Address Event Representation Bus Research Articles

On algorithmic rate-coded AER generation

This paper addresses the problem of converting a conventional video stream based on sequences of frames into the spike event-based representation known as the address-event-representation (AER). In this paper we concentrate on rate-coded AER. The problem is addressed as an algorithmic problem, in which different methods are proposed, implemented and tested through software algorithms. The proposed algorithms are comparatively evaluated according to different criteria. Emphasis is put on the potential of such algorithms for a) doing the frame-based to event-based representation in real time, and b) that the resulting event streams ressemble as much as possible those generated naturally by rate-coded address-event VLSI chips, such as silicon AER retinae. It is found that simple and straightforward algorithms tend to have high potential for real time but produce event distributions that differ considerably from those obtained in AER VLSI chips. On the other hand, sophisticated algorithms that yield better event distributions are not efficient for real time operations. The methods based on linear-feedback-shift-register (LFSR) pseudorandom number generation is a good compromise, which is feasible for real time and yield reasonably well distributed events in time. Our software experiments, on a 1.6-GHz Pentium IV, show that at 50% AER bus load the proposed algorithms require between 0.011 and 1.14 ms per 8 bit-pixel per frame. One of the proposed LFSR methods is implemented in real time hardware using a prototyping board that includes a VirtexE 300 FPGA. The demonstration hardware is capable of transforming frames of 64 x 64 pixels of 8-bit depth at a frame rate of 25 frames per second, producing spike events at a peak rate of 10(7) events per second.

An ON–OFF Orientation Selective Address Event Representation Image Transceiver Chip

This paper describes the electronic implementation of a four-layer cellular neural network architecture implementing two components of a functional model of neurons in the visual cortex: linear orientation selective filtering and half wave rectification. Separate ON and OFF layers represent the positive and negative outputs of two-phase quadrature Gabor-type filters, whose orientation and spatial-frequency tunings are electronically adjustable. To enable the construction of a multichip network to extract different orientations in parallel, the chip includes an address event representation (AER) transceiver that accepts and produces two-dimensional images that are rate encoded as spike trains. It also includes routing circuitry that facilitates point-to-point signal fan in and fan out. We present measured results from a 32/spl times/64 pixel prototype, which was fabricated in the TSMC0.25-/spl mu/m process on a 3.84 by 2.54 mm die. Quiescent power dissipation is 3 mW and is determined primarily by the spike activity on the AER bus. Settling times are on the order of a few milliseconds. In comparison with a two-layer network implementing the same filters, this network results in a more symmetric circuit design with lower quiescent power dissipation, albeit at the expense of twice as many transistors.