Chiral MnIII Research Articles

Chiral MnIII (Salen) Immobilized on Organic Polymer/Inorganic Zirconium Hydrogen Phosphate Functionalized with 3-Aminopropyltrimethoxysilane as an Efficient and Recyclable Catalyst for Enantioselective Epoxidation of Styrene.

Organic polymers/inorganic zirconium hydrogen phosphate (ZSPP, ZPS-IPPA, and ZPS-PVPA) functionalized with 3-aminopropyltrimethoxysilane were prepared and used to support chiral MnIII (salen) complexes (Jacobsen’s catalyst). Different characterization methods demonstrated that the chiral MnIII (salen) complexes was successfully supported on the surface of the carrier (ZSPP, ZPS-IPPA, or ZPS-PVPA) through a 3-aminopropyltrimethoxysilane group spacer. The supported catalysts effectively catalyzed epoxidation of styrene with m-chloroperbenzoic acid (m-CPBA) as an oxidant in the presence of N-methylmorpholine N-oxide (NMO) as an axial base. These results (ee%, 53.3–63.9) were significantly better than those achieved under a homogeneous counterpart (ee%, 46.2). Moreover, it is obvious that there was no significant decrease in catalytic activity after the catalyst 3 was recycled four times (cons%: from 95.0 to 92.6; ee%: from 64.7 to 60.1). Further recycles of catalyst 3 resulted in poor conversions, although the enantioselectivity obtained was still higher than that of corresponding homogeneous catalyst even after eight times. After the end of the eighth reaction, the solid catalyst was allowed to stand in 2 mol/L of dilute hydrochloric acid overnight, prompting an unexpected discovery that the catalytic activity of the catalyst was recovered again at the 9th and 10th cycles of the catalyst.

Synthesis, Crystal Structure and Magnetic Properties of [Mn((1R, 2R)‐Salcy)N3/NCS] Complexes: Solvent Dependent Crystallization of Monomers, Chains and Dimers.

AbstractFive new chiral MnIII complexes [Mn((1R, 2R)‐Salcy)N3]∞⋅CH3CN (1), [Mn((R,R)‐Salcy)N3]∞ (2), [Mn((R,R)‐Salcy)N3] (4), [Mn((R,R)‐Salcy)(H2O)N3]⋅C4H8O (5) and [Mn((R,R)‐Salcy)NCS] (6) have been synthesized and characterized by X‐ray structural analysis and magnetic measurements (Salcy=N,N′‐bis(salicylidene)‐1,2‐diaminocyclohexane}. The four azido complexes have been obtained from the previously known [Mn((R,R)‐Salcy)(CH3OH)N3] (3) by crystallization from various solvents. Compounds 1 and 2 are trans‐μ‐1,3‐azide bridged coordination polymers. While 1 forms helical chains, the chain in 2 is formed via translation of a dimeric helicate repeat unit. Compound 3 is a methanol coordinated mononuclear azido complex which forms a 2D‐network through H‐bonding. Compounds 4 and 6 are phenoxo‐bridged dimers without inversion center. Compound 5 is an aqua coordinated mononuclear azido complex, which forms a 1D‐chain through O−H⋅⋅⋅N hydrogen bonding involving axial ligands. In all six compounds MnIII exhibits a characteristic Jahn−Teller elongation. The magnetic coupling in 1 and 2 leads to antiferromagnetic interaction along the chain (2 J=−11.6 cm−1 for 1 and –11.9 cm−1 for 2) through the μ‐1,3‐azide bridge. Compound 3 is weakly antiferromagnetic due to hydrogen bonding interactions in the lattice. The phenoxo dimers (4 and 6) do not have measurable exchange interaction, the low temperature susceptibility being influenced mainly by zero‐field splitting.

Chiral MnIII (Salen) Covalently Bonded on Modified ZPS-PVPA and ZPS-IPPA as Efficient Catalysts for Enantioselective Epoxidation of Unfunctionalized Olefins.

Chiral MnIII (salen) complex supported on modified ZPS-PVPA (zirconium poly(styrene-phenylvinylphosphonate)) and ZPS-IPPA (zirconium poly(styrene-isopropenyl phosphonate)) were prepared using –CH2Cl as a reactive surface modifier by a covalent grafting method. The supported catalysts showed higher chiral induction (ee: 72%–83%) compared with the corresponding homogeneous catalyst (ee: 54%) for asymmetric epoxidation of α-methylstrene in the presence of 4-phenylpyridine N-oxide (PPNO) as axial base using NaClO as an oxidant. ZPS-PVPA-based catalyst 1, with a larger pore diameter and surface area, was found to be more active than ZPS-IPPA-based catalyst 2. In addition, bulkier alkene-like indene, was efficiently epoxidized with these supported catalysts (ee: 96%–99%), the results were much higher than those for the homogeneous system (ee: 65%). Moreover, the prepared catalysts were relatively stable and can be recycled at least eight times without significant loss of activity and enantioselectivity.

Chiral heterobimetallic chains from a dicyanideferrite building block including a π-conjugated TTF annulated ligand.

