxidized polyunsaturated fatty acids, we used LC-electrospray ionization-MS/MS coupled with a stable isotope dilution method to perform activity-guided separation of active molecules in oxidized lipids and identified glycolaldehyde (GA) as a pyrK source. The results from mechanistic experiments to study GA-mediated lysine N-pyrrolation suggested that the reactions might include GA oxidation, generating the dialdehyde glyoxal, followed by condensation reactions of lysine amino groups with GA and glyoxal. We also studied the functional significance of GA-mediated lysine N-pyrrolation in proteins and found that GA-modified proteins are recognized by apolipoprotein E, a binding target of pyrrolated proteins. Moreover, GA-modified proteins triggered an immune response to pyrrolated proteins, and monoclonal antibodies generated from mice immunized with GA-modified proteins specifically recognized pyrrolated proteins. These findings reveal that GA is an endogenous source of DNA-mimicking pyrrolated proteins and may provide mechanistic insights relevant for innate and autoimmune responses associated with glucose metabolism and oxidative stress.

Glyoxal as an alternative fixative to formaldehyde in immunostaining and super‐resolution microscopy

Paraformaldehyde (PFA) is the most commonly used fixative for immunostaining of cells, but has been associated with various problems, ranging from loss of antigenicity to changes in morphology during fixation. We show here that the small dialdehyde glyoxal can successfully replace PFA. Despite being less toxic than PFA, and, as most aldehydes, likely usable as a fixative, glyoxal has not yet been systematically tried in modern fluorescence microscopy. Here, we tested and optimized glyoxal fixation and surprisingly found it to be more efficient than PFA‐based protocols. Glyoxal acted faster than PFA, cross‐linked proteins more effectively, and improved the preservation of cellular morphology. We validated glyoxal fixation in multiple laboratories against different PFA‐based protocols and confirmed that it enabled better immunostainings for a majority of the targets. Our data therefore support that glyoxal can be a valuable alternative to PFA for immunostaining.

Acid-free glyoxal as a substitute of formalin for structural and molecular preservation in tissue samples.

Tissue fixation in phosphate buffered formalin (PBF) remains the standard procedure in histopathology, since it results in an optimal structural, antigenic and molecular preservation that justifies the pivotal role presently played by diagnoses on PBF-fixed tissues in precision medicine. However, toxicity of formaldehyde causes an environmental concern and may demand substitution of this reagent. Having observed that the reported drawbacks of commercially available glyoxal substitutes of PBF (Prefer, Glyo-fix, Histo-Fix, Histo-CHOICE, and Safe-Fix II) are likely related to their acidity, we have devised a neutral fixative, obtained by removing acids from the dialdehyde glyoxal with an ion-exchange resin. The resulting glyoxal acid-free (GAF) fixative has been tested in a cohort of 30 specimens including colon (N = 25) and stomach (N = 5) cancers. Our results show that GAF fixation produces a tissue and cellular preservation similar to that produced by PBF. Comparable immuno-histochemical and molecular (DNA and RNA) analytical data were obtained. We observed a significant enrichment of longer DNA fragment size in GAF-fixed compared to PBF-fixed samples. Adoption of GAF as a non-toxic histological fixative of choice would require a process of validation, but the present data suggest that it represents a reliable candidate.

Matrix composition regulates three-dimensional network formation by endothelial cells and mesenchymal stem cells in collagen/fibrin materials

Co-cultures of endothelial cells (EC) and mesenchymal stem cells (MSC) in three-dimensional (3D) protein hydrogels can be used to recapitulate aspects of vasculogenesis in vitro. MSC provide paracrine signals that stimulate EC to form vessel-like structures, which mature as the MSC transition to the role of mural cells. In this study, vessel-like network formation was studied using 3D collagen/fibrin (COL/FIB) matrices seeded with embedded EC and MSC and cultured for 7days. The EC:MSC ratio was varied from 5:1, 3:2, 1:1, 2:3 and 1:5. The matrix composition was varied at COL/FIB compositions of 100/0 (pure COL), 60/40, 50/50, 40/60 and 0/100 (pure FIB). Vasculogenesis was markedly decreased in the highest EC:MSC ratio, relative to the other cell ratios. Network formation increased with increasing fibrin content in composite materials, although the 40/60 COL/FIB and pure fibrin materials exhibited the same degree of vasculogenesis. EC and MSC were co-localized in vessel-like structures after 7days and total cell number increased by approximately 70%. Mechanical property measurements showed an inverse correlation between matrix stiffness and network formation. The effect of matrix stiffness was further investigated using gels made with varying total protein content and by crosslinking the matrix using the dialdehyde glyoxal. This systematic series of studies demonstrates that matrix composition regulates vasculogenesis in 3D protein hydrogels, and further suggests that this effect may be caused by matrix mechanical properties. These findings have relevance to the study of neovessel formation and the development of strategies to promote vascularization in transplanted tissues.

