To fully evaluate the influence of the rough surface (σ) and speed (ω) of the crankpin bearing on the engine power, a combination model of the slider crank mechanism and crankpin bearing’s lubrication is established to calculate the mathematical equations for the simulation. Three indexes of the bearing-capacity (W), friction-force (F), and friction-coeficient (μ) are used to evaluate the influence of the change of the crankpin bearing’s speed and rough surface on the engine’s power. The study shows that increasing ω not only effectively reduces the load capacity of the crankpin bearing but also increases the F and μ in the engine’s crankpin bearing, thereby directly reducing the engine’s power. Besides, the reduction of ω also reduces the bearing-capacity of the crankpin bearing. To optimize the engine’s power, the engine’s speed should be maintained at 2000 r/min to improve the engine’s power. In addition, under the effect of the rough surface of the crankpin bearing, the W of the crankpin bearing is insignificantly affected by the change of the rough surface while both the F and μ are greatly affected. In particular, the maximum F at σ = 8 μm and σ = 10 μm is increased by 68.3 % and 77.7 % in comparison with the maximum F at minimum value of σ = 2 μm, respectively. Therefore, in the design of the engine, the rough surface of the crankpin bearing should be reduced to improve the engine’s power. Additionally, the design parameters of the crankpin bearings should also be optimized to further improve the engine’s power.