The π-conjugated tetrathiafulvalene (TTF) annulated ligand was introduced into a dicyanometallate for the first time, leading to the synthesis of the versatile redox-active dicyanideferrite building block [(n-Bu)4N][Fe(TTFbp)(CN)2] (H2TTFbp = N-(2-(4,5-bis(methylthio)-1,3-dithiol-2-ylidene)-5-(picolinamido) benzo[d][1,3]dithiol-6-yl) picol inamide). The incorporation of the new precursor with chiral MnIII Schiff-base complexes resulted in two enantiopure one-dimensional complexes, [Mn((R,R)-salphen)Fe(TTFbp)(CN)2]n (2-(RR)) and [Mn((S,S)-salphen)Fe(TTFbp)(CN)2]n (2-(SS)) (Salphen = N,N'-1,2-diphenylethylene-bis(salicylideneiminato) dianion), which were synthesized and structurally characterized. Circular dichroism (CD) and vibrational circular dichroism (VCD) spectra confirmed the enantiomeric nature of the optically active complexes, and structural analyses revealed the formation of neutral cyanide-bridged double chains in 2-(RR) and 2-(SS). Solution and solid state CV studies revealed the redox-active characteristics of the complexes. Antiferromagnetic couplings were detected between FeIII and MnIII centers within a chain, and a field-induced magnetic phase transition was observed (TN = 4.8 K). The introduction of electroactivity and chirality into cyanide-bridged complexes with interesting magnetic properties leads the way towards new multifunctional materials.

Enantioselective Epoxidation of Styrene by Manganese Chiral Schiff Base Complexes Immobilized on MCM-41.

Two chiral MnIII complexes synthesized and characterized by single-crystal X-ray diffraction were grafted onto mesoporous silica MCM-41. The MCM-41-immobilized solid chiral catalysts were characterized by various spectrochemical and physicochemical methods (XRD, FTIR, 29 Si NMR, TGA, UV/Vis/DRS, EPR, cyclic voltammetry, SEM, BET). Both the homogeneous and heterogeneous MnIII chiral complexes are found to be effective catalysts for epoxidation of styrene. MCM-41-supported chiral catalysts are found to retain their catalytic activity up to five cycles. When an ionic liquid was implemented to enhance the catalytic recyclability of the homogeneous catalysts, they can be recycled up to three times. However, after the third cycle the catalytic activities of the complexes were found to decrease due to rupturing of the chiral catalyst.

Chiral MnIII(Salen) supported on tunable phenoxyl group modified zirconium poly (styrene-phenylvinylphosphonate)-phosphate as an efficient catalyst for epoxidation of unfunctionalized olefins

We have developed a series of chiral MnIII(Salen) (chiral Jacobsen's catalyst) catalysts that were axially supported onto zirconium poly(styrene-phenylvinylphosphonate)-phosphate through tunable phenoxyl linkers of varying steric hindrance, and evaluated their performance as catalysts (Cat1–Cat3) for the epoxidation of unfunctionalized olefins using m-chloroperbenzoic acid as an oxidant. The corresponding non-supported analogues (Cat4–Cat6) were also prepared and tested under similar conditions. The results demonstrated that the incorporation of substituents at the ortho-positions of the tunable phenoxyl linkers had a critical effect on the catalytic activity. Furthermore, the enantioselectivity increased as the steric hindrance imposed by the linker increased, although this also led to a decrease in the conversions under the same reaction conditions, especially for heterogeneous epoxidation. The heterogeneous system also displayed high ee values and conversions in the absence of the axial additive N-methylmorpholine N-oxide, which is commonly required to improve the catalytic activity of epoxidation reactions, especially for the epoxidation of α-methylstyrene. The reusability of the catalyst was also evaluated over 11 catalytic cycles, with no significant reduction observed in the catalytic activity or enantioselectivity after five runs.

Recoverable MnIII(salen) supported on diamine modified zirconium poly(styrene-isopropenyl phosphonate)-phosphate as an efficient catalyst for epoxidation of unfunctionalized olefins

Chiral MnIII(salen) (Jacobsen’s catalyst) was axially immobilized onto a new type of organic polymer-inorganic hybrid material-zirconium poly(styrene-isopropenyl phosphonate)-phosphate(ZPS-IPPA) with different linkage lengths and evaluated as catalysts for the epoxidation of unfunctionalized olefins. The results demonstrated that the prepared catalysts exhibited moderate to good activity and enantioselectivity in the asymmetric epoxidation of unfunctionalized olefins. Furthermore, the immobilized catalysts were relatively stable and could be conveniently separated from the reaction system by simple precipitation in hexane. Moreover, higher enantioselectivity was obtained with catalyst 2c than that of homogeneous counterpart catalyzed even after eight times. The excellent recycling of the catalyst was attributed to its structure feature of ZPS-IPPA which is different from either pure polystyrene or pure zirconium phosphates.

Remarkable matrix effect in polymer-supported Jacobsen’s alkene epoxidation catalysts

Adaptation of the polymer matrix has allowed high enantioselectivity to be achieved for the first time with a polymer-supported chiral MnIII(salen) alkene epoxidation catalyst.