Abstract
Envelope limiters are used in such applications as FM demodulation and power leveling. Recently, the envelope-limiting properties of yttrium-iron-garnet (YIG) filters were reported for the special cases of unmodulated and pulsed input signals. Measured data is presented hereon the response of a YIG limiter to AM carriers having modulation index of the order of 50 percent. Sinusoidal, square-wave, and low-pass noise modulating signals were used in the measurements. It was found that a YIG filter will give good envelope Iimiting for modulating frequencies in the submegacycle range. At these low frequencies the carrier and the side frequencies are not limited selectively. At higher modulating frequencies where the limiting is frequency selective, the YIG filter will not remove the variations. In fact, in the particular filter tested, the modulation index was increased, rather than decreased, at modulating frequencies greater than about 750 kc/s. A graph is given showing the measured factor of reduction (or increase) of modulation index, as a function of modulating frequency. The response of the limiter as a function of carrier frequency, modulating frequency, and input power is shown by oscilloscope displays produced by sweeping the carrier frequency or input power. In addition, selected photographs of output envelope waveforms are given.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.