Zinc delivery to plants through seed coating with nano-zinc oxide particles

Abstract

ABSTRACTIn India, zinc (Zn) has been recognized as the fourth most important yield-limiting nutrient after nitrogen (N), phosphorus (P) and potassium (K). Supplementing the zinc (Zn) requirement of agricultural crops through water soluble zinc sulfate ZnSO4 fertilizer is a costly management option whereas, utilization of ZnO (water insoluble and a cheaper material) as a source of Zn could be an alternative cost effective option to encourage farmers for wider adoption. In this present investigation, in order to supply the requisite amount of Zn to the plants, a protocol has been developed to coat the seeds of maize (Zea mays L.), soybean (Glycine max L.), pigeon pea (Cajanas cajan L.) and ladies finger (Abelmoschus esculentus L.) with microns scale (<3 µm) and nano-scale (<100 nm) ZnO powder at 25 mg Zn/g seed and at 50 mg Zn/g seed. Different Zn sources, ethyl alcohol, and crude pine oleoresin (POR) were used for coating of seeds. The germination test carried out with coated and uncoated seeds indicated better germination percentage (93–100%) due to ZnO coating as compared to uncoated seeds (80%). Pot culture experiment conducted with coated seeds also revealed that the crop growth with ZnO coated seeds were similar to that observed with soluble Zn treatment applied as zinc sulfate heptahydrate (ZnSO4·7H2O) (at 2.5 ppm Zn) which is evident from the periodic SPAD reading taken after 20, 25, 30 and 45 days after sowing. Application of Zn through different sources also enhanced the auxin indole-3-acetic acid (IAA) production in plant roots, which subsequently improved the overall growth. The most important advantage of seed coating with ZnO (both micron/nano-scale) is that it did not exert any osmotic potential at the time of germination of the seed, thus, the total requirement of Zn of the crop can be loaded with the seed effectively through nano-scale ZnO particle.