Achievable Sum-rate Maximization Research Articles

SLIPT-Enabled Multi-LED MU-MISO VLC Networks: Joint Beamforming and DC Bias Optimization

This paper studies a simultaneous lightwave information and power transfer (SLIPT)-enabled multi-user (MU) multiple input single output (MISO) visible light communication (VLC) network, where multiple user equipments (UEs) are simultaneously allowed to receive information by the photodiode (PD) and harvest energy by the solar panel, respectively. To improve the system spectral efficiency, an achievable sum rate maximization problem is formulated subject to the minimum energy harvesting (EH) requirement of each UE, the total transmit power constraint of the LEDs and the dimming control constraint of the LEDs, by jointly optimizing the beamforming vector and the direct current (DC) bias vector of the LEDs. To be general, the practical non-linear EH model and the information capacity model of the VLC channel are adopted. To solve the non-convex optimization problem, the objective function is equivalently transformed at first by using the epigraph reformulation, and then the transformed problem is relaxed with the semi-definite relaxation (SDR) method. Based on this, an iterative algorithm is designed to approximately obtain the maximal achievable sum rate based on the successive convex approximation (SCA). Simulation results indicate that there exists a non-trivial trade-off between the achievable sum rate and the harvested energy, and that DC bias vector dominates the amount of the harvested energy compared with the beamforming vector. Besides, for a given relatively high EH requirement, the achievable sum rate increases with the increment of the dimming level, especially for relatively small dimming level. Once the dimming level is larger than a specific value, with the increment of the dimming level, more transmit power will be allocated for illumination, resulting in the decrement of the achievable sum rate.

Downlink Training Sequence Design Based on Waterfilling Solution for Low-Latency FDD Massive MIMO Communications Systems

Future generations of wireless communications systems are expected to evolve toward allowing massive ubiquitous connectivity and achieving ultra-reliable and low-latency communications (URLLC) with extremely high data rates. Massive multiple-input multiple-output (m-MIMO) is a crucial transmission technique to fulfill the demands of high data rates in the upcoming wireless systems. However, obtaining a downlink (DL) training sequence (TS) that is feasible for fast channel estimation, i.e., meeting the low-latency communications required by future generations of wireless systems, in m-MIMO with frequency-division-duplex (FDD) when users have different channel correlations is very challenging. Therefore, a low-complexity solution for designing the DL training sequences to maximize the achievable sum rate of FDD systems with limited channel coherence time (CCT) is proposed using a waterfilling power allocation method. This achievable sum rate maximization is achieved using sequences produced from a summation of the user’s covariance matrices and then applying a waterfilling power allocation method to the obtained low-complexity training sequence. The results show that the proposed TS outperforms the existing methods in the medium and high SNR regimes while reducing computational complexity. The obtained results signify the proposed TS’s feasibility for practical consideration compared with the existing DL training sequence designs.

Joint SIC-Based Precoding and Sub-Connected Architecture Design for MIMO VLC Systems

Densely deployed light emitting diodes (LEDs) typically lead to high spatial correlation in multiple-input multiple-output (MIMO) visible light communication (VLC) systems. Although precoding can effectively alleviate the spatial correlation issue, most existing precoding algorithms require a dedicated baseband chain for each LED, leading to high energy consumption and hardware complexity when a large number of LEDs are used. In this paper, a successive interference cancellation (SIC)-based precoding scheme with sub-connected architecture (SIC-SA) is proposed. In the considered model, each baseband chain is connected to an LED sub-array containing multiple LEDs to reduce the complexity. Since, in this case, SIC-based precoding can only determine the signal of each baseband chain for an LED sub-array, while its target is to mitigate the spatial correlation between individual LEDs, the electrical/optical power of each LED must also be jointly optimized to accomplish the target. This joint SIC-based precoding, power allocation, and direct current offset design problem is formulated as an achievable sum rate maximization problem under dimming control and electrical power constraints. A two-step iterative algorithm is proposed to solve this problem. In the first step, the SIC-based precoding is designed to alleviate the multi-user interference. In the second step, the power allocation of LEDs is optimized by matrix decomposition and convex optimization, and a closed-form solution of DC offset is derived. Furthermore, considering the dynamic scenarios, a SIC-based precoding scheme with dynamic sub-connected architecture (SIC-DSA) is proposed, in which a switch network is used to adaptively adjust the LED sub-array structure based on the channel state information. Simulation results show that the proposed SIC-SA and SIC-DSA respectively achieve 0.1340 bps/Hz/W and 0.1305 bps/Hz/W energy efficiency gains over the zero-forcing precoding scheme with SA, when the signal-to-noise ratio is 30 dB.

