Widespread per- and poly-fluoroalkyl substances (PFAS) contamination in water, sediments and soils has driven demand for scalable and cost-effective treatments suitable for application across a range of ∑PFAS concentrations from ng/L to mg/L. One promising class of treatment technology is based on PFAS accumulation at the surface of air bubbles. In this study, hydrodynamic cavitation induced by high shear mixing generated colloidal gas aphrons (CGAs) made of different surfactants (cationic, anionic and non-ionic) to facilitate separation of PFAS differing in carbon–fluorine chain length, head group and charge. Separation efficiency was evaluated for a 600 µg/L ∑PFAS mixture of 6 PFAS each at 100 µg/L, and also for a solution spiked to 1 mg/L ∑PFAS with an aqueous film forming foam (AFFF) mixture. The choice of surfactant produced CGAs with different bubble sizes and surface properties; the non-ionic surfactant produced significantly smaller bubbles, while the cationic and anionic surfactant varied principally by charge. The ∑PFAS separation efficiency varied from < 30 % to 86 % using different surfactants after a 30 s process. The non-ionic surfactant was most effective overall, and the cationic surfactant was most efficient for short-chain PFAS, and those with the carboxylic head group due to surface charge compatibility. Zwitterionic precursor PFAS and perfluoroalkyl sulfonic acids species tested in this study were removed with > 90 % efficiency when anionic and non-ionic surfactants formed the CGAs, while short-chain perfluoroalkyl acids PFAA were removed similarly effectively by cationic surfactant-derived CGAs. While separation efficiencies were lower than the > 95 % ∑PFAS reductions reported elsewhere, the effect was achieved with a treatment time of 30 s, in contrast to the significantly longer treatment cycles applied in other studies.