Adaptive Modulation And Channel Coding Research Articles

Optimum Adaptive Modulation and Channel Coding Scheme for Frequency Domain Channel-Dependent Scheduling in OFDM Based Evolved UTRA Downlink

In the Evolved UTRA (UMTS Terrestrial Radio Access) downlink, Orthogonal Frequency Division Multiplexing (OFDM) based radio access was adopted because of its inherent immunity to multipath interference and flexible accommodation of different spectrum arrangements. This paper presents the optimum adaptive modulation and channel coding (AMC) scheme when resource blocks (RBs) is simultaneously assigned to the same user when frequency and time domain channel-dependent scheduling is assumed in the downlink OFDMA radio access with single-antenna transmission. We start by presenting selection methods for the modulation and coding scheme (MCS) employing mutual information both for RB-common and RB-dependent modulation schemes. Simulation results show that, irrespective of the application of power adaptation to RB-dependent modulation, the improvement in the achievable throughput of the RB-dependent modulation scheme compared to that for the RB-common modulation scheme is slight, i.e., 4 to 5%. In addition, the number of required control signaling bits in the RB-dependent modulation scheme becomes greater than that for the RB-common modulation scheme. Therefore, we conclude that the RB-common modulation and channel coding rate scheme is preferred, when multiple RBs of the same coded stream are assigned to one user in the case of single-antenna transmission.

Experimental Evaluation of Time Diversity Effect in Hybrid ARQ Considering Space and Path Diversity for Downlink OFDM-Based Broadband Radio Access

This paper presents experimental evaluations of the effect of time diversity obtained by hybrid automatic repeat request (HARQ) with soft combining in space and path diversity schemes on orthogonal frequency division multiplexing (OFDM)-based packet radio access in a downlink broadband multipath fading channel. The effect of HARQ is analyzed through laboratory experiments employing fading simulators and field experiments conducted in downtown Yokosuka near Tokyo. After confirming the validity of experimental results based on numerical analysis of the time diversity gain in HARQ, we show by the experimental results that, for a fixed modulation and channel coding scheme (MCS), time diversity obtained by HARQ is effective in reducing the required received signal-to-interference plus noise power ratio (SINR) according to an increase in the number of transmissions, K, up to 10, even when the diversity effects are obtained through two-branch antenna diversity reception and path diversity using a number of multipaths greater than 12 observed in a real fading channel. Meanwhile, in combined use with the adaptive modulation and channel coding (AMC) scheme associated with space and path diversity, we clarify that the gain obtained by time diversity is almost saturated at the maximum number of transmissions in HARQ, K' = 4 in Chase combining and K' = 2 in Incremental redundancy, since the improvement in the residual packet error rate (PER) obtained through time diversity becomes small owing to the low PER in the initial packet transmission arising from appropriately selecting the optimum MCS in AMC. However, the experimental results elucidate that the time diversity in HARQ with soft combining associated with antenna diversity reception is effective in improving the throughput even in a broadband multipath channel with sufficient path diversity.

Field and Indoor Experimental Results of E-UTRA Uplink

This paper investigates the uplink throughput performance and the interference power to other cells using an Evolved UTRA (E-UTRA) laboratory and field experimental system. In E-UTRA uplink, the near-far problem is not an issue since the orthgonality among the users within the target cell is maintained. Therefore, the fractional transmission power control (TPC), in which the target level of TPC is adjusted according to the path loss level, can be adopted. Thus, it is expected the high cell throughput and the large coverage area by combining fractional TPC, adaptive modulation and channel coding (AMC), and variable resource block (RB) allocation. The indoor and field experimental results show that the peak throughput of approximately 45Mbps is achieved by allocating a wider bandwidth and setting higher target level for the UE located near the cell site while keeping the adjacent cell interference level almost the constant. We also showed that the system capacity can be improved by 50% in simple cell model by applying the AMC and the fractional TPC.

Comparison of Throughput Employing Hybrid ARQ Packet Combining in Forward Link OFCDM Broadband Packet Wireless Access

This paper compares the throughput performance employing hybrid automatic repeat request (ARQ) packet combining, i.e., Chase combining, and Incremental redundancy, considering the frequency diversity effect in the broadband forward-link channel for Orthogonal Frequency and Code Division Multiplexing (OFCDM) packet wireless access achieving a peak throughput above lOOMbps. Simulation results show that the achievable throughput at the average received signal energy per symbol-to-background noise power spectrum density ratio (E s /N 0 ) of 0 and 6 dB employing Incremental redundancy is increased by approximately 35 and 30% compared to that using Chase combining for QPSK and 16QAM data modulation schemes with the coding rate of R = 1/2, respectively, considering a large frequency diversity effect in a 12-path exponential decayed Rayleigh fading channel, since the reduced variations in the received signal level in a broadband channel bring about a larger coding gain in Incremental redundancy. We also show that when adaptive modulation and channel coding (AMC) is applied, Incremental redundancy is superior to Chase combining since the large coding gain is effective in achieving a large time diversity gain for a low number of retransmissions such as M = 1 or 2 for a maximum Doppler frequency up to f D = 400 Hz. It is demonstrated, nevertheless, that the total throughput when employing Incremental redundancy associated with a near optimum MCS set according to the channel conditions becomes almost identical to that using Chase combining when a large number of retransmissions, M, is allowed, such as M = 10, owing to time diversity alone with frequency diversity.

Variable Spreading Factor-OFCDM with Two Dimensional Spreading that Prioritizes Time Domain Spreading for Forward Link Broadband Wireless Access

This paper proposes the optimum design for adaptively controlling the spreading factor in Orthogonal Frequency and Code Division Multiplexing (OFCDM) with two-dimensional spreading according to the cell configuration, channel load, and propagation channel conditions, assuming the adaptive modulation and channel coding (AMC) scheme employing QPSK and 16QAM data modulation. Furthermore, we propose a two-dimensional orthogonal channelization code assignment scheme to achieve skillfully orthogonal multiplexing of multiple physical channels. We first demonstrate the reduction effect of inter-code interference by the proposed two-dimensional orthogonal channelization code assignment. Then, computer simulation results show that in time domain spreading, the optimum spreading factor, except for an extremely high mobility case such as for the fading maximum Doppler frequency of f D = 1500 Hz, becomes SF Time = 16. Furthermore, it should be decreased to SF Time = 8 for such a very fast fading environment using 16QAM data modulation. We also clarify when the channel load is light such as C mux /SF = 0.25 (C mux and SF denote the number of multiplexed codes and total spreading factor, respectively), the required average received signal energy per symbol-to-noise power spectrum density ratio (E s /N 0 ) is reduced as the spreading factor in the frequency domain is increased up to say SF Freq = 32 for QPSK and 16QAM data modulation. When the channel load is close to full such as when C mux /SF = 0.94, the optimum spreading factor in the frequency domain is SF Freq = 1 for 16QAM data modulation and SF Freq = 1 to 8 for QPSK data modulation according to the delay spread. Consequently, by setting several combinations of spreading factors in the time and frequency domains, the near maximum link capacity is achieved both in cellular and hotspot cell configurations assuming various channel conditions.