Carrier Photodiode Research Articles

D-Band MUTC Photodiodes With Flat Frequency Response

Novel back-illuminated modified uni-traveling- carrier photodiodes (MUTC-PDs) are reported to demonstrate wide bandwidth and high output power performance at D-band (110–170 GHz) regime. A comprehensive design model is employed to predict and tune the frequency response by incorporating coplanar waveguides (CPWs) with different inductive peaking effects. As a demonstration, 4.5-μm-diameter photodiodes with two types of CPWs are fabricated to exhibit different frequency response profiles. Both PDs exhibit a 3-dB bandwidth over 150 GHz and the measured frequency responses are in excellent agreement with simulations. Thanks to the proper design of the CPW electrodes, the two PDs exhibit an output power roll-off of only 4.3 dB and 4.8 dB from dc to 170 GHz, respectively, and high saturation performance is maintained over the broadband frequency range of 130–170 GHz.

Characterizing and Modeling Nonlinear Intermodulation Distortions in Modified Uni-Traveling Carrier Photodiodes

We present a physics-based model for nonlinear analysis of InGaAs/InP modified uni-traveling carrier (MUTC) photodiodes. At low frequencies (<;3 GHz), the Franz-Keldysh effect has been identified as the primary nonlinear mechanism in these MUTC photodiodes. The output third-order intercept point (OIP3) is used as a figure of merit for characterizing the nonlinear intermodulation distortion. The OIP3 behavior of the photodiode simulated using this model agrees well with measurements.

40-Gb/s Widely Tunable Transceivers

We present the first monolithic widely tunable 40-Gb/s transceivers. The devices integrate sampled grating distributed Bragg reflector (SG-DBR) lasers, quantum-well electroabsorption modulators (EAM), low-confinement semiconductor optical amplifiers (SOA), and uni-traveling carrier (UTC) photodiodes for state-of-the-art light generation, modulation, amplification, and detection. A relatively simple high-flexibility fabrication scheme combining quantum-well intermixing (QWI) and blanket metal-organic chemical vapor deposition (MOCVD) regrowth was used to integrate components with performance rivaling optimized discrete devices. The SG-DBR/EAM transmitters demonstrate 30 nm of tuning, 39-GHz bandwidth, low-drive voltage, and low power penalty 40-Gb/s transmission through 2.3 km of fiber. The SOA/UTC photodetector receivers provide 23-28 dB of gain, saturation powers up to 18.6 dBm, and -20.2 dBm of chip-coupled sensitivity at 40 Gb/s. By connecting the transmitters and receivers off-chip, we demonstrate 40-Gb/s wavelength conversion

Design and Demonstration of Novel QW Intermixing Scheme for the Integration of UTC-Type Photodiodes With QW-Based Components

We present the design and demonstration of unitraveling carrier (UTC) photodiodes fabricated using a novel quantum-well (QW) intermixing and metal-organic chemical vapor deposition (MOCVD) regrowth fabrication platform. The photodiodes discussed here were realized on the same chip as high gain centered QW active regions, intermixed passive centered well waveguides, and low optical confinement offset QW active regions regrown over intermixed wells. This demonstration lifts previous constraints imposed on high functionality photonic circuits, which forced a common waveguide architecture in the detector, laser, and amplifier by validating a platform suited for the monolithic integration of UTC photodiodes into photonic integrated circuits comprised of widely tunable high gain laser diodes, high efficiency modulators, and low optical confinement high saturation power semiconductor optical amplifiers. In this manuscript we focus on the design and performance of UTC photodiodes fabricated on intermixed QWs using this novel scheme. The photodiodes exhibit /spl sim/90% internal quantum efficiency, excellent photocurrent handling capabilities, and minimal response roll-off over the 20 GHz of our testing capability. The 40 Gb/s operation was achieved with the demonstration of open eye diagrams.