Beam Waveguide Research Articles

Coherent propagation of high-power wave beams in hollow gas-filled daisy-shaped waveguides

Coherent propagation of high-power wave beams in hollow gas-filled daisy-shaped waveguides

Dynamic response characteristics and linearization of liquid crystal cladding waveguide beam scanner

Dynamic response characteristics and linearization of liquid crystal cladding waveguide beam scanner

1 × 2 Graphene Surface Plasmon Waveguide Beam Splitter Based on Self-Imaging.

Based on the principle of self-imaging, a 1 × 2 graphene waveguide beam splitter is proposed in this work, which can split the graphene surface plasmons excited by far-infrared light. The multimode interference process in the graphene waveguide is analyzed by guided-mode propagation analysis (MPA), and then the imaging position is calculated. The simulation results show that the incident beam can be obviously divided into two parts by the self-imaging of the graphene surface plasmon. In addition, the influences of the excited light wavelength, Fermi level, dielectric environment on the transmission efficiency are studied, which provide a reference for the research of graphene waveguide related devices.

Phase Measurement and Adjustment of Reflector Antenna with Beam Waveguide Feeds

Phase Measurement and Adjustment of Reflector Antenna with Beam Waveguide Feeds

Three-dimensional polarization-dependent full-wavelength beam splitter written by femtosecond laser in LiNbO3 crystal.

We report on the fabrication of Y-branched waveguide beam splitters with cladding structures in LiNbO3 crystal by direct femtosecond laser writing. The femtosecond laser writes tracks near the surface of the crystal, constructing a square structure based on the Type II geometry. The waveguide beam splitters support the propagation of full-wavelength light from the visible to mid-infrared, which was experimentally and numerically investigated. In addition, it has been found that the guidance is only along the vertical (i.e., TM) polarization, which is due to the different refractive indices in the longitudinal and transverse directions. The femtosecond-laser writing here also represents an alternative for fabricating complex integrated light guiding in crystals.

Tailoring the nonclassicality of light states via mode detuning in waveguide beam splitters

The recent advent of integrated waveguide systems with reconfigurable propagation constants and coupling coefficients has opened the door to using waveguide detuning as a resource for readily tailoring the quantum properties of light states. Here we theoretically demonstrate that waveguide mode detuning can be used for molding the nonclassical properties of two interacting quantum optical fields in integrated waveguide couplers. In particular, we explore the states that are generated by conditional measurements when one of the input ports of the waveguide coupler is excited by coherent states, squeezed vacuum states, and thermal states, while the other port is excited by a single-photon Fock state. We explore the detuning range required to attain nonclassical states. Our findings could pave the way for a robust integrated-optics protocol, providing enhanced control and engineering capabilities over multiphoton quantum states.

Inverse design of mid-infrared diamond waveguide beam splitter.

Diamond is a supreme material for mid-infrared (MIR) integrated photonics as it has a transparency window up to 20 µm that covers the entire fingerprint region. However, its relatively low refractive index poses a challenge in designing an MIR diamond functional device with both small footprint and high transmission efficiency. Here we propose and demonstrate the inverse design of an MIR diamond waveguide beam splitter operating at the wavelength of 15 µm with a small footprint of ∼15 µm × ∼15 µm and a total transmission efficiency above 95%. Our work paves a new avenue for the design of compact and high-efficiency MIR diamond photonic devices.

A hybrid variational method for beam propagation and interaction in a graded-index nonlinear waveguide

The hybrid variational method can be used to simplify multidimensional numerical simulations. We examine the applicability of this method to study the nonlinear propagation of a single beam and the interference of two spatial soliton beams in a graded-index optical waveguide governed by a two-dimensional nonlinear Schrodinger equation. We classified three distinct regimes of the dynamics that emerge during single Gaussian beam propagation, corresponding to beam decay, breather formation, and self-focusing. When two spatial soliton beams were set up to interfere in the waveguide, we identified the boundary where the nonlinear interaction during the interference led to excitation or self-focusing. These quite involved dynamics were used to test the predictive power of our variational models by comparing them with direct numerical simulations, obtaining good agreement.

Study on dynamic response characteristics of the scanning angle in a liquid crystal cladding waveguide beam scanner

This paper studies the dynamic response characteristics of the scanning angle in a liquid crystal cladding waveguide beam scanner. Based on liquid crystal dynamic theory, finite element analysis and vectorial refraction law, a dynamic response calculation model of scanning angle is constructed. The simulation results show that the dynamic responses of the scanning angle during the electric field-on and field-off processes are asymmetric, and exhibit “S”-shape and “L”-shape changing trends, respectively. In addition, by comparing with the bulk phase modulation response process of traditional liquid crystal devices, the intrinsic physical reason for the rapid light regulation of the liquid crystal cladding waveguide beam scanner is clarified to be that the liquid crystal close to the core layer has a faster rotation speed during the electric field-off process. Moreover, the liquid crystal cladding waveguide beam scanner is experimentally tested, and the experiment results are in good agreement with theoretical simulations.

