Redox flow batteries based on sodium polysulfide (Na2Sx) show promise due to sodium's high solubility in organic solvents (e.g., diglyme. However, when x is lower than 5, sodium polysulfide exhibits low solubility (less than 0.1 molal), limiting the nominal capacity of this redox-active material. Sodium phosphorothioate complexes, Na2P2Sx, have been reported as an alternative to Na2Sx. Incorporating phosphorus into the polysulfide structure improves their solubility in organic solvents, specifically in diglyme.This presentation will describe the synthesis and characterization of sodium phosphorothioate complexes (Na2P2Sx, where x = 6, 7, 8, and 9) for nonaqueous redox flow batteries. The structure of these materials is explored using 31P NMR and 23Na NMR spectroscopy, Raman spectroscopy, and X-ray diffraction analysis. Overall, 31P NMR results indicate that P5+ is tetrahedrally coordinated in all structures and that Na-P-S compounds have a common PS3- moiety. Ongoing efforts are aimed at providing more precise assignments to the 31P bands and correlating these findings with complementary structural information obtained from 23Na NMR and Raman spectroscopy.Electrochemical properties of sodium polysulfide and sodium thiophosphate catholytes, specifically Na2S8 and Na2P2S8, were also compared using CV. The voltammogram of Na2S8 revealed two clear redox reactions in the 1.5-3 V range vs. Na/Na+ due to a multi-step electron transfer process involving the S2-/S0 redox center. In contrast, Na2P2S8 exhibited a larger peak separation (~2 V) and lower peak currents at a given scan rate, potentially indicating a significant activation barrier associated with the rearrangement of the thiophosphate’s polyanionic structure during reduction/oxidation. Despite the substantial voltage hysteresis, Na2P2S8 displayed stable cycling performance, with a slight increase in peak current after 100 cycles. This behavior is consistent with measurements on RFBs containing a Na2P2Sx catholyte, where an electrode activation process increased the cell’s reversible capacity, likely due to subtle changes in the electrode’s surface chemistry during repeated oxidation/reduction. Finally, preliminary flow cell measurements on Na2P2S7 catholyte show reversible voltage profiles after the formation step with deep discharge. Overall, this presentation demonstrates that Na-P-S catholytes represent a promising material for high energy, low-cost redox flow batteries.AcknowledgementsThis research was conducted at Oak Ridge National Laboratory, managed by UT Battelle, LLC, for the U.S. Department of Energy (DOE) and is sponsored by the U.S. Department of Energy through the Energy Storage Program in the Office of Electricity.
Read full abstract