X-ray planar radiography and computed tomography

Abstract

Introduction X-ray planar radiography is one of the mainstays of a radiology department, providing a first ‘screening’ for both acute injuries and suspected chronic diseases. Planar radiography is widely used to assess the degree of bone fracture in an acute injury, the presence of masses in lung cancer/emphysema and other airway pathologies, the presence of kidney stones, and diseases of the gastrointestinal (GI) tract. Depending upon the results of an X-ray scan, the patient may be referred for a full three-dimensional X-ray computed tomography (CT) scan for more detailed diagnosis. The basis of both planar radiography and CT is the differential absorption of X-rays by various tissues. For example, bone and small calcifications absorb X-rays much more effectively than soft tissue. X-rays generated from a source are directed towards the patient, as shown in Figure 2.1(a). X-rays which pass through the patient are detected using a solid-state flat panel detector which is placed just below the patient. The detected X-ray energy is first converted into light, then into a voltage and finally is digitized. The digital image represents a two-dimensional projection of the tissues lying between the X-ray source and the detector. In addition to being absorbed, X-rays can also be scattered as they pass through the body, and this gives rise to a background signal which reduces the image contrast. Therefore, an ‘anti-scatter grid’, shown in Figure 2.1(b), is used to ensure that only X-rays that pass directly through the body from source-to-detector are recorded.