Stabilization of hollow Gaussian beams in nonlinear metamaterial waveguides

Hollow Gaussian beams which possess the dark hollow spatial intensity distribution were found to have interesting applications in trapping nano-sized particles and free-space optical communication. Many applications demand stable dynamics of higher dimensional beams. Here we theoretically study the dynamics of hollow Gaussian beams in cubic and quintic nonlinear negative index metamaterial. We adopt Lagrangian variational analysis and explore the parametric regions characterizing the metamaterial in which the hollow Gaussian beam can execute stable dynamics as well as it can undergo filamentation due to intrinsic collapse. We confirm the analytical results obtained through variational analysis by direct numerical analysis based Crank Nicolson method implemented in Python programming.

Asymmetries Caused by Nonparaxiality and Spin–Orbit Interaction during Light Propagation in a Graded-Index Medium

Spin–orbit coupling and nonparaxiality effects during the propagation of vortex vector light beams in a cylindrical graded-index waveguide are investigated by solving the full three-component field Maxwell’s equations. Symmetry-breaking effects for left- and right-handed circularly polarized vortex light beams propagating in a rotationally symmetric graded-index optical fiber are considered. The mode-group delay in a graded-index fiber due to spin–orbit interaction is demonstrated. A scheme for observing the temporal spin Hall effect is proposed. It is shown that the relative delay times between vortex pulses of opposite circular polarizations of the order of 10 ps/km can be observed in graded-index fibers for high-order topological charges.

Ultra-compact all-optical half-adder based on inverse design

The all-optical half-adder is an important module in integrated photonics, which can be used to realize optical computing and optical communication. At present, the all-optical half-adder implemented by traditional methods cannot easily be further compressed in size, which also limits the development of its integration. In this paper, four optical devices, the power beam splitter, waveguide cross, XOR gate, and AND gate, are designed by the inverse design method. Their footprint is only 2µm×2µm, and they have extremely low insertion loss and high contrast ratio. These devices are further interconnected with waveguides to realize an all-optical half-adder module with a size of only 10µm×4.5µm. When working at 1550 nm, the module exhibits contrast ratios of 14.47 dB and 5.14 dB for SUM and CARRY, respectively. These photonic devices have the characteristics of ultra-compact size and high performance, rendering them highly valuable for photonic integrated circuits.

The Influence of Bottom Sediment on the Propagation of Caustic Beams in Oceanic Waveguides

The Influence of Bottom Sediment on the Propagation of Caustic Beams in Oceanic Waveguides

The Influence of Bottom Sediment on the Propagation of Caustic Beams in Oceanic Waveguides

Numerical modeling with the use of mode theory was used to investigate the regularities of the spatial (depth and horizontal distance) distribution of the acoustic field intensity formed by multiple interaction of a caustic beam with a layered bottom in a shallow oceanic waveguide with an underwater sound channel open to the bottom. It has been established that at the values of the sound velocity at the upper boundary in the sedimentary layer, less than the sound velocity at the bottom in the water layer, the formation of a multi-beam structure of the acoustic field is possible. It was found that, starting from certain distances, newly formed beams can play the main role in the spatial distribution of the acoustic field intensity.

Solitary waves for the nonparaxial nonlinear Schrödinger equation

In this paper, the nonparaxial nonlinear Schrödinger (NNLS) equation by considering its integrability which enables the propagation of ultra-broad nonparaxial beams in a planar optical waveguide is studied. The plenty numbers of solitary wave solutions by using Hirota’s bilinear scheme are found, in addition, the bilinear transformation and also the related theorem for getting to the bilinear form of nonlinear system are considered. Two new simple approaches are implemented to recover periodic wave, bright soliton, singular, and singular soliton for this model. Because of the significance of the NNLS in modeling the propagation of solitons through an optical fiber, the recovered solitons are vital for describing and understanding a variety of fundamental physical processes. The effect of the free parameters on the behavior of acquired figures to a few obtained solutions by providing the feasibility and reliability of the used procedure was also discussed. For more physical illustration and knowledge of the physical characteristics of this equation, some important solutions are discussed graphically in the form of 2D and 3D plots by selecting suitable parameters.

