Abstract
Passively mode-locked fiber lasers based on a nonlinear polarization rotation (NPR) have attracted much attention due to their ability to generate short pulses with wide spectra and high peak power. However, environmental perturbations can easily cause the lasers to lose the mode-locked state and make it a challenge for practical application. The aim of this research is to improve the laser stability by inserting a Lyot filter into the mode-locked laser cavity. The experimental results indicate that the mode-locked state can be maintained when the radius of the fiber loop is changed from 7.5 to 1.5 cm, while the signal-to-noise ratio of the fundamental frequency remains almost the same. The tunability of the output power can be achieved by adding a half-wave plate (HWP) in the laser cavity without changing the pump power, while the mode-locked state remains stable. By adjusting the angle of the HWP2, the output power can be adjusted from 3.36 to 66.5 mW at repetition rate of 29.7 MHz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.