Sum Rate Maximization for Self-Sustainable IRS-Assisted UAV Communications

In this letter, we propose a novel time switching (TS) transmission scheme for intelligent reflecting surface (IRS)-assisted unmanned aerial vehicle (UAV)-enabled wireless powered communication network (WPCN). In the energy harvesting (EH) phase, the operation of IRS is switched between energy harvesting and reflecting to improve the energy transfer. In the information transmitting (IT) phase, the operation of IRS is switched between assisted and unassisted IT to avoid the deficient duration of IT phase when the IRS is energy starved. We formulate an achievable sum-rate maximization problem by jointly optimizing the resource allocation, IRS phase shift and location of the UAV. To address the non-convexity resulting from coupling of variables, we divide original problem into three sub-problems and solve them with the block coordinate descent (BCD) method. The numerical results testify that the proposed scheme can obtain the significant sum-rate gain compared to the traditional TS scheme.

A Joint Multiservice Transmission Scheme for RSMA-Aided Cell-Free mMIMO System

In this letter, we propose a joint multi-service (MS) transmission scheme based on cell-free (CF) massive MIMO architecture. Based on the user-centric (UC) principle, we perform access point (AP) selection and form broadcast, multicast, and unicast messages at each AP according to the rate splitting multiple access (RSMA) technique, then we carry out the joint transmission of MS signals. In terms of system optimization, a novel three-step resource allocation algorithm is proposed to deal with the non-convex problem of achievable sum-rate maximization which downscales multidimensional variables to solve the one-dimensional problems of AP selection, intra-AP power ratio determination, and inter-AP power allocation in steps. We provide achievable sum-rate analyses backed by numerical results to show the superiority of the proposed scheme and optimization algorithm compared with the baselines.

Joint Communication and Trajectory Design for Intelligent Reflecting Surface Empowered UAV SWIPT Networks

Aiming at the limited battery capacity of widely deployed low-power smart devices in the Internet-of-things (IoT), this paper proposes a novel intelligent reflecting surface (IRS) empowered unmanned aerial vehicle (UAV) simultaneous wireless information and power transfer (SWIPT) network framework, in which IRS is used to reconstruct the wireless channel to enhance the wireless energy transmission efficiency and coverage area of the UAV SWIPT networks. In this paper, we formulate an achievable sum-rate maximization problem by jointly optimizing UAV trajectory, successive interference cancellation (SIC) decoding order, UAV transmit power allocation, power splitting (PS) ratio and IRS reflection coefficient while taking account of user non-orthogonal multiple access (NOMA) and a non-linear energy harvesting model. Due to the coupling of optimization variables, this problem is a complex non-convex optimization problem, and it is challenging to solve it directly. We first transform the problem, and then apply the alternating optimization (AO) algorithm framework to divide the transformed problem into four sub-problems to solve it. Specifically, by applying successive convex approximation (SCA), penalty function method and difference-convex (DC) programming, UAV trajectory, SIC decoding order, UAV transmit power allocation, PS ratio and IRS reflection coefficient are alternately optimized until the convergence is achieved. Numerical simulation results verify the effectiveness of our proposed algorithm compared to other algorithms.

Sum-Rate Optimization in Flexible Half-Duplex Networks With Transmitter/Receiver Scheduling

In this paper, we focus on the problem of transmitter and receiver scheduling to maximize the achievable sum-rate of a flexible half-duplex network where nodes have the flexibility to either transmit, receive or be silent in a given time slot. We consider a network with multiple transmitters and receivers where each transmitter has specific information it needs to send to a set of receiving nodes. First, we conduct some structural analysis and show that the achievable sum-rate is maximized when each transmitter only transmits to a single receiver at a given time. Next, we consider one instance of the flexible network and by reducing the symmetric multiple receiver network to a single receiver network, we also show that the achievable sum-rate is maximized when either one transmitter or all the transmitters transmit. In fact, there exists a unique received signal-to-noise ratio at which the optimality changes from all-to-one. Finally, we design a novel low-cost algorithm that gives a sub-optimal solution to the achievable sum-rate maximization problem in a flexible half-duplex network. We also provide a comprehensive comparison of the proposed algorithm with respect to existing resource allocation techniques, and observe that our proposed algorithm provides significant sum-rate gains.

Sum Rate Maximization Versus MSE Minimization in FDD Massive MIMO Systems With Short Coherence Time

