Yield and Zinc, Copper, Manganese and Iron Concentration in Maize (Zea mays L.) Grown on Vertisol as Influenced by Zinc Application from Various Zinc Fertilizers

Abstract

Zinc (Zn) deficiency in soils and field crops is widespread across the world, including India, resulting in severe reduction in yield. Hence, soil application of Zn fertilizers is recommended for ameliorating Zn deficiency in soil and for obtaining higher crop yield and better crop quality. Zinc sulfate is commonly used Zn fertilizer in India because of its solubility and less cost. However, good quality and adequate quantity of zinc sulfate is not available in the market round the year for farmers' use. Field experiments were therefore conducted during rainy season of 2010 and 2011 at research farm of Indian Institute of Soil Science, Bhopal, India to assess the influence of Zn application through zinc sulfate monohydrate (33% Zn), zinc polyphosphate (21% Zn) and Zn ethylenediaminetetraacetate (EDTA) (12% Zn) on yield and micronutrient concentration and uptake by maize (Zea mays L.). In both the years, grain and vegetative tissue (stover) yield of maize increased significantly with successive application of Zn up to 1 kg ha−1 added through zinc sulfate monohydrate and zinc polyphosphate. Addition of 2.5 kg Zn ha−1 did not increase yield further but resulted in highest stover Zn concentration. Zinc, copper (Cu), manganese (Mn), and iron (Fe) concentration in maize grain varied from 22.2 to 27.6, 1.6 to 2.5, 3.5 to 4.7 and 19.9 to 24.5 mg kg−1 respectively in both the years. Maize stover had 25.9 to 36.2, 7.9 to 9.8, 36.7 to 44.9 and 174 to 212 mg kg−1 Zn, Cu, Mn, and Fe, respectively. Zinc application did not influence Cu, Mn and Fe concentration in both grain and stover of maize. Transfer coefficients (TCs) of micronutrients varied from 0.72 to 0.95, 0.18 to 0.30, 0.08 to 0.13 and 0.10 to 0.15 for Zn, Cu, Mn, and Fe respectively. Total Zn uptake significantly increased with Zn application from 0.5 to 2.5 kg ha−1 supplied through zinc sulfate monohydrate and zinc polyphosphate. Recovery efficiency of Zn declined with increased Zn rates.