Abstract
To improve comfort conditions of the enuresis alarm system, modular humidity sensor should be replaced by textile sensor. During research woven textile moisture sensor was developed and first experiments of signal detection speed were performed. Washed and unwashed samples were tested from both sides of sensor. Measurements of electrical signals were performed with oscilloscope. It is important to know what the actual resistance of a wet sensor is in order to design a proper electrical circuit that controls the state of the sensor. Acquired values of electrical resistance will be used in further sensor circuit design for developing enuresis alarm system prototype. During the design of moisture sensor it is necessary to take into consideration position of electrodes depending on sensor’s configuration and characteristics of textile wettability and moisture management.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