The increasing demand for higher data rates motivates the exploration of advanced techniques for future wireless networks. To this end, massive multiple-input multiple-output (mMIMO) is envisioned as the most essential technique to meet this demand. However, the expansion of the number of antennas in mMIMO systems with short coherence time makes the downlink channel estimation (DCE) overhead potentially overwhelming. As such, the number of training sequence (TS) needs to be significantly reduced. However, reducing the number of TS reduces the mean-squared error (MSE) accuracy significantly and to date it is not clear to what extend can this TS reduction affects the achievable sum rate performance. Therefore, this paper develops a low complexity and tractable TS solution for DCE and establishes an analytical framework for the optimum TS. Furthermore, the tradeoff between the achievable sum rate maximization criteria and the MSE minimization criteria is investigated. This investigation is essential to characterize the optimum TS length and the actual performance of mMIMO systems when the channel exhibits a limited coherence time. To this end, the statistical structure of mMIMO channels is exploited. In addition, this paper utilizes a random matrix theory (RMT) method to characterize the downlink achievable sum rate and MSE in a closed-form. This paper shows that maximizing the downlink sum rate criterion is more important than minimizing the MSE of the SINR only, which is typically considered in the conventional MIMO systems and/or in the time division duplex (TDD) mMIMO systems. The results demonstrate that a feasible downlink achievable sum rate can be achieved in an frequency division duplex (FDD) mMIMO system. This finding is necessary to extend the benefit of mMIMO systems to high frequency bands such as millimeter-wave (mmWave) and Terahertz (THZ) communications.

Optimal Time Scheduling in Relay Assisted Batteryless IoT Networks

In this letter, we propose a novel relay transmission scheme in a batteryless IoT network for practical implementation and high energy-efficiency, where communications between a hybrid access point (HAP) and multiple batteryless sensors are assisted by energy-constrained gateways. In the proposed system, while a batteryless sensor backscatters the incident signals from the HAP to transmit data to its gateway, other gateways can simultaneously harvest energy from the HAP. Then, the gateways can use their harvested energy to forward the received signals to the HAP. Under this setup, we formulate the achievable sum-rate maximization problem by optimizing the time allocation between data backscattering, energy harvesting, and data forwarding. Then, an efficient method is proposed to find the optimal solution. Simulation results show that the proposed relay transmission scheme can achieve up to 34% sum-rate gain over two benchmark schemes.

Achievable sum‐rate maximization using relay/antenna selection for MIMO two‐way AF relaying with channel uncertainties

SummaryThis paper focuses on the layered relay‐and‐antenna selection (LRAS) for achievable sum‐rate (ASR) maximization while considering the impacts of residual self‐interference due to channel estimation errors in multiple‐input multiple‐output two‐way amplify‐and‐forward relaying systems. Two LRAS algorithms, namely, the Gram–Schmidt and the adaptive discrete stochastic approximation selection techniques, are investigated based on the ASR maximization under an equal power allocation. To alleviate the complexity burden of the LRAS strategies, the optimal relay and the subset of transmit‐and‐receive antenna pairs are determined by a two‐stage selection mechanism. By taking two LRAS strategies and correlated channel uncertainties into account, the development of a two‐way multiple‐input multiple‐output multi‐amplify‐and‐forward‐relay system is able to provide improved robustness against the channel state information mismatch and the residual self‐interference. Copyright © 2016 John Wiley & Sons, Ltd.

Joint Opportunistic Spectrum Access and Optimal Power Allocation Strategies for Full Duplex Single Secondary User MIMO Cognitive Radio Network

This paper introduces a full duplex single secondary user multiple-input multiple-output (FD-SSU-MIMO) cognitive radio network, where secondary user (SU) opportunistically accesses the authorized spectrum unoccupied by primary user (PU) and transmits data based on FD-MIMO mode. Then we study the network achievable average sum-rate maximization problem under sum transmit power budget constraint at SU communication nodes. In order to solve the trade-off problem between SU`s sensing time and data transmission time based on opportunistic spectrum access (OSA) and the power allocation problem based on FD-MIMO transmit mode, we propose a simple trisection algorithm to obtain the optimal sensing time and apply an alternating optimization (AO) algorithm to tackle the FD-MIMO based network achievable sum-rate maximization problem. Simulation results show that our proposed sensing time optimization and AO-based optimal power allocation strategies obtain a higher achievable average sum-rate than sequential convex approximations for matrix-variable programming (SCAMP)-based power allocation for the FD transmission mode, as well as equal power allocation for the half duplex (HD) transmission mode.

Resource Allocation in Amplify-and-Forward Relay-Assisted DS/CDMA Systems

Non-cooperative resource allocation in amplify-and-forward relay-assisted DS/CDMA networks is tackled in this paper. The relay allocates its amplify-and-forward matrix for achievable sum-rate maximization, whereas the mobile transmitters selfishly allocate their spreading codes for individual achievable rate maximization. Convergence of the proposed algorithm is proved and its performance contrasted against a centralized approach. Moreover, the proposed approach is extended to the case in which the direct path between transmitters and receiver is taken into account.

Practical Power Allocation for Cooperative Distributed Antenna Systems

In this letter, we address the problem of downlink power allocation for the generalized distributed antenna system (DAS) with cooperative clusters. Considering practical applications, we assume that only the large-scale channel state information is available at the transmitter. The power allocation scheme is investigated with the target of ergodic achievable sum rate maximization. Based on some approximations and the Rayleigh Quotient Theory, the simple selective power allocation scheme is derived for the low SNR scenario and the high SNR scenario, respectively. The methods are applicable in practice due to their low complexity.