CO2 Flooding In Reservoirs Research Articles

Influencing factors and application prospects of CO2 flooding in heterogeneous glutenite reservoirs

In recent years, large amounts of CO2 emissions have led to many environmental problems. Developing a reasonable approach to carbon dioxide emissions is one of the most important issues for the sustainable development of human civilization. Compared with CO2 geological storage, CO2 flooding has greater advantages and a higher utilization efficiency. CO2 flooding technology has been successfully applied to many types of reservoirs, such as conventional sandstone reservoirs, low-permeability reservoirs, and carbonates. In this paper, the feasibility of CO2 flooding in glutenite reservoirs is studied. First, the glutenite reservoir is divided into fine stages, and reasonable vertical development units are determined. On this basis, the distribution scale, genetic environment and formation mode of the glutenite reservoir are characterized in detail and their spatial distribution rules are depicted in three dimensions. Then, the influencing factors of CO2 flooding in the glutenite reservoir are analysed via reservoir numerical simulation technology. The effects of reservoir thickness, reservoir heterogeneity, macropores, dominant channels and fracturing on CO2 flooding efficiency are evaluated individually, and a set of reasonable parameters constituting an evaluation system for CO2 flooding in the glutenite reservoir is established. Finally, based on parameter optimization, the disadvantaged conditions of CO2 flooding in glutenite reservoirs are optimized, and their effects are gradually eliminated. In view of the characteristics of glutenite reservoirs, a unique three-dimensional well pattern arrangement is designed, different injection modes are optimized, and suitable injection agents are tested. These methods are conducive to improving the effect of reservoir parameters on CO2 flooding efficiency, allowing these reservoirs to be used for CO2 flooding. Based on these new methods, the displacement effect of the Yanjia-Yongan glutenite reservoir is predicted. Our results show that the reservoir has been developed efficiently and achieved a high recovery rate, the displacement front of the CO2 has become more uniform, and the sweep range has become wider. After extending the successful application of CO2 flooding in this reservoir to all of the glutenite reservoirs in the entirety of the Bohaiwan Basin, we predict that the oil recovery rate may reach 40%, with a cumulative oil recovery rate of approximately 3.04 × 108 t and a total CO2 consumption of 1.672 × 108 t. Thus, the proposed approach not only can improve the atmospheric environment but can also greatly improve the efficiency of oil displacement.

An Investigation of CO2-Responsive Preformed Particle Gel for Conformance Control of CO2 Flooding in Reservoirs With Fractures or Fracture-Like Channels

Summary Gel treatment is an important technique to solve early CO2 breakthrough and excess–CO2–production problems, caused by the low viscosity and low density of CO2, as well as the heterogeneity of reservoirs with fractures or fracture–like channels. However, there is no reported work on gel that increases its volume after reacting with CO2 (termed CO2–responsive gel) for the conformance control of CO2 flooding. In this paper, the intrinsic properties of a CO2–responsive preformed particle gel (CR–PPG) were evaluated in a water/supercritical–CO2 (scCO2) environment in high–pressure vessels. Continuous scCO2 injection and CR–PPG treatment were conducted in fractured sandstone cores, to probe their plugging performance to scCO2 flow in a high–permeability–contrast system. The volumetric swelling ratio (VSR) of the CR–PPG increased by approximately two times in the presence of scCO2, compared with a sample under similar conditions in the absence of scCO2. The CR–PPG swelling ratio decreased with increasing NaCl concentration. Under the same conditions, the temperature did not have an apparent effect on the swelling ratio after 31 days of swelling. In coreflooding experiments, the placed CR–PPG resisted a considerable pressure up to 617.0 psi before breakthrough. After a shut–in process, CO2–breakthrough pressure was detected at 437.2 psi. It is observed that the shut–in process improved the plugging performance of CR–PPG to CO2 as revealed by the increase in the residual resistance factor. Controlling the shut–in time was found to be effective in augmenting the increase in the residual resistance factor, by increasing the VSR of placed CR–PPG. Resistance of CR–PPG to some real field challenges, including a high pressure gradient and long–term exposure to CO2, was also reported for field–applicability concerns.

Properties of CO2Foam Stabilized by Hydrophilic Nanoparticles and Nonionic Surfactants

Nanoparticles can improve the stability of CO2 foam and increase oil recovery during CO2 flooding in reservoirs. However, there are few reports in the literature concerning the synergistic effects ...

Properties of Carbon Dioxide Foam Stabilized by Hydrophilic Nanoparticles and Hexadecyltrimethylammonium Bromide

Nanoparticles can improve the stability of CO2 foam and increase oil recovery during CO2 flooding in reservoirs. The synergistic effect of hydrophilic SiO2 nanoparticles and hexadecyltrimethylammonium bromide (CTAB) on CO2 foam stability was examined in this study. Experimental results show that the synergistic effect requires a CTAB/SiO2 concentration ratio of 0.02–0.07, with 0.033 representing the best concentration ratio. With the increase in the concentration ratio, the synergistic stabilization effect of CTAB/SiO2 dispersion first increases and then decreases. In the monolayer adsorption stage (concentration ratio from 0.02 to 0.033), when the hydrophobicity of SiO2 nanoparticles increases with the concentration ratio, the nanoparticles tend to adsorb on the gas–liquid interface and the stability of CO2 foam increases. In the double-layer adsorption stage (concentration from 0.033 to 0.07), when the hydrophobicity of SiO2 nanoparticles decreases with an increase in the concentration ratio, the nanopa...