Yield stress Measurement of municipal sludge: A comprehensive evaluation of testing methods and concentration effects using a rotational rheometer

Abstract

Accurate prediction and measurement of yield stress are crucial for optimizing sludge treatment and disposal. However, the differences and applicability of various methods for measuring yield stress are subjects of ongoing debate. Meanwhile, literature on measuring sludge yield stress is limited to low solid concentrations (TS <10%), understanding and studying the yield stress of medium to high solid concentration sludge is crucial due to increasingly stringent standards for sludge treatment and disposal. So, this study employed a rotational rheometer to measure sludge yield stress across a wide range of TS (4–50%) using steady shear, dynamic oscillatory shear, and transient shear. The study derived significant conclusions by comparing and summarizing the applicability and limitations of each testing method: Dynamic oscillatory shear methods, including G′-σ curve method, γ-σ curve method, and G**γc method can measure sludge yield stress ranging from 4% to 40% TS, while other methods are restricted to low or limited solid concentrations; The G' = G″ method, utilizing the intersection of G′ and G″ curves, consistently yields the highest value for yield stress when 4%≤ TS ≤ 12%; The rotational rheometer cannot measure sludge yield stress when the solid concentration exceeds 40% TS; The relationship between sludge yield stress and solid concentration is stronger as a power-law for TS ≤ 25%, transitioning to linear for higher concentrations (28%≤ TS <40%). This study systematically explores the applicability and limitations of various measurement methods for characterizing sludge yield stress across a wide range of solid concentrations, providing valuable guidance for scientific measurement and highlighting challenging research issues.