Electron Quantum Optics with Beam Splitters and Waveguides in Dirac Matter

AbstractAn electron is a quantum particle and behaves as both a particle and a probability wave. On account of this it can be controlled in a similar way to a photon and electronic devices can be designed in analogy to those based on light when there is minimal excitation of the underlying Fermi sea. Here, splitting of the electron wavefunction is explored for systems supporting Dirac type physics, with a focus on graphene but being equally applicable to electronic states in topological insulators, liquid helium, and other systems described relativistically. Electron beam‐splitters and superfocusers are analysed along with propagation through nanoribbons, demonstrating that the waveform, system geometry, and energies all need to balance to maximise the probability density and hence lifetime of the flying electron. These findings form the basis for novel quantum electron optics.

Design of prism coupling structure for liquid crystal cladding waveguide beam steerer.

This paper proposes an extended prism coupling analysis method to accurately analyze the coupling structure of liquid crystal (LC) cladding waveguide beam steerer. We analyze the effects of LC anisotropy on the coupling of transverse electric (TE) and transverse magnetic (TM) modes and derive the expression of the optical field distribution that perfectly matches the given coupling structure. Based on this method, we present the optimal coupling structure for Gaussian beam. Taking into account the practical manufacturing process, we propose a simplified coupling structure and perform a detailed analysis of its performance based on numerical simulations. Experimental results show a coupling efficiency of 91% and a coupling angle full width at half maximum (FWHM) of about ±0.02°, demonstrating the effectiveness of the proposed method in predicting the coupling performance of anisotropic cladding waveguides.

Aluminum nitride waveguide beam splitters for integrated quantum photonic circuits

We demonstrate integrated photonic circuits for quantum devices using sputtered polycrystalline aluminum nitride (AlN) on insulator. On-chip AlN waveguide directional couplers, which are one of the most important components in quantum photonics, are fabricated and show the output power splitting ratios from 50:50 to 99:1. Polarization beam splitters with an extinction ratio of more than 10 dB are also realized from the AlN directional couplers. Using the fabricated AlN waveguide beam splitters, we observe Hong–Ou–Mandel interference with a visibility of 91.7%±5.66%.

Deep space debris—Detection of potentially hazardous asteroids and objects from the southern hemisphere

Space debris are composed of both natural and human made objects, some in near Earth orbits while others are passing through deep space. Asteroids may represent one form of near Earth and deep space debris. In this article we report on a set of asteroid observations from the southern hemisphere. We indicate that Apollo and Aten class asteroids represent another form of deep space debris of a potentially hazardous nature to orbiting spacecraft and/or Earth based locations. We also show some of the operational challenges, types of facilities and the importance of geographic diversity, that is, necessary for detecting, observing and characterising asteroids, especially PHA’s. For many years, space agencies and institutions have observed and monitored near Earth asteroids and objects (NEO’s) using high gain radio frequency antennas and optical telescopes in the northern hemisphere (GSSR, Arecibo, Catalina, Pan-STARRS, Atlas and Linear) 1) However a regular operational system to monitor the southern skies does not have the same level of maturity and is where a percentage of asteroids and various human made objects are not detected until they pass into northern skies. To fill that gap the Southern Hemisphere Asteroid Radar Program (SHARP) 2) located in Australia uses available antenna time on either a 70 or 34 m beam waveguide antenna located at the Canberra Deep Space Communication Complex (CDSCC) to transmit a Doppler compensated continuous radio wave at 2.114 GHz (14.2 cm) and 7.15945 GHz (4.2 cm) toward the NEO and receive its echoes at the 64 m Parkes or 6 m × 22 m Australia Telescope Compact Array (ATCA) antennas at Narrabri in Australia. This mode of NEO observation is termed a deep space bistatic radar. The southern hemisphere program has also recently been joined by the 12 m University of Tasmania antennas at Hobart (Tasmania) and Katherine (Northern Territory). Combining SHARPS bistatic radar with small optical apertures located at the University of New South Wales (UNSW) and University of Western Australia (UWA) allows combined optical/RF NEO detections. Whilst sub-metre class optical instruments have contributed independently to asteroid detection over decades, the use of coordinated small 0.3–0.5 m instruments synchronized to large asteroid radars offers an observational flexibility and adaptability when larger optical systems 3) are dedicated to other forms of professional optical astronomy. Since 2015, SHARP has illuminated and tracked over 30 NEO’s ranging in diameter from 7 to 5000 m at ranges of 0.1–18 lunar distances (LD) from Australia.

Effect of PMMA Temperature on Optical Performances of 1 x 2 Hybrid Photonic Crystals Waveguide Beam Splitters

Effect of PMMA Temperature on Optical Performances of 1 x 2 Hybrid Photonic Crystals Waveguide Beam Splitters