Wide stopband compact microstrip lowpass filter using circular ring resonator and split ring resonators

Abstract

In this contribution, a microstrip low-pass filter with a wide stop-band using split ring resonators and a circular ring resonator is introduced. The passband ripple of proposed filter was measured 0.6 dB and minimum insertion loss of passband is about 0.75 dB at 0.5 GHz frequency. Moreover, the 1.0 dB cut off frequency of proposed filter is 1.45 GHz in measurement. Designing this type of low-pass filter requires a high impedance transmission-line. However, the microstrip line width cannot be taken less than 0.2 mm in practical implementation. This causes to a small mismatch in passband. Furthermore, these results show wide stop-band up to 9.0 GHz with more than 30 dB rejection. The dimensions of proposed compact filter are about 12.5×30 mm2 (excluding extra substrate width). The proposed filter is a microstrip filter and can compete with defected ground structure (DGS) or defected microstrip structures lowpass filters in miniaturizing and wide stopband. However, the DGS or DGS filters have some problems in manufacturing applications such as radiation fields from defected structures and requiring a specific box. In addition, a distributed equivalent circuit model based on geometrical filer parameters is introduced, and good agreement can be seen between EM simulation and distributed equivalent circuit model up to 6.0 GHz frequency. © 2011 Wiley Periodicals, Inc. Microwave Opt Technol Lett, 2011; View this article online at wileyonlinelibrary.com. DOI 10.1002/mop.26203