Abstract
Zr55Cu30Al10Ni5 (at.%) amorphous sheets with thickness of ~0.5 mm and width of ~75 mm were successfully fabricated by twin-roll strip casting. The amorphous alloy sheets fabricated using a high rolling force exhibited a high-energy state, a high free-volume content, and structural inhomogeneity, which led to an engineering strain greater than 62% in compression at room temperature. This study provides an effective method for fabricating large amorphous alloy sheets with good plasticity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.