Abstract
X-ray Computed Tomography (XCT) analysis was applied to identify and quantify typical defects in dense 3Y-TZP zirconia processed by the Lithography-based Ceramic Manufacturing (LCM) technique. XCT derived strengths were anticipated from the XCT data and compared to experimental measurement. A good agreement between XCT data, bending strength measurement and fractographic analysis demonstrates the suitability of X-ray tomography for both defects detection and predictive mechanical strength estimation. It allows also to rank the different defects related to LCM in terms of their criticality versus mechanical resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
