Abstract
AbstractA wideband printed dipole antenna with an integrated balun feed is given. To further get larger bandwidth capabilities of this antenna, a novel low‐cost smaller unit‐cell planar photonic bandgap (PBG) structure is etched onto the antenna surface, and a better dipole antenna is fabricated. Through optimizing the sizes of PBG structure, a 56.7% bandwidth is obtained where voltage standing wave ratio (VSWR) is less than 1.5 while a 36% bandwidth is obtained from initial structure. Agreement between calculations and measurements is very good. The result indicates that the novel design may obtain better wideband characteristic. © 2009 Wiley Periodicals, Inc. Microwave Opt Technol Lett 51: 1862–1865, 2009; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.24466
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
