Abstract
A single main rotor helicopter's maximum forward speed is limited due to the compressibility effects on the advancing side and reverse flow and dynamic stall on the retreating side. Compound helicopters can address these issues with a slowed rotor and lift compounding. There is a scarcity of test data on compound helicopters, and the present research focuses on a systematic wind tunnel test on lift compounding. Slowing down the rotor increases the advance ratio and, hence, the reverse flow region, which does not produce much lift. The lift is augmented with a wing on the retreating side. A hingeless rotor hub helps to balance the rolling moment with lift offset. Wind tunnel tests were carried out on this configuration up to advance ratios of 0.7 at two different wing incidence angles. Rotor performance, controls, blade structural loads, and hub vibratory loads were measured and compared with in-house comprehensive analysis, UMARC. A comparison between different wing incidences at constant total lift provided many insights into the lift compounding. It increased the vehicle efficiency and reduced peak-to-peak lag bending moment and in-plane 4/rev hub vibratory loads. The only trade-off was steady rotor hub loads and rolling moment at the wing root carried by the fuselage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.