Ring-opening Polymerization Of Carbonate Research Articles

Azidopyrazole as Initiator for Ethylene Carbonate Ring Opening Polymerization

A green approach for ethylene carbonate ring opening polymerization was proposed via an interaction between ethylene carbonate and 5-azido-3-methyl-1-phenyl-1H-pyrazole-4-carbaldehyde (azidopyrazole) in presence of FeCl3 anhydrous as initiator. Despite the high thermodynamic stability of ethylene carbonate, reducing consumption of heat and time has been obtained. The effect of the molar ratio of azidopyrazole to ethylene carbonate has been studied and the resulted products were characterized.

Guanidinium as bifunctional organocatalyst for ring-opening polymerizations

Typical organocatalyst promoted ring-opening polymerization (ROP) by activation of monomer or polymer chain end via the acidic or basic mechanism. Dual activating of both the monomer and the propagating polymer chain end suggested an ideal strategy of widely tuneable catalysis of high efficiency. Stoichiometric Brønsted acid–base adduct was rarely employed in ROPs since general Brønsted acid and Brønsted base quench each other. We proposed that an acid–base adduct may work bifunctionally in catalysis. The cationic part of the acid–base adduct as H-bond donor activated the monomer, and the counter anion part as H-bond acceptor activated initiator/chain end. A series of guanidiniums, derived from commercially available Brønsted acids and guanidine, were employed as catalysts in ROPs of carbonate, lactide, and lactone. Guanidinium triazabicyclodecene hydrochloride exhibited outstanding catalytic performances in the respect of the rate and controlled in the ROPs of l-lactide, trimethylene carbonate, and δ-valerolactone with nearly full conversions, predicted molecular weights, as well as narrow dispersity of Đ = 1.07. These experimental results indicated that guanidinium is an efficient organocatalyst in controlled/living ring-opening polymerization.

Less toxic acetylacetonates as initiators of trimethylene carbonate and 2,2‐dimethyltrimethylene carbonate ring opening polymerization

AbstractThis article presents the results of TMC and DMC polymerization with the use of acetylacetonates of low‐toxic metals: iron, zinc, and zirconium. Zinc (II) acetylacetonate proves to be a very good initiator of homopolymerization. The reaction carried out with the use of this initiator at 110 °C is very rapid and of high yield. Using both zinc and iron (III) acetylacetonates, as well as the zirconium (IV) one, in high temperatures it is possible to obtain PTMC possessing high molecular mass, thus ensuring optimization of the relation between the duration of the polymerization and its yield. A strong influence of thermal degradation on the course of the reaction has been observed, particularly at 160 °C, with the use of Fe(acac)3 as the initiator. DMC polymerization proceeds much more slowly when initiated by iron and zinc acetylacetonates. A high conversion of the monomer is obtained in this case as well. The relation between the molecular mass of the obtained PDMC and the conversion of the monomer is directly proportional; however, those masses, determined on the basis of polystyrene standards, are much lower than those estimated theoretically. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 43: 1913–1922, 2005