Abstract
PLANE stress yielding was induced in a duralumin plate by expanding a 12-segmented cylindrical collet. The tangential strains in the plate were measured at ten values of radius by means of single-filament Minalpha resistance wire strain gauges1. At all loads the measured strains in the unyielded portion of the plate fitted the theoretical solution exactly. The measured values in the yielded zone from the inner radius out to the yield boundary are shown for a typical loading in the figure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.