Activation of Benznidazole by Trypanosomal Type I Nitroreductases Results in Glyoxal Formation

Benznidazole, a 2-nitroimidazole, is the front-line treatment used against American trypanosomiasis, a parasitic infection caused by Trypanosoma cruzi. Despite nearly 40 years of use, the trypanocidal activity of this prodrug is not fully understood. It has been proposed that benznidazole activation leads to the formation of reductive metabolites that can cause a series of deleterious effects, including DNA damage and thiol depletion. Here, we show that the key step in benznidazole activation involves an NADH-dependent trypanosomal type I nitroreductase. This catalyzes an oxygen-insensitive reaction with the interaction of enzyme, reductant, and prodrug occurring through a ping-pong mechanism. Liquid chromatography/mass spectrometry (LC/MS) analysis of the resultant metabolites identified 4,5-dihydro-4,5-dihydroxyimidazole as the major product of a reductive pathway proceeding through hydroxylamine and hydroxy intermediates. The breakdown of this product released the reactive dialdehyde glyoxal, which, in the presence of guanosine, generated guanosine-glyoxal adducts. These experiments indicate that the reduction of benznidazole by type I nitroreductase activity leads to the formation of highly reactive metabolites and that the expression of this enzyme is key to the trypanocidal properties displayed by the prodrug.

Determination of the dialdehyde glyoxal in workroom air—development of personal sampling methodology

The dialdehyde glyoxal (ethanedial) is an increasingly used industrial chemical with potential occupational health risks. This study describes the development of a personal sampling methodology for the determination of glyoxal in workroom air. Among the compounds evaluated as derivatizing agents; N-methyl-4-hydrazino-7-nitrobenzofurazan (MNBDH), 1,2-phenylenediamine (OPDA), 1-dimethylaminonaphthalene-5-sulfonylhydrazine (dansylhydrazine, DNSH) and 2,4-dinitrophenylhydrazine (DNPH), DNPH was the only reagent that was suitable. Several different samplers were evaluated for sampling efficiency of glyoxal in workroom air using DNPH as derivatizing agent; in-house DNPH coated silica particles packed in two different types of glass tubes, impingers containing acidified DNPH solution, filter cassettes containing glass fibre filters coated with DNPH, a commercially available solid phase cartridge sampler originally developed for formaldehyde sampling (Waters Sep-Pak DNPH-silica cartridge), and the commercially available SKC UMEx 100 passive sampler originally developed for formaldehyde sampling. Aldehyde atmospheres for sampler evaluation were generated with an in-house made vapour atmosphere generator coupled to a sampling unit, with the possibility of parallel sampling. The resulting glyoxal-DNPH derivative was determined using both LC-UV and LC-APCI-MS with negative ionization. By far, the highest recovery of glyoxal was obtained employing one of the in-house DNPH coated silica samplers (93%, RSD = 3.6%, n = 12).

Formation and Removal of Aldehydes in Plants That Use Ozonation

Recently developed analytical techniques allow for the quantification of C1‐C1O straight‐chain aliphatic aldehydes, benzaldehyde, and the dialdehydes glyoxal and methylglyoxal down to 1 μg/L. These compounds are formed as the partial oxidation products of the reaction between disinfectants (particularly ozone) and naturally occurring organic matter. Various full‐scale and pilot treatment plants in North America that employ ozonation were surveyed using these techniques, which showed a trend toward both monoaldehyde and dialdehyde formation. Once formed, aldehydes can persist in the water and their concentrations may even increase following postdisinfection. An effective means of aldehyde removal appears to be the use of biologically active granular activated carbon filters, whose filtration mode determines the actual degree of removal. Dialdehydes require a slower filtration rate for their removal than formaldehyde and acetaldehyde.

Formaldehyde, glyoxal, urethane, methyl carbamate, 2,3-butanedione, 2,3-hexanedione, ethyl acrylate, dibromoacetonitrile and 2-hydroxypropionitrile induce chromosome loss in Saccharomyces cerevisiae

Induction of mitotic chromosome loss could be demonstrated for the dialdehyde glyoxal, the diketones 2,3-butanedione and 2,3-hexanedione, ethyl and methyl carbamate, ethyl acrylate, dibromoacetonitrile, 2-hydroxypropionitrile and formaldehyde, but only when they were combined with subacute concentrations of propionitrile, which is a strong inducer of chromosomal malsegregation. The same chemicals did not induced mitotic chromosome loss when applied in pure form. However, glyoxal, ethyl acrylate, dibromoacetonitrile and formaldehyde when applied in pure form also induced mitotic recombination. Respiratory deficiency was induced, in the absence of propionitrile, by these recombinogenic agents and also by 2,3-hexanedione and 2-hydroxypropionitrile which are not recombinogenic.

Dialdehydes as Cotton Cellulose Cross-Linkers1

Formaldehyde, when applied with acid catalysis, is the most effective cellulose cross linker available in that it produces the most crushproofing on a weight basis. However, formalization is accompanied by high strength loss in cotton. It has been postulated that the unfavorable crease recovery-strength relationship with formaldehyde is a function of the shortness of the acetal cross-link. It has also been postulated, naively, that longer cross-links could be derived from long chain dialdehydes, the crease recovery-strength relationship improving with increasing chain length. Work with the dialdehydes glyoxal (C2). glutaraldehyde (C5). and α-hydroxy adipaldehyde (C6) yielded crease recovery-strength relationships similar, if not identical. to formaldehyde. This tinding is consistent with the known chemistry of the formalde hyde-cellulose reaction in that the acetal linkage controls the length of the